拉伸强度和硬度随外壳厚度比增加而增加。
Tensile strength and stiffness increase as skin thickness ratio increases.
迷走神经与脊神经的拉伸强度几乎完全相同。
The tensile strength of vagus and spinal nerves is very alike.
这个关系的重要性在于提供高的屈服和拉伸强度。
The significance of this relationship is providing for high yield and tensile strengths.
偏轴拉伸强度的理论计算结果与试验结果很一致。
The theoretical predictions of off-axis tensile strength agree well with experimental results.
对螺栓拉伸强度计算的载荷系数法作了进一步改进。
The load coefficient method of bolt on tensile strength calculation was improved.
方法：测定材料的硬度、压缩强度、径向拉伸强度。
Methods: The surface hardness, compress strength, diametral tensile strength of composites were measured.
提高电线电缆用三元乙丙橡胶材料的拉伸强度和伸长率。
Improved tensile strength and elongation of ethylene propylene diene monomer compounds used for wire and cable.
此时，复合材料的拉伸强度和维卡软化温度也有所升高。
The Vicat temperature and tensile strength of the blends were also increased.
建立了预测单向复合材料纵向拉伸强度的随机核理论与模型。
The random crack core theory and model for predicting the longitudinal tensile strengths of unidirectional composites is built.
结果表明，大理岩的动态拉伸强度随着应变率的提高而增加。
The results show that the dynamic tensile strength of marble is heightened with increasing strain rate.
织物输送带是由不同的层，其中拉伸强度是由化纤织物铺层提供。
Fabric conveyor belts are made of various layers, where the tensile strength is provided by synthetic fabric plies.
铜的应用是有限的，由于其拉伸强度低，耐磨性差，共同氨基酸。
Copper applications are limited due to its low tensile strength, poor resistance to abrasion and common acids.
结果表明：该复合材料有优良的拉伸强度、抗水性和熔融流动性；
The modification results in the excellent mechanical properties, water resistance and melting fluidity of this composite material.
随着时效温度的升高，合金的拉伸强度降低，而延伸率则不断增加。
With the increase of aging temperature, the tensile strength decreases. With the increase of elongation.
邵氏硬度、拉伸强度和伸长率是考核橡胶材质力学性能的重要指标。
Shall hardness, tensile strength and its elongation rate are principal data to indicate the quality of rubber materials.
随着这些性能的降低，拉伸强度也降低而钢的延展性和韧性则会提高。
As these properties are reduced there is also a decrease in tensile strength and an increase in the ductility and toughness of the steel.
加筋网片的拉伸强度高于普通网片，加筋丝直径一般不小于边丝直径。
The tensile strength of the mesh sheet is higher than that of the common mesh, and the diameter of the wire is not smaller than the diameter of the side wire.
这套模具在测量火焰喷涂聚合物涂层自拉伸强度方面实用、快速、简单。
The mould is useful, rapid and simple in measuring the self tensile strength of flame spraying polymer coatings.
脉冲参数对显微硬度和拉伸强度的影响符合相似的规律，但也有所不同；
The effect of pulse parameters on micro-hardness and stretch strength correspond to similar law, but different slightly.
并且随着MTES量的增加，材料的拉伸强度增强而断裂伸长率逐渐降低。
Increase in the amount of MTES increases the tensile strength and decreases the ratio of elongation for breaking of the materials.
研究结果表明，复合材料的冲击强度、拉伸强度随玻纤用量的增加而提高。
The result showed the impact strength and tensile strength of the composite increased with the increase of the content of the glass fiber.
结果表明，采用复合增塑剂，大豆蛋白塑料的拉伸强度，杨氏模量均增加。
The results showed that the tensile strength, Young's modulus of soy protein plastics with complex plasticizers increased.
另外，样品制备时，随着相对湿度的增加，测得的碳纤维拉伸强度逐渐降低。
In addition, CF tensile strength decreased with relative humidity during preparation of specimens.
加筋重型六角网的拉伸强度高于普通网片，加筋丝直径一般不小于边丝直径。
The tensile strength of the reinforced heavy six Angle net is higher than that of the common mesh, and the diameter of the wire is not smaller than the diameter of the side wire.
离聚体的拉伸强度、搭接剪切强度和乳化性能均随顺酐化程度的提高而改善。
Tensile strength and lap shear strength increased with increasing of grafting degree due to great improvement of polarity.
结果表明，随着碳纤维布含量的增加，复合材料的拉伸强度、冲击强度提高；
The results show that the tensile strength and impact strength of the composite increase with the increase of carbon fiber cloth content.
随着超细硅灰石用量的增大，体系的拉伸强度、耐热性能和加工性能都稍有下降。
The tensile strength, heat resistance and processability of the system decrease slightly with the increase of superfine wollastonite amount.
结果表明，复合材料的拉伸强度、曲强度和弯曲模量随着云母用量的增加而提高。
The results showed that the tensile strength, flexural strength and flexural modulus increased obviously with increase of amount of Mica.
目的：比较整体固化与分层固化光固化复合树脂的压缩强度、拉伸强度及弯曲强度。
AIM: To compare the compressive strength, tensile strength and flexural strength of bulkily filled and incrementally filled visible light-cured composite resin.
不同的去溶剂温度和热亚胺化的升温方式对聚酰亚胺薄膜拉伸强度也有较大的影响。
The tensile strength of polyimide film will also be affected by the temperature of de-solvent and the heating way of thermal imidization.
应用推荐