天线的实测方向图完全符合赋形波束的要求,表明该设计方法是可行的。
The measured radiation patterns satisfy the requirements of beam shaping well, which demonstrates the effectiveness of this appr…
用本法获得的某雷达天线方向图的结果与基于太阳噪声的实测结果基本一致。
An actual radar antenna pattern plotted by using the method shows approximately no difference from the practically measured results based on solar noise.
文中叙述了该系统的硬件设计及软件流程图,并给出了实测结果。
This paper also describes the hardware design and the software flow chart and the on-the-spot survey result is given.
变方向折线剖面是在地形、地质情况较为复杂地区普遍采用的实测地质剖面方法。其地质剖面图目前一般用几何作图方法以投影法成图。
The construction of the direction changing section is a method of measuring a geological section applied commonly in areas with complex topographic and geological condition.
通过野外实测剖面,地质填图等工作,证实了铁洞沟组与熊耳群之间是既整合又有局部不整合的接触关系。
It has been proved by making geological-section and map that contact between the Tiedonggou Formation and the Xionger Group is concordant as well as discordant locally.
对比表明,计算结果和实测结果基本相符,这说明用键合图理论建立火炮浮动自动机的动力学模型是可行的。
It shows, it is practicable to set up a systematic dynamic model of floating automatic gun with the bond graph theory.
传统的实测资料分析法存在分析效果差、效率低的缺陷,不能充分利用河道测图提取河床演变信息。
However, the traditional analysis of data is inefficient which can not pick up the fluvial process information fully from the channel data.
传统的库容计算方法是在已有的地形图上采用求积仪法进行,当精度要求较高时,需到现场实测更大比例尺的地形图。
In traditional reservoir capacity calculation, a planimeter is used to obtain a reservoir capacity from topographic maps and large scale topographic maps are needed if high accuracy is required.
根据实测的单元天线方向图,利用几何绕射理论,给出了金属截锥柱侧天线三维辐射场的一种有效的数值分析方法。
On the basis of the experimental element pattern and GTD, an efficient numerical method for analyzing 3-D radiation field of antennas on the truncated cone-cylinder is presented.
根据实测的单元天线方向图,利用几何绕射理论,给出了金属截锥柱侧天线三维辐射场的一种有效的数值分析方法。
On the basis of the experimental element pattern and GTD, an efficient numerical method for analyzing 3-D radiation field of antennas on the truncated cone-cylinder is presented.
应用推荐