亚裔美国人寿命折减最少,分别是男性4.1年,女性3.6年。
Asian Americans had their lives shortened the least, by 4.1 years for men and 3.6 years for women.
目前人们对大直径扩底桩端阻力折减问题有不同的看法。
The current viewpoints on the modifying coefficient problem of end-bearing resistance of large diameter belled piles are different.
对塔身的稳定,用折减系数法及迭代法导出了临界力表达式。
Critical force expressions for tower stability are derived using reduced coefficient method and iteration.
因此,弹塑性模型更适合于强度折减有限元法分析土坡稳定性。
So the elastic - plasticity model is more compatible to slope stability analysis by FEM with shear strength reduction.
试验结果表明:自攻自钻螺钉群连接件具有“群体折减效应”。
The destructive mechanism of self-drilling screws connection is recorded in the test.
强度折减有限元方法分析边坡的关键问题是临界破坏状态的确定。
The key of strength reduction method is how to define the critical failure state of slope.
采用强度折减有限元法分析一无土钉支护三维素土坡的整体稳定性。
An elastoplastic strength reduction FEM is used to analyze the stability of the unsupported excavation slope.
最后对主动土压力折减系数做了分析,进一步验证了公式的合理性。
Finally the reduced coefficient of active earth pressure has been analyzed in this paper, which further confirmed the formula rationality.
用强度折减有限元方法对开挖边坡的稳定性进行了较为全面的研究。
An elastoplastic shear strength reduction FEM is used to analyze the stability of excavation slope.
抗震规范在考虑结构相互作用时规定,剪力和层间位移可以进行折减。
The interaction of some buildings is prescribed in code for seismic resistance by decreasing the shear force and the story displacement, while the decreasing method is based on the elastic conditions.
根据试验结果,分析了应力折减系数大小和填土中的竖向应力分布特点。
The stress reduction ratio and the vertical stress distribution in the embankment fill were studied in detail.
有限元强度折减系数法在边坡稳定分析中的应用正逐渐受到人们的重视。
The shear strength reduction method (SRM) with FEM on analysis of slope stability is increasingly applied.
根据考虑变形的朗肯土压力模型,对被动土压力折减系数进行了理论探讨。
According to Rankine earth pressure model considering deformation, the reduced coefficient of a passive earth pressure is explored theoretically.
并以简化的荷载效应组合概率模型,计算出多台吊车组合时的荷载折减系数。
The load reduction factors of the multiple cranes are estimated with simplified probabilistic model of the load effect combination.
同时给出了当构件跨度不满足最小跨度要求时受拉钢筋强度折减的计算方法。
Presents the strength reduction calculating method of the tension bar when the minimum span length is not sufficed.
根据试验数据提出了存在斜裂缝钢筋混凝土梁的抗剪强度折减系数的计算公式。
The formula of reduced shear strength coefficient of RC beams with inclined cracks is put forward to according to the test data.
退化型悬索单元能在对普通梁单元进行刚度折减的基础上给出良好的分析结果。
The degenerated cable element is derived by the reduction of stiffness of the conventional beam element and the results are acceptable.
聚乙烯燃气管道的压力折减系数是重要的设计参数,取决于管道埋设周边地温。
The pressure reduction coefficient of PE gas pipeline is an important design parameter, and depends on the soil temperature around the buried pipeline.
利用有限元强度折减系数法求得的滑坡安全稳定性系数进行北门沟滑坡稳定性评价。
The stability assessment of Beimengou slope is achieved on the basis of the safety factor calculated by the strength reduction FEM.
利用jc法对两种承载力折减系数下的FRP加固轴心受压构件进行了可靠度计算。
For two different capacity reduction factors, calculate the reliability of concentrically compressed members strengthened with FRP using the JC method.
将岩体中的结构面视为一种初始损伤,岩体变形参数通过岩块参数的损伤折减来确定。
Considering the structural planes as initial damage, damage mechanics is applied to analyze the deformation parameters of rock masses by discounting mechanical parameters of rock.
因此,采用强度折减法对非均质边坡进行稳定性分析时,建议对整个模型都进行折减。
It is advised that the global strength method should be better than the local strength method when the inhomogeneous slope is analyzed.
并采用强度折减有限元法分析了海堤在自重、波浪力和渗透力耦合作用下的整体稳定性。
The overall stability under the coupling force of dead-weight, wave force and seepage force is analyzed by the shear strength reduction with FEM.
然后引入强度折减技术,结合数值流形方法提出了公路路基岩溶顶板稳定性的评价方法。
Then, the evaluating method of the stability of karst roof in roadbed had been established by combining with strength reduction technique and numerical manifold method.
因此通过对该试验的数据进行参数分析,提出了一个变形计算公式中较合理的折减系数。
Based on the parameter analysis, a more reasonable reduction factor is presented in the deformation formula.
基于对抗力折减系数的参数研究结果,无论钢筋的应变水平如何,建议取固定值0.90。
The resistance reduction factor is suggested as a fixed value of 0.90, regardless of the strain level of the tensile steel reinforcement.
还评述了大跨径桥梁的车道荷载拟定原则,探讨了大跨径桥梁的车道荷载和多车道横向折减。
Byintroducing the principles of initiating a lane loading in long span Bridges with comments, the appropriate lane loading as well as multi-lane transverse reduction factors are suggested.
采用边坡某一幅值的等效塑性剪应变区,从坡脚到坡顶贯通前的折减系数作为边坡安全系数。
The strength reduction coefficient before a well-defined equivalent plastic shear strain (EPSS) running through from the bottom to the top of a slope is considered as its safety factor.
采用边坡某一幅值的等效塑性剪应变区,从坡脚到坡顶贯通前的折减系数作为边坡安全系数。
The strength reduction coefficient before a well-defined equivalent plastic shear strain (EPSS) running through from the bottom to the top of a slope is considered as its safety factor.
应用推荐