第一只LED的电路导通时的电池电压量太低。
The first simply circuit turns on an LED when the battery voltage gets too low.
设计了能保证减振板焊接过程稳定的导通旁路。
Electric accessorial structure is designed to ensure steady welding of vibration-damping sheets.
接地装置引下线的导通检测工作应每年进行一次。
Original: grounding device Yin Xiaxian of conduction testing should be conducted once a year.
网印：在板两面完全涂覆阻焊油墨，包括导通孔、焊盘。
Screen Print: Solder mask coating will cover completely the panel holes, pads and traces, on both sides.
此研究对高速数字设计者深入理解导通孔设计有一定意义。
The study allows high-speed digital designers to have a more indepth assessment of via design.
测试功能包括导通测试、断点检测与定位以及短路点的检测。
Its functions include conducting state test, measurement and location of the broken point, and short-circuit point measurement.
所述第一和第二开关的每一个都交替地进行导通操作和截止操作。
Each of the first and second switches alternatively performs a turn-on operation and a turn-off operation.
电路导通器是一种简单的量测仪表，它只能检查电路的通断状况。
The circuit tester is a simple test instrument which only shows whether the circuit is intact or whether there is a break.
通常采用控制晶闸管的导通角，而得到输出连续可调的直流电压。
Usually, the output voltage for continuous adjustment was obtained by controling turn-on angle of thyristor.
接地装置引下线的导通检测工作应每年进行一次并进行记录、分析。
Yin Xiaxian of conduction testing should be conducted once a year, and recorded and analyzed.
无论导通时刻是否一致，同臂号晶闸管的关断截止时刻总是相同的。
Whether the turn-on time of the same arm thyristors was uniform or not, the turn-off time was always identical.
接地装置引下线的导通检测工作应每年进行一次并进行记录、分析。
Grounding device Yin Xiaxian of conduction testing should be conducted once a year, and recorded and analyzed.
这种方案是通过测量导通相测试线圈的电感来获得实时转子位置的。
The scheme is applied to get the real-time rotor-position by measuring the inductance of the test winding of the conducting phase.
是否通过切片检验pth与小导通孔孔壁状况，并有相应的改善对策跟踪？
Is PTH and small via hole wall quality checked by cross-section and followed by a closed loop corrective action?
该电阻器还应当有足够高的额定功率，以满足齐纳管导通时的功率耗散要求。
The resistor must also be rated high enough to meet the power dissipation requirements while the zeners are conducting.
通过反馈电压控制可控硅的导通角来实现对工业大功率整流电路的恒流控制。
It's possible to control the industry powerful constant circuit of commutating circuit through controlling the guide circuit Angle of controllable silicon by feedback pressure.
本文介绍了在开关磁阻电动机调速系统中对各相绕阻的导通角的设计原理和方法。
This paper introduces design theory and method of conduction Angle of every winding in switching reluctance motor's regulating system.
启动电流随导通角的增大而减小，控制系统应以大导通角启动，可防止撞缸现象。
So the control system should be started under large Angle of flow in order to avoiding striking the cylinder.
本文提出了工作在连续导通情况下DC—DC开关转换器的快速建模的统一方法。
A unified method for fast modelling of dc-dc switching converters in continuous conduction mode (CCM) is proposed in this paper.
漏源极电压（图28）在反射过程结束后并减小到100伏特时场效应晶体管导通。
The drain-source voltage (Fig. 28) starts oscillating at the end of the flyback phase and reaching the minimum of 100V when the MOSFET turns on.
针对加速工况，分别对IGBT1导通和截止状态建立了电机驱动系统瞬态数学模型。
Considering various states of IGBT1, transient mathematical models of the electric motor driving system during the acceleration process is built up.
介绍了可控电抗器晶闸管导通角的微机控制及应注意的问题，并给出了试验结果和波形。
Microcomputer control of thyristor conduction Angle in controllable reactor and the matter to be noted are introduced. Experimental results and oscillogram are given.
该开关可以连接在可充电电池和一个直流电源之间并且能够在导通和非导通状态之间转换。
The switch may be coupled between the rechargeable battery and a DC power source and capable of moving between conducting and non-conducting states.
在车站信号工程的施工中，开通前都要进行车站联锁导通试验，以验证信号设备联锁的正确性。
In construction of signalling system in station, the station conduction test needs to be done to verify the correction of signalling equipment interlocking.
还定量讨论了支配半个衰减正弦波残存波的等效电感、等效电阻和高压硅堆导通时间抖动的影响。
In addition, the influence of the equivalent inductance, the equivalent resistance and time-jitters of the diode on the residual waveform of a half sinewave with attenuation is discussed.
设计的模糊控制器以电机的转速偏差及转速偏差率为输入，输出量用于控制斩波调速时的导通角。
The fuzzy logic controller designed in this study determines the required angular used in the DC chopper control based on motor speed error and its change.
结合某样机系统提出了一种用不含CPU的低成本硬件控制器实现的固定导通角p WM控制策略。
Based on a certain prototype, the fixed conducting Angle PWM control strategy implemented by the low cost hardware controller without CPU is proposed.
主要介绍导通孔填充制程的另一种替代方法，即用封闭头网板印刷的细节，也称封闭式整体印刷方法。
This article mainly introduces an alternative to the squeegee for Via-filling processes which is called enclose-head screen-printing or Mass Imaging.
与不可导通电边界条件相比，导通裂纹表面的电位移强度因子比不可导通裂纹的电位移强度因子要小许多。
It is found that the electric displacement intensity factors for the permeable crack surface conditions are much smaller than the results for the impermeable crack surface conditions.
与不可导通电边界条件相比，导通裂纹表面的电位移强度因子比不可导通裂纹的电位移强度因子要小许多。
It is found that the electric displacement intensity factors for the permeable crack surface conditions are much smaller than the results for the impermeable crack surface conditions.
应用推荐