• 使用具有四端测量能力的欧姆计,以避免在测量结果中计入引线电阻。

    An ohmmeter with four-terminal measurement capability is used to prevent lead resistance from being added to the measurement. The source terminals are connected on either end of the contact pair.

    youdao

  • 控温电路采用四端电阻自平衡电流环路,从而保证其电气和温度均处于闭环状态。

    The control circuit is a self-balancing current loop which makes use of a four-terminal resistor of nickel wire to assure a close-loop both electrically and thermally.

    youdao

  • 对四端对阻抗测量仪在其使用频段内进行校准,须确定四端对标准电容器的频率特性。

    The calibration of four-terminal-pair(4TP) impedance meters at their working frequencies requires the knowledge of 4TP standard capacitor frequency characteristic.

    youdao

  • 从多支承系统出发,运用功率流和四端参数方法,研究了安装在柔性基础上设备振动的隔离问题。

    The problem of vibration isolation for the multi supporting machine installed on flexible foundations was studied by power flow and four end parameters methods.

    youdao

  • 在负载为纯力抗的状况下,利用纵振型变幅杆等效四端网络,对频率方程和放大系数进行了研究。

    Based on equivalent four-terminal networks of the longitudinal ultrasonic transformer, the resonant frequency equation and the amplitude magnification coefficient, with reactive load, are studied.

    youdao

  • 然后,借助于研制的精密四端对-单端口转换器,用四端对阻抗测量仪测量单端口电容器容量值;

    Secondly, with the aid of developed 4TP-single-terminal-port transform device, capacitance value of single-terminal-port capacitor is measured by 4TP impedance instrument.

    youdao

  • 本文以工程常见四端位移为零的振动板为例,提出一种新的压电式传感器的设计方法测量体积位移。

    With a shown example of the pinned-pinned plate, a new piezoelectric sensor design is presented to measure volume displacement.

    youdao

  • 以工程常见四端位移为零的振动板为例,提出一种新的压电式传感器的设计方法测量第一阶声辐射模态伴随系数。

    With the examples of the pinned-pinned plate, a new piezoelectric sensor design is presented to measure the first adjoint coefficient of radiation mode.

    youdao

  • 为考察消声器的性能,先用三维有限元法求出消声器两端的四端子参数,然后再根据四端子参数求出消声器的传递损失。

    The 3-D finite element method is used to obtain the four-pole parameters of a muffler which are in turn used to calculate the transmission loss.

    youdao

  • 为考察消声器的性能,先用三维有限元法求出消声器两端的四端子参数,然后再根据四端子参数求出消声器的传递损失。

    The 3-D finite element method is used to obtain the four-pole parameters of a muffler which are in turn used to calculate the transmission loss.

    youdao

$firstVoiceSent
- 来自原声例句
小调查
请问您想要如何调整此模块?

感谢您的反馈,我们会尽快进行适当修改!
进来说说原因吧 确定
小调查
请问您想要如何调整此模块?

感谢您的反馈,我们会尽快进行适当修改!
进来说说原因吧 确定