压降是超重力旋转床流体力学的重要特征之一。
The pressure drop is one of the most important characteristics in hydrodynamics of high-gravity rotating bed.
随着孔径和喷嘴压降的增加,N值总是下降的。
N always decreases with the increase of nozzle pressure drop or orifice diameter.
每个位置的温度和测试区两端的压降各记录三次。
The temperature at each position and pressure drop across the test section were recorded three times.
特点:低饱和压降,电流放大线性好,开关速度快。
Features: Low saturation voltage, excellent dependence of hFE on current, fast switching time.
此外,随来流流量和颗粒浓度的增加,过滤压降增加。
Increases in the inlet flow rate or the particle concentration both increase the filter pressure drop.
合适颗粒直径的选择与孔隙率、压降和强度的要求有关。
The particle diameter selection then depends on the porosity, pressure drops, and plate strength.
对自然循环和强迫循环流动中压降流量特性进行了比较。
The pressure drop characteristic in natural circulation was compared with that in forced circulation.
建立了计算旋风分离器压降及速度分布指数的通用计算式。
A semitheoretical modeling to calculate pressure drop and exponent of vortex velocity profile is deduced.
本文研究了壁流式DPF系统基于压降特性的失效诊断策略。
This paper studies up on the strategy for failure diagnosis of wall-flow DPF system based on pressure drop characteristics.
CU7直线管、提升型结构压降最小,流量特性曲线平稳圆滑。
The straight line, poppet-type construction of the CU7 minimizes pressure drop and provides smooth flow characteristics.
结果表明,旋转床气相压降随F因子和旋转速度的增大而增大;
The results indicate that the pressure drop increases as F factor or rotational speeds increase.
这样能降低购买成本,更重要的是能减小系统压降及空气损耗。
This can reduce the purchase cost, the more important is to be able to reduce the system pressure drop and air loss.
流化床内的固定藏量可以用测定床层的压降办法很容易地求得。
The inventory of solids in a fluidized bed can easily be found by pressure drop measurements across the bed.
有喷淋时,压降的变化主要是气速、喷淋