以简支板为例,利用压电式传感器测量声辐射模态。
Based on the radiation modes, it is presented a piezoelectric sensor strategy with an example of simply supported rectangular panel.
本文主要以均布荷载作用下四边简支板为研究对象。
Slabs simply supported on four sides subjected to uniform loads are taken as the main subject in the analysis.
为减小应力集中,研究了机匣几何尺寸对支板应力的影响。
Furthermore, the effect of the gearbox geometry sizes on the stress of support was investigated to reduce the stress concentration.
翻转式工装,为了防止塔机片式标准节的扭转变形,在两支板之间应加上斜杆。
Two, rotary tooling, in order to prevent the torsional deformation of tower crane type standard section, between the two supporting plate should be added to the diagonal rod.
以简支板为例,通过压电作动器控制效果分析,揭示了压电作动器控制的内在规律;
Taking the simple-supported plate as an example, the control rules of the piezoelectric actuators are revealed by analyzing the control effects.
利用半高度后掠支板和氢气引导火焰相结合的点火方式,也可以实现煤油的可靠点火和稳定燃烧。
Combination use of the oblique Shockwave induced by the leading edge of the half height strut and hydrogen pilot flame can also ignite the kerosene and hold the combustion stably.
数值模拟的结果还表明:涡轮与支板的匹配不太理想,但气体通过支板后,仍能够接近轴向出气;
The results also show that the matching of turbine and strut is not perfect, but the flow direction is still close to axial through it.
为了验证本方法的正确性与有效性,将其用于单点激励固支板的全息实验中,取得了令人满意的结果。
In order to prove its validity, the method was used in the experiment to reconstruct the normal velocity of a clamped point-driven steel plate, and satisfactory results were obtained.
支板簇引射发动机是火箭基组合循环(RBCC)方案的一种基础动力,是为满足低费用高性能要求而提出的组合推进系统。
Strutjet is a new kind of Rocket Based Combined Cycle (RBCC), and is an integrated propulsion system that can satisfy low cost and high performance requirements.
支板驻点处由于水滴飞溅造成水滴收集率下降了11.8%,同时由于水滴在局部地方的反弹使得撞击极限下降了35.7%。
Also, due to the splash and rebounding influence the droplet collection efficiency and impingement limit decrease 11.8% and 35.7%, respectively.
发现板在两端简支、中点联结松动时,结构首先出现屈曲失稳,而不会发生颤振失稳。
For pined_pined, loosed midpoint support plate, it is found that the plate's buckling instability will happen first while the flutter instability will disappear.
发现板在两端简支、中点联结松动时,结构首先出现屈曲失稳,而不会发生颤振失稳。
For pined_pined, loosed midpoint support plate, it is found that the plates buckling instability will happen first while the flutter instability will disappear.
本文讨论在集中荷载和均布荷载联合作用下搁支矩形板的弯曲问题。
The problem of bending of rectangular plates with rest-on edges under the combined action of concentrated load with uniform distribution load has been discussed.
对于线性荷载作用下外简支环板,引入统一强度理论,进行了极限荷载分析。
For simply supported annular plate under linear load, the limit load analysis was investigated by applying unified strength theory.
用本文的解还可以推出多种荷载作用下简支圆板的塑性极限荷载。
The plastic limit loads of simply supported circular plates under various loads can be obtained based on the present solution.
本文将奇异函数法应用于结构的塑性极限分析,简化计算某些固支环形板的极限荷载。
In this paper, the method of singularity function is applied to the structural plastic limit analysis, and simplified the calculation of limit loads of some annular plates of fixed supports.
为了提高可靠性,在软弱地基上建造油罐时,可采用桩支圆板基础。
When the tank is built in soft soil ground, pile-supported round slab foundation could be used to improve the reliability of the tank.
在均布荷载作用下,对钢筋混凝土周边固支等腰梯形板的计算通常都是将其简化成周边固支当量矩形板进行计算。
Calculation method of reinforced concrete isosceles trapezoid slab is experiential arithmetic which simplified isosceles trapezoid into rectangle slab to calculate.
以简支矩形板为例,通过声辐射模态研究结构声辐射问题。
With an example of simply supported rectangular panel, this paper presents a new method for analysis of structure borne sound by radiation mode method.
本文讨论了两对边简支单向线性变厚度矩形板的弯曲问题。
The bending problems of rectangular plates of unidirectional linear variable thickness with two opposite edges simply supported are discussed.
由动力学的一般解,导出了扇形板和扇形环板在广义弹性简支和广义刚性滑动边界条件下自由振动的频率方程和振型;
From these dynamic solutions, frequency and mode shapes of sectorial plate and sectorial annular plate under boundary conditions of GSS and GRS are derived.
对于在受压边简支,纵向加筋的受压加筋板,本文给出了求解临界载荷的特征方程的精确形式。
The exact characteristic equations for solving the critical bucking load of stiffened plate compressed and simply supported in direction of the stiffeners are derived in this paper.
给出四边简支任意厚宽比的矩形板在任意荷载作用下的控制方程及其精确解。
The governing equations as well as their exact solutions are constructed for a simply supported rectangular orthotropic plate with arbitrary thickness subjected to arbitrary Loads.
当板的四边为简支时可用双正弦级数解法来求得各阶固有频率。
When a plate is simply supported at four edges, it can be solved by double sine sery method to get each proper frequency.
本文研究了理想刚塑性简支圆板在均布阶跃载荷作用下的塑性动力响应。
Dynamic plastic response of a simply supported circular plate made of a rigid - perfectly plastic material under uniformly step Loading is investigated in this paper.
文中求得了周边简支多边形板的弹性改进理论解,数值结果与三维弹性理论精确解的结果非常接近。
The solution of the refined theory for simply supported polygonal plates has been obtained; and its numerical result is very close to the exact solution of the three-dimensional theory of elasticity.
本文的主要特点为有料向板条的选取及荷载传递、简支不规则板的负弯矩裂缝线以及点支承板条和板的剪切劈裂问题。
The distinguishing features of the paper are selection of oblique strip and loading transmission, negative yielding line in irregular slab with simple supports, point support and shear split of slab.
本文的主要特点为有料向板条的选取及荷载传递、简支不规则板的负弯矩裂缝线以及点支承板条和板的剪切劈裂问题。
The distinguishing features of the paper are selection of oblique strip and loading transmission, negative yielding line in irregular slab with simple supports, point support and shear split of slab.
应用推荐