用填缝材料和喷雾泡沫器把你能找到的地下室里框架和砖石墙之间、贯穿环托梁或外墙的管道或电线周围的每条裂缝堵住。
Walk around the basement with caulk and cans of spray foam and plug every gap you can find between framing and masonry and around pipes or wires that penetrate the rim joist or exterior walls.
提出了哈尔滨市计生委办公楼结构改造所需的托换梁、托换柱、托换基础及相关连接构造的设计思路和方法。
Design thought and method of underpinning beam, column, foundation and relative joint construction in remodeling office building for Committee of Family Planning in Harbin are introduced.
介绍了上部结构中挑梁、托梁和斜柱的设计措施，深基础抗浮及底板外墙的处理方法。
The design of cantilever beam, joist and battered column in the upper structure was introduced. The anti-float of deep foundation problem and baseplate and concrete external wall were introduced.
对墙梁中托梁与墙中的“组合作用”进行了论述，并对国家现行规范中的计算方法提出探讨和建议，同时介绍了配筋混凝土空心砌块砌筑墙梁的初步试验结果。
This article deals with the composite action between bressummer and wall on it in wall beam, and puts forward discussion and proposal to the calculation method in current national code.
结果表明，SRC梁式托柱转换层结构的破坏机制优于rc梁式托柱转换层结构。
The results show that the failure mechanism of SRC girder transfer floor is better than that of RC girder transfer floor.
地铁上方铁路站房的主要荷载由转换托梁传递至桩基承载。
Primary load of the railway station was transmitted through conversion jacking joist to pile foundation.
通过预应力吊杆将楼面荷载转移到托梁上，安全地实现托梁拔柱的目的。
The purpose of transferring loads to the joist and wiping out the columns can be achieved safely.
通过实际工程应用，介绍分析了桩基托梁挡土墙的工程特性和设计方法以及适用条件。
Through practical project application, the engineering characteristics, design methods and application conditions of retaining wall on supported beams of pile foundation were introduced and analyzed.
结合工程实例，介绍了托梁拔柱改造中的悬挂技术。
This paper introduced suspension technique application in structural reforming with jack beam and removing columns.
针对大跨度预应力空间框架体系托梁受力复杂的特点，采用ANSYS软件进行了预应力梁板体系的空间有限元分析。
Based on the force behavior of joist of large-span prestressed space frame system, space finite element analysis of prestressed beam-slab system is carried out by using ANSYS software.
角撑板一种三角形的金属托架，用来加固地板托梁。
建议一般型钢混凝土托墙转换梁的允许跨高比在抗震设防时不大于8，对非抗震设计工程，跨高比不大于10；
It is suggested that the span-depth ratio of wall-bearing transfer beam should be less than 8 in seismic design, 10 in static design for SRC structure.
结合一综合大楼抽柱改造工程，介绍高层框架结构抽柱改造设计中有关概念设计和构造处理方法及托梁内力的电算分析。可供类似工程参考。
Based on an actual project of local demolition column, the concept design of multi-story building renovation, some detail construction and stress analysis of the trimmer are introduced.
研究了高托蜂窝式钢与混凝土组合梁的计算方法。
The calculating method of high haunched honeycomb steel concrete composite beam is presented.
应用预应力托梁转换技术满足了底部大空间的功能要求；
To meet the requirement of a wide space at the bottom story of the building, prestressed concrete joist transformation method is adopted.
通过实例计算分析，给出了带托柱式转换梁的框架-核心筒结构的转换层上、下层间侧移角比的取值范围建议。
Base on the calculation of an example, suggestions on range of sideway ratio of stories up and down in transfer story of frame-core tube structure with column supporting transfer beam is obtained.
介绍了缀板梁结构体系在框架结构抽柱托换以及加层改造中的应用，并分析了该方法的优点以及设计时注意的问题。
The paper presents the application of batten-plate beam structure in removal columns from frame structure and adding stories. It analyses the advantages and the notices in design.
介绍了缀板梁结构体系在框架结构抽柱托换以及加层改造中的应用，并分析了该方法的优点以及设计时注意的问题。
The paper presents the application of batten-plate beam structure in removal columns from frame structure and adding stories. It analyses the advantages and the notices in design.
应用推荐