反应本身也在纳米管内部发生。这种中空的纳米管只有20纳米厚的薄壁,所以具有巨大的内表面积。
The reaction itself also takes place inside the nanotubes, which are hollow and have a large internal surface area thanks to their thin 20-nanometer-thick walls.
全位置自动焊接技术的特点是,焊丝可以连续送进,焊丝熔敷速度快,焊接质量较高,尤其适用于大口径、厚壁管的焊接。
This welding process, with continuous welding wire feeding, fast deposit speed and quality welding pass, is especially suitable for long distance pipeline with large diameter and thick wall.
针对45钢冷拔厚壁管存在内表面横裂纹问题,分析了其产生的原因。
The causes of inner transversal crack of cold-draw heavy wall pipe of 45 steel were analyzed.
在单独使用或用于厚壁管焊接时,应选用低氢耐热钢焊条。
In a separate use or for the thick-walled tube welding, heat-resistant steel should use low hydrogen electrodes.
对椭圆断面厚壁螺旋管进行了强化传热和流体阻力实验研究。
The heat transfer enhancement and pressure drop of spiral tube with oval cross section and thick wall were investigated.
通过外观检验、壁厚测量、扫描电镜、能谱和X射线衍射,对省煤器管腐蚀原因进行了分析。
Through appearance inspection, wall thickness measurement, EDS analysis and X-ray diffraction, the corrosion cause of the coal economizer tube is analysed.
利用有限元法证实了内高压成形三通管的可行性,给出了不同轴向进给速度下零件的壁厚及应变分布,并就轴向进给速度对成形的影响进行了分析。
The feasibility of hydroforming tri-branch tube is proved by FEM. The corresponding thickness and strain distribution of different axial feed velocity on the simulation is analyzed.
同时既能提供生产大口径、厚壁管所需的圆钢锭,又不需要对轧管穿孔机的辊型进行修改。
Simultaneously, round steel ingots which are used to produce pipes with large diameters and thick walls are provided without modifying roll shapes of rolling pipe piercers.
通过正交试验方法验证得到:在上述参数条件下可以获得壁厚均匀、耐高压、等强度的钛合金环形管。
The titanium ring pipe with uniform wall thickness, high-voltage-resistance and equal strength was obtained using the above mentioned parameters, detected by the orthogonal test.
用其制备成的内径75~360毫米、壁厚7~30毫米的芯管,可以取代现有各种纸质芯管,具有广泛推广应用前景。
The prepared core pipe with 75mm to 360mm of inside diameter and 7mm to 30mm of wall thickness can replace various paper core pipes, thereby having a wide popularization and application prospect.
专业供应各种规格的不锈钢管,不锈钢方管,不锈钢无缝管,不锈钢镜面管,毛细管,厚壁管!
Our company specialize in various specifications of the stainless steel tube, stainless steel square tubes, stainless steel seamless tube, stainless steel mirror tube, capillary, thick wall pipe!
计算结果表明:在转臂上施加一定的反向弯矩,能有效减小弯管的壁厚减薄率。
It shows that pipe bending by using induction heating applied a counter torque can efficiently reduce the thinning ratio of pipe wall thickness.
分析结果表明,该模型符合管端增厚控制的工艺要求。
The actual calculation result is analyzed and the result indicates these models can meet the requirements of the technology for pipe end upset control.
发生过程中内皮细胞由厚变薄,血管平均截面积逐渐减小,管腔的体密度增大;
During development, the endothelial cells thinned , the average profile area of the vessels reduced and the volume density of vascular lumen increased gradually.
在斜轧穿孔过程中,由于轧件旋进力克服不了顶头的阻力,因此轧制厚壁管或高合金钢管时在穿孔后期造成后轧卡。
In the cross piercing process, as the piercing precession power can not overcome the resistance force, it will lead to rear-jamming when rolling thick-wall tubes or high alloy tubes.
受累动脉管壁不同程度地向心性或偏心性增厚,管腔狭窄或闭塞。
The affected artery wall had varying degrees of concentric or eccentric thickening, and stenosis or occlusion of lumen was observed.
动脉壁明显增厚,管腔狭窄。
The arteriolar wall is markedly thickened and the lumen is narrowed.
结节状小叶间隔增厚可见于癌性淋巴管炎、结节病和硅肺。
Nodular thickening of interlobular septa can be seen in lymphangitic carcinomatosis, sarcoidosis, and silicosis.
诊断:右肺癌、癌性淋巴管炎,并小叶间隔增厚。
Diagnosis: Lymphangitic spread of carcinoma, right hilar bronchogenic carcinoma, with interlobular septal thickening.
此例未见一般在淋巴管转移癌常见的小叶间隔增厚。
Interlobular septal thickening, common with lymphangitic spread of carcinoma is not seen in this case.
通过与已有文献的比较,得出的结论同时适用于内层管为薄壁管和厚壁管的情况。
The conclusions are applicable to the case where the inner tube is thin-walled or thick-walled in comparison with available literatures.
对厚壁管感应加热设备及热处理工艺进行了重新设计改造。
The induction heating equipment and heat treatment process of thick-wall pipe were reconstructed.
还给出微泵流量与扩散管长宽比、厚宽比、液体粘度和进出口反压差的定量关系。
Quantitative relations of the pump flow rate versus the ratio of diffuser length to width, the ratio of diffuser thickness to width, fluid viscosity and backpressure were also given.
将传质方程引入到垂直管降膜蒸发传热模型中,求解时考虑了径向速度、质量扩散系数和膜厚变化对传热的影响。
The mass transfer equation was introduced into heat transfer model of falling film evaporation. The radial velocity, mass diffusion coefficient and variation of film thickness were taken into account.
并分析了缩径率、缩径凹模半锥角、摩擦系数、缩径管坯初始壁厚对管端翘曲和轴向伸长率的影响规律。
In addition, this paper presents how the diameter reducing rate, the die semicone angle, the friction coefficient and the original wall thickness influence the buckling and the axial elongation rate.
然而,在结节病和煤尘肺,间隔增厚常较淋巴管转移癌轻。
However, in sarcoidosis and coal worker's pneumoconiosis, septal thickening is usually less extensive than that seen in patients with lymphatic spread of tumor.
本文根据理论分析和实际测定推导出管坯壁厚计算公式及确定管坯壁厚的计算方法。
Formulas for calculating the shell wall thick-ness are derived and a method for calculating the wall thickness is also obtained based on related theoretical analyses and actual measuring results.
本文根据理论分析和实际测定推导出管坯壁厚计算公式及确定管坯壁厚的计算方法。
Formulas for calculating the shell wall thick-ness are derived and a method for calculating the wall thickness is also obtained based on related theoretical analyses and actual measuring results.
应用推荐