• 影响反应强度的一个简单因素,就是产生神经冲动的神经元数量,神经元越多,反应强度越大。

    So, one simple way to code intensity is the number of neurons firing; the more neurons the more intense.

    youdao

  • 在胚胎发育的不同阶段,免疫反应强度亦不等。

    The staining intensity was unequal at the different embryonic stages of the fetus.

    youdao

  • 雄虫的反应强度比雌虫强,尤其在间质部位最明显。

    The higher reaction intensity appeared in male worm, especially in parenchyma when compared with the female.

    youdao

  • 与外周血单个核细胞相比,脐血细胞的血清学反应强度偏低。

    Its serological reaction is lower as compared with that of peripheral mononuclear cells.

    youdao

  • 然后,依据PPD反应强度及活动性肺结核病人检出情况测算结核感染率及患病率。

    Then, calculate tuberculosis infectious rate and morbidity according to PPD reaction intensity and finding of active tuberculosis patients.

    youdao

  • 目的了解某沿海医科大学临床医学专业本科一年级和三年级学生目标设置的内容、反应强度及相关社会心理因素;

    Objective To investigate the contents, responsive intensities and psychosocial factors of the goals set by the medical freshmen and juniors in a medical university in coastal area.

    youdao

  • 其表面的多角形组成部分对紫外光产生反应,映射太阳光线的方位和强度。

    The polygonal segments of the surface react to ultra-violet light, mapping the position and intensity of solar rays.

    youdao

  • 根据皮层小泡释放强度,可将皮层反应分为潜伏期、发展期、高潮期、衰退期四个时期。

    According to the release intensity of the cortex vesicles, cortical reaction can be divided into the latent period, development period, climactic period, declining period.

    youdao

  • 通过比较三种方法的酶活力回收、最适反应条件、GOS的得率和和载体机械强度,选择明胶作为固定化细胞的载体。

    By comparing with each other in the enzyme recovery, optimal reaction conditions, yields of GOS and mechanical strength of the carriers, the gelatin was selected as better carrier for immobilization.

    youdao

  • 采用L9(34)正交实验,考察了引发剂的浓度、反应时间、单体的体积比和PVA用量对木材胶黏剂的剪切强度的影响。

    L9 (34) orthogonal experiment was adopted, the effects of concentration of initiator, reaction time, volume ratio of monomers and amount of PVA on shear strength of adhesive were investigated.

    youdao

  • 随着结焦时间的延长,焦炭的热态性能,即焦炭反应性(CRI)和反应后强度(CSR),均得到提高。

    The high temperature properties, coke reactivity index (CRI) and coke strength after reaction (CSR) are improved with longer carbonization time.

    youdao

  • 采用酸溶法测定并比较几种典型的火山灰质掺合料的火山灰活性,探讨其火山灰反应程度对浆体强度的影响。

    Pozzolanic reactivity of several pozzolanic admixture were measured and compared by acid dissolution method. Effects of reaction degree of pozzolanic admixture on strength of paste were discussed.

    youdao

  • 同一温度条件下,随着焦炭层喷吹UPC量的增加,气化反应后焦炭的强度提高,粉末量减少。

    Under the same temperature, Strength of coke increases after the reaction and coke fines decreases as the amount of UPC being injected into coke layer increases.

    youdao

  • 结论杏仁外侧核参与了皮层水平听觉信息调制,影响持续性反应神经元对声音强度信息的编码。

    Conclusion la could participate in the modulation of auditory information in auditory cortex, influencing the sustained response neuron's encoding of the sound intensity message.

    youdao

  • 研究了反应条件对接枝率、交换容量和纤维强度的影响。

    The effects of reaction conditions on grafting yield, ion-exchange capacity and mechanical strength were studied.

    youdao

  • 机场水泥混凝土道面结构参数包括板厚、混凝土弯拉强度和弯拉弹性模量、地基反应模量。

    Airport cement concrete pavement structural parameters include slab thickness, concrete bending strength elastic modulus and foundation reaction module.

