筋板、凸台部分或薄壁处为防止冷隔，要提高铝液流动性。模温应相对提高。
The number of stiffened plate, convex platform part or to prevent cold-lap thin-walled place, must improve liquid aluminum liquidity. Mould temperature should be relative improve.
研究了一种利用蒸汽加热和冷却水冷却的变模温注塑工艺，制定了其工艺流程。
A variotherm injection molding technique with steam heating and coolant cooling was studied and its molding process was also designed.
采纳该技巧，模温能够得逞很高的温度，不存留熔接线问题，一起能够抬高产品外表硬度。
Adopted the technique, the temperature can get a high temperature, not left weld lines problems, we can drive up the surface hardness.
所得到的规律特征经实际工程的物模试验结果初步检验被证明可信，可作为电厂规划阶段深层排水方案温排水掺混稀释效果的估算分析方法加以采用。
The test results of the three dimensional flow condition and temperature field of deep water discharge can be used as scientific basis for planning of the similar outfall of power plant.
所得到的规律特征经实际工程的物模试验结果初步检验被证明可信，可作为电厂规划阶段深层排水方案温排水掺混稀释效果的估算分析方法加以采用。
The test results of the three dimensional flow condition and temperature field of deep water discharge can be used as scientific basis for planning of the similar outfall of power plant.
应用推荐