利用计算机建模与仿真的方法,对电动节流阀控制系统正常和异常时电机电压和阀门转角的波动进行了分析。
By means of computered modeling and simulating, the variation of the discrepancy of motor voltage and valve Angle are analyzed when system working at proper or fault condition.
在讨论控制系统涉及领域广的基础上,提出利用20-SIM软件进行建模与仿真。
The main functions, programming interfaces and simulation methods of 20-SIM software which is developed by control engineering department of Twente University(the Netherlands) are briefly introduced.
本文主要研究和设计了冷轧带钢电解清洗线上刷辊马达电流负荷控制的模糊控制系统并做了建模与仿真。
This paper mainly researches and designs fuzzy control system used in brush roll motor current load control and establishes its object model successfully used in simulation in the lab.
现有微电网研究集中在并网控制、潮流计算、建模与仿真、拓扑结构与控制等方面,实际投入运营的系统不多。
Main research subjects are focused on grid-connected control, power flow calculation, modeling and simulation, topology and control and so on, real operation systems are very few.
使用当前先进的MATLAB语言及SIMULINK环境,对农村中大量使用的拖动风机与水泵类负载运行的笼型感应电动机(CIM)矢量控制系统,进行了建模和仿真。
This paper shows that it is possible to model and simul ate any CIM vector controlled system used for agricultural pump or fan by means of advanced MATLAB and SIMULINK platform.
使用当前先进的MATLAB语言及SIMULINK环境,对农村中大量使用的拖动风机与水泵类负载运行的笼型感应电动机(CIM)矢量控制系统,进行了建模和仿真。
This paper shows that it is possible to model and simul ate any CIM vector controlled system used for agricultural pump or fan by means of advanced MATLAB and SIMULINK platform.
应用推荐