功能指示螺纹规是为了检验通端的最大材料限度及大小及止端的有效直径限度及大小。
Functional Indicating Thread Gage for inspecting the maximum-material GO functional limit and size and the NOT GO functional diameter limit and size.
旋开移相器上“西科”牌（？）装置一端的止动柄，即可转动止动柄而调整移相器。
Unscrew the locking handle found on the side of the phase shift 'Siko'unit; this enables the adjusting handle to be turned.
该设备系加工拖辊钢管两端止口的专用设备。
The equipment is special equipment for processing the rabbet of two ends of roller steel tube.
举例用的模具是由六个板组成的包含型芯、脱模衬套、齿轮和齿条以及止推片、轴瓦和方形密封圈载一起的冷端或“B”面。
For used molds are composed of six panels contains the core, Demoulding Bushing, gear and rack and the thrust piece, bearing and seal set with a square of the cold-side or "b" side.
方法：研究对象为在一单独治疗中心连续接受治疗的71位患者，腘绳肌腱近端止点撕脱的重建手术共计72例。
Methods: Seventy-two consecutive reconstructions in seventy-one patients with avulsion of the proximal hamstring origin were performed at a single center.
最大张紧轮振幅要与两端止点留有总行程10%的间隙余量。
Maximum tensioner amplitude leaves 10% of total travel clear to end stop in both directions.
移植肌腱会更短，功能也可能很好，但不可能位于最佳位置，与两端都位于止点中心的移植肌腱相比其不能防止胫骨前移。
This will be a shorter graft and may function reasonably well, but it may not be in the optimum location to prevent anterior translation compared to a graft centered in each footprint.
内筒的一端端口法兰内径处设有止口，用于与相邻筒节的对应端无止口法兰插接。
The inner diameter part of the flange at one port of one end of the inner cylinder is provided with a rabbet for splicing with a flange without a rabbet at a corresponding end of an adjacent elbow.
在逆止器的轴端孔内通过胀套和双平键与从 动轴连接；
The inner part of a shaft end hole of the backstop is connected with a driven shaft through an expansion bush and a double flat key;
一设于底 座上的导引单元，其设有一端具有止挡部的连通槽；
The guiding unit is provided with a communicated groove, and one end of the communicated groove is provided with a stopping part;
一设于底 座上的导引单元，其设有一端具有止挡部的连通槽；
The guiding unit is provided with a communicated groove, and one end of the communicated groove is provided with a stopping part;
应用推荐