梁，挠度，弯曲，应力计算器。
上模夹具配有挠度补偿装置。
Upper punch clamping fitted with deflection compensation device.
转动的泵轴会弯曲变形，产生最大挠度。
Rotational deformation of the shaft will produce maximum deflection.
验算钢骨混凝土转换梁的挠度和裂缝宽度。
The deflection and the crack width of the SRC transfer girder are calculated.
测试涂挂不同涂料的模样在变载荷下的挠度值。
The deformations (deflection value) of the patterns with different coatings were measured under different loads.
计算得到的荷载—挠度曲线基本吻合试验曲线。
The computational load versus deflection curves agree with the test results.
当薄膜带有刚性中心时，能使薄膜的中心挠度减小。
For the annular membranes, the concentric rigid inclusion make the maximal deflection become smaller than circular membranes.
提出了一种大型桥梁结构截面挠度测量的光学方法。
An optics method for measurement of beam section deflection of major bridge structure is put forward.
剪力连接的非线性将导致钢与混凝土组合梁挠度的显著增加。
Shear connection nonlinearity always results in a significant increase in deflection of steel-concrete composite beams.
求解该方程时，将纵向位移分量和曲率的改变量用挠度表示。
The longitudinal displacement and curvature variation are both described by deflection as solving the equations.
静载试验的内容是测定加固前后梁板结构的混凝土应力和挠度。
These experiments mainly aim at determining the deflection and stress of beam slab structure before and after reinforcement.
下水前测量船体主尺度：总长、两柱间长、型宽、型深、基线挠度。
Measuring hull's main dimensions: length overall(LOA. ), length between perpendiculars(LPP. ), breath molded(B. ), depth molded(D. ) and deflection before launching.
本又讨论了映象法，并利用映象法求解了板在集中载荷作用下的挠度。
This paper discussing the mirror photo method and finding the solution deflexion of the plates through mirrir photo method under the concentrate force.
给出的挠度函数满足薄板的基本微分方程、全部边界条件以及角点条件。
The deflection functions given satisfy the differential equation of thin plate, all the boundary conditions as well as the conditions at free corner points.
快速铁路是束热处理铝合金型材中空截面，给高强度下的扭转和挠度应力。
The Speedy Rail beam is a heat-treated aluminium alloy profile with hollow cross-sections that give it high strength under torsion and deflection stresses.
其次，论述了关于拱桥稳定性的挠度问题和极限承载力的几何非线性理论。
Secondly, it discussed the deflection in stability of arch bridge and geometry nonlinear theory on ultimate load-carrying ability.
在其他参数相同的情况下，侧向挠度随着偏心距或构件长度的增大而增大；
Under the condition that other factors are the same, lateral deflection increases as eccentricity or member height increases.
垂直杆件则借悬臂作用产生和拱挠度相等的悬臂挠度，来承担足够的荷载。
Vertical elements carry sufficient load through cantilever action to produce cantilever deflections equal to arch deflections.
还表明，在一定温度下，载荷-挠度曲线越陡，合金的抗弯强度一般也越高。
It was also found that at a fixed temperature the transverse-rupture strength of the alloy generally increased with the steepness of load-deflection curves.
对各向同性、均布载荷及简支点等间距分布的简化情况计算了圆板的最大挠度。
The maximum deflection is calculated in case of isotropic, uniformly loaded circular plate and equidistant bearing points.
由于CFR P板的弹性模量比钢筋的弹性模量小，加固梁破坏时的挠度仍较大。
Because elastic modulus of CFRP plate are weaker than elastic modulus of steel bar, while strengthening beam is destroyed, the deflection is still strong.
改值为定挠度下的强度值，不是最大的强度值，根据1998年的最新测试标准。
The values are strength parameters under fixed flexure rather than Max. Strength according to the latest testing standard of 1998.
改值为定挠度下的强度值，不是最大的强度值，根据1998年的最新测试标准。
The values are strength parameters under fixed flexure rather than max. Strength according to the latest testing standard of1998.
得到了按矩形四边固支边界考虑时，膜材大挠度非线性振动频率的幂级数表达式。
Derived and solved the governing vibration equations of orthotropic membrane, and obtained the power series formula of nonlinear vibration frequency of rectangular membrane with four edges fixed.
对不同系列的护栏网，必须要按受力状况最晦气准则进行强度、挠度的校核或实验。
The different series of fence, must carry on the strength and deflection according to the stress condition of the experimental verification or unlucky criterion.
钢结构的异常变形或局部损坏可通过荷载—挠度曲线以及纵轴线的挠度曲线反映出来。
The abnormal deformation or local damage of steel structure can be reflected by the load-deflection curve and the deflection curve of the longitudinal axis.
这允许设置为自由对齐辊在外圈滚道，从而为失调和轴挠度进行补偿(见图1.43)。
This permits the roller set to align freely in the outer-ring raceway, thus compensating for misalignments and shaft deflections (see Figure 1.43).
对正交异性扁薄圆柱壳在均布载荷及集中载荷作用下的大挠度问题进行了理论计算和测量。
Orthotropic shallow cylindrical shells with large deflection are theoretically calculated and experimentally analyzed under the cations of uniform and concentrated loads.
对正交异性扁薄圆柱壳在均布载荷及集中载荷作用下的大挠度问题进行了理论计算和测量。
Orthotropic shallow cylindrical shells with large deflection are theoretically calculated and experimentally analyzed under the cations of uniform and concentrated loads.
应用推荐