明确正弯矩区组合扁梁的受力性能是进行结构分析的基础。
Clearly understanding the capacity of composite slim beam in the sagging moment region is the basis of structural analysis.
本文讨论了钢筋混凝土构件在轴向力、弯矩和剪力共同作用下的抗剪强度。
This paper discusses the shear strength of reinforced concrete members subjected to combined axial forces, moment and shear.
国家游泳中心“水立方”结构中采用了连接方钢管、且承受轴力与弯矩共同作用的焊接空心球节点。
Welded hollow spherical joints connected with square hollow sections are adopted in the National Swimming Center "Water Cube", which are subjected to combined axial forces and bending moments.
摩托车液压盘式制动器径向尺寸较小，制动时沿制动盘的轴向施力，制动轴不受弯矩，制动性能稳定，应用较广。
Motorcycle disk brake is widely used because of its small radial dimensions, axial application of force along the disk when braking, no bending moment on brake shaft and braking stability.
在风荷载或地震荷载等水平荷载及竖向荷载共同作用下，板柱节点除了要传递垂直剪力外，还必须传递较大的不平衡弯矩。
In addition to vertical shear force, slab-column connections also have to transfer unbalanced moment due to combined vertical and lateral forces as a result of wind effect or earthquake excitations.
在弯矩分配中有很多的简化法。
极限扭矩与极限弯矩之间的相关关系。
The curve of interaction between ultimate moment and ultimate torque .
随着弯矩的增加股骨的应力有明显增加。
With the increase of bending moment, the stress of femur increases evidently.
如果附加弯矩产生的应力过大，螺栓便会断裂。
If the stress produced by the additional bending moment is too large, the bolt will break.
当法兰承受轴向拉力或弯矩时，应另行考虑其作用。
When flange is withstanding axial tension or crook moment, its purpose should be considered otherwise.
一般由升力所产生的弯矩对最终的弯矩只有很小的影响。
Bending moments produced by lift generally have only a small effect on the resultant bending moment.
腰椎生物力学的参数显示腰椎在发力动作中主要受弯矩和压力作用。
Biomechanical parameters of lumbar vertebra shows that the main loads of lumbar vertebra are pressure and bending moment.
增大支撑预加轴力可以有效的控制连续墙的变形，减小墙身负弯矩。
Increasing brace pre axial force can effectively control the wall displacement and reduce negative bending moment.
重点讨论了预应力连续梁中次弯矩和轴向预压力对弯矩调幅的影响。
The emphasis of the paper is placed on the influence of the secondary moment and the axial prestress on the moment redistribution.
将弯矩与轴力分开处理，然后将两者算出的应力叠加，得到综合应力。
The combined stress induced by moment and thrust can be added to get the combined stress effect.
剪力键主要承受弯矩和剪力，从支座到跨中，其弯矩和剪力逐渐减小。
The shear keys bear moment and shear and decrease from support to mid-span.
本文主要讨论力法计算中，各单位弯矩图可采用不同的基本结构的方法。
The method of using various released structures in the moment diagram of each unit in force method is discussed in this paper.
滑移增大结构曲率，降低构件刚度，增加附加弯矩，从而引起挠度增大。
The slip displacement increases the curvature, reduces the stiffness, increases the additional moment and consequently leads the increase of deflection.
这使螺栓在承受预紧力和工作载荷作用的同时，还要承受附加弯矩的作用。
This makes the bolt bear the preload and work load, but also bear the role of additional bending moment.
在用三弯矩方程解连续梁时，通常是对每个中间支座列出一个三弯矩方程。
When solving continuous beams by means of a three-moment equation, we write usually an equation of three moments for every intermediate support.
经简化后的开裂弯矩计算公式形式比较简单，计算结果与试验结果基本吻合。
The simplified calculation formula form of cracking moment is simple and the analytical results agree well with that of experiments.
反挠结构是一种新近提出的钢结构，它特别适用于主要承受弯矩荷载的结构。
The counter deflection structure is a new-proposed steel structure especially suitable for that mainly subjected to bending load.
对框架结构梁端弯矩应如何调幅问题做一探讨，对以往设计提出修正性的建议。
The paper discusses how to regulate the amplitude of bending moment within beam end for frame structure, and presents revisal Suggestions for previous designs.
应力平衡法以主梁弯矩合理为目标，通过主梁上下缘应力平衡来求得拉索索力。
The stress balance method aims at the girders' reasonable moment, getting the cable forces by balancing the stress in girder's upper and lower margin.
通过试验得出了钢梁的温度场分布、变形、轴向约束力和连接弯矩的变化规律。
From the test results, the regularities of temperature field, deflection, axial restraining force and connection moment are presented.
以连续梁模型作为曲轴受力分析的基础，分析了平衡重对曲轴所受弯矩的影响。
On the basis of continuous beam model the effect of fitting counterweights on the bending moment of crankshaft was analysed.
研究了外部U形粘贴碳纤维布加固钢筋混凝土梁负弯矩区段斜截面的受力特性。
This paper makes experimental study of stress character of reinforced concrete beam's oblique section in negative area strengthened with U-jackets carbon fiber reinforced polymer (CFRP).
连续组合梁在内支座处的负弯矩区段会出现混凝土板受拉、钢梁受压的不利局面。
Adverse condition of concrete in tension and steel joist in compression occurs at inner support regions of continuous composite steel concrete beams.
连续组合梁在内支座处的负弯矩区段会出现混凝土板受拉、钢梁受压的不利局面。
Adverse condition of concrete in tension and steel joist in compression occurs at inner support regions of continuous composite steel concrete beams.
应用推荐