您可以通过分析性能指标来解决诸如故障条件或不可接受的延迟等问题。
You can solve problems like failure conditions or unacceptable latency by analyzing performance metrics.
验证短路故障条件下，直流侧的负载转换器的动态稳定的特点。
Verify that the DC side load converter dynamic stability characteristics under short-circuit fault conditions.
本文给出了等效电路的ASVG使用对称分量的方法的系统的故障条件。
This paper gives the equivalent circuit of an ASVG for system faulty conditions using the symmetry component method.
检验plc系统设计的优劣，主要考察其是否满足：正常条件下可靠运行，故障条件下可靠保护。
Discriminating good from bad of PLC system design mainly depend on whether or not reliably tuning in normal condition and reliably protecting in trouble condition.
当发生故障转移时，所有应用程序被断开连接，客户机将一个通信错误条件返回给应用程序。
When a failover takes place, all applications are disconnected, and the client returns a communication error condition to the application.
有各种故障的大脑条件和残疾人，可以从中受益反馈治疗。
There is a variety of malfunctioning brain conditions and disabilities that can benefit from feedback treatment.
自动重合闸的成功率依线路结构、电压等级、气象条件、主要故障类型等变化而定。
Automatic reclosing the success rate structure on line, voltage levels, weather conditions, fault type, and other major changes may be.
基于GTO器件特性和故障状态下gto的过流工况，研究了GTO过流分级快速保护模式和实现方法以及保护的极限条件。
GTO over current rapid protection by gradation mode and limited protection conditions are studied based on the features of GTO and over current situation under fault state.
由于其工作条件恶劣，在使用中经常出现如上故障，严重影响了工程施工进度。
Because its working condition is bad, presents like on the breakdown frequently in the use, serious influence project construction progress.
当一个节点出现故障，其他节点检测的条件，并确定在数据库中，在进步在该故障节点的工作。
When a node fails, the other nodes detect the condition and identify the jobs in the database that were in progress within the failed node.
讨论了用于故障检测的特征结构配置方法，给出了特征结构设计的必要条件。
The eigenstructure assignment approach used for FDI has been discussed and its some feasible necessary conditions are given.
当卫星速率积分陀螺的配置冗余度不满足一致性检验条件时，不能单纯利用硬件冗余实现陀螺的故障定位。
When the redundancy of the gyroscopes can not meet the condition of consistency check, fault isolation of the gyroscopes can not be realized only by hardware redundancy.
条件允许实时读数的电压，电流，功率和故障，并实时改变设定点调整的权力，工艺要求。
Allows for real-time readings of voltage, current, power and fault conditions, and for real-time changes to the set point that adjusts power to process requirements.
实时数据库及时准确地从现场获取数据并有效地组织和管理，是水电厂设备故障诊断系统进行故障诊断的首要条件。
The primary condition for the fault diagnosis expert system of hydropower plants is the real time acquisition of data and efficient organization and management by the real time database.
将提取的暂态零序电流故障特征作为条件属性，信号增强倍数作为决策属性，构成一个决策系统。
The extracted fault characteristics of transient zero sequence current is looked as condition attributes and the multiple of signal enhancement is.
作为使用电脑的交换条件，他们俩的任务就是尽力找出并解决电脑故障(非常成功)。
In exchange for computer time, the boys' job was to try (quite successfully) to find bugs that would crash it.
通过仿真研究，确定了遗忘因子和初始条件的最佳值，实现了对过程故障诊断和预报。
The optimum values of oblivious genes and initial conditions can be confirmed, and also the process fault diagnosis can be realized through the simulation experiments.
本文介绍了一种最新型灭菌消毒柜的工作原理，工作条件，常见故障的维修及其改进措施。
This paper introduces the operating principles, working conditions, maintenance of common failures and improvements of the pulsating vacuum sterilizer with a motor-drive gate.
文章还指出了该可诊条件为合理使用定位故障的极值法提供了理论基础。
In addition, it is shown that this condition provides a theoretical basis for reasonably application of extreme methods to locate faults.
分析了TT和TN系统的接地故障保护和保护电器及其应用条件。
The earth fault protection and protective electric devices of TT and TN system and the application conditions were analyzed.
在实践中，不断变化的，如as间的交通需求的变化，链路故障和网络条件AS间路由发生变化动态。
In practice, changing network conditions such as inter-AS traffic demand variation, link failures and inter-AS routing changes occur dynamically.
故障诊断规则中判断条件的冗余、不完全和不确定性不利于实际应用。
In engineering applications, the incompleteness, imprecision, and redundancy in rules of fault diagnosis often lead to inconvenience.
在故障发生之前，保证滑模的存在，并以此为条件，通过检测残差信号是否在规定的滑动区内，从而判定是否发生故障。
Before the occurrence of fault, ensures the being of sliding mode, and takes this as condition, by detecting if the residual signal is in the regulation sliding area, estimates whether fault occur.
电机场路结构设计、控制器主回路换流模式设计、TMS320F 240最小系统设计、程序设计充分考虑了故障应急状态下系统正常运行必要条件。
Designs on motor field and structure, controller main circuit current commuting mode design, TMS320F240 least system and system program consider system normal operation under fault condition fully.
在假设因果图中的连接事件表示必然因果关系条件下，因果图可以转换为含有可能的因果关系的故障树。
Supposing that connecting event in causality express necessary causality, causality diagram can be converted into fault tree including possible causality.
介绍了故障码种类、基本设置条件及故障诊断程序。
Failure code kinds, basic setting conditions and failure diagnosis procedures are intro-duced.
简要分析了ADSS光缆电腐蚀故障的机理，提出了用静态和动态的概念来控制电腐蚀的条件及措施。
This paper concisely analyses the mechanism of electrical erosion of ADSS optical cable, puts forward the conditions and measures to control electrical erosion under both static and dynamic concepts.
近年来，由于法兰连接系统数目的增加、工况条件的复杂性，法兰连接系统的故障率也不断的上升。
In recent years, owing to the great number of flange joints and complexity of work condition, the failure rate of flanged joint system is increasing continuously.
在分析基于特征矩阵的主存故障检测方法原理的基础上，介绍了检测地址位及数据位故障时特征矩阵存在的条件及其确定方法。
Analyzing principle of fault detection in main memory based on characteristic matrix, the paper introduces the condition and methods of detecting address bit and data bit.
在分析基于特征矩阵的主存故障检测方法原理的基础上，介绍了检测地址位及数据位故障时特征矩阵存在的条件及其确定方法。
Analyzing principle of fault detection in main memory based on characteristic matrix, the paper introduces the condition and methods of detecting address bit and data bit.
应用推荐