    youdao

  • 结果表明,真空烧结过程中出现了界面反应,改善了界面结合强度,断裂破坏主要在基体上进行。

    The results show that interface element diffusion and reaction on interface in vacuum hot-pressing sintering processing improved interface strength. Fracture occurred mainly in Al matrix.

    youdao

  • 研究不同掺量的矿渣、粉煤灰和沸石粉对阿利特-硫铝酸钡钙水泥砂浆强度的影响规律,并对其反应机理进行探讨。

    The influence of different contents of slag, fly ash and zeolite powers on the strength of alite-calcium barium sulphoaluminate cement mortar is investigated, and the reaction mechanism is discussed.

    youdao

  • 研究了在模拟太阳光和高压汞灯作用下,不同浓度的光催化剂和紫外光辐射强度对孔雀绿废液的光催化降解反应。

    The photocatalytic degradation reactions of peacock green dye were studied with photocatalyst of different concentration and UV radiation strength under simulated sunlight and UV lamp.

    youdao

  • 考察了各因素对反应型聚氨酯热熔胶粘接强度、固化速度等性能的影响。

    The factors which influenced adhesive strength, curing speed of reactive polyurethane hot melt adhesive were studied.

    youdao

  • 阳性免疫反应产物的密度及强度在神经的远侧端大于近侧端。

    The intensity and density of positive immunoreactivity was greater in the distal stump than that in proximal stump.

    youdao

  • 产物的相对产率与反应体积内的激光强度之间存在着较强的依赖关系。

    The relative yield of individual product depends strongly on the Iaser intensity within the reactive volume.

    youdao

  • 对超高压聚乙烯反应管进行了应力分析、强度评定及结构的优化设计等项研究。

    In summary, the stress analysis, the stress intensity evaluation and the optimization for the ultra-high pressure polythene reactive tube have been carried out.

    youdao

  • 通过梯度液相烧结或中温反应烧结处理,热喷涂层具有很高的结合强度。

    The coating with high bond strength was synthesized by means of treatment of the gradient liquid phase sintering or medium temperature reactive sintering.

    youdao

  • 重点研究焦炭在高炉块状带内的抗压强度与温度和反应程度的关系。

    The relationship between temperature, carbon loss rate and compression strength of coke in the lumpish section of blast furnace was investigated.

    youdao

  • 在高碳范围内熔池脱碳反应速度与供氧强度和氧气利用率成正比,而提高吹氧压力可以提高氧气利用率。

    The decarburization rate in bath was proportional to the intensity of oxygen supply and the utilization ratio of oxygen was enhanced with the oxygen pressure rising.

    youdao

  • 在高碳范围内熔池脱碳反应速度与供氧强度和氧气利用率成正比。而提高吹氧压力可以提高氧气利用率。

    The decarburization rate in bath is proportional to the intensity of oxygen supply and the utilization ratio of oxygen depends on the oxygen pressure.

    youdao

  • 研究了酸度、温度、时间、离子强度、不同类型蛋白质等对该反应体系的影响。

    The influences of acidity, sodium chloride concentration, temperature, reaction time and other proteins on the interaction have been investigated.

    youdao

  • 三聚氰胺可以和其它聚合物发生聚合反应,形成立体网状结构,提高聚合物的强度、韧性、阻燃性等。

    Melamine could polymerized with other polymers to form crosslinked network structure, which could improve the strength, toughness and flame retardance and other properties.

    youdao

  • 玻纤增强汽车门内饰板采用结构反应模塑(SRIM)工艺生产,在保证强度的前提下有效减小了零部件的质量。

    SRIM process was adopted to produce automotive door interior trimming panel, where mass of parts can be reduced without strength decrease.

    youdao

$firstVoiceSent
- 来自原声例句
小调查
请问您想要如何调整此模块?

感谢您的反馈,我们会尽快进行适当修改!
进来说说原因吧 确定
小调查
请问您想要如何调整此模块?

感谢您的反馈,我们会尽快进行适当修改!
进来说说原因吧 确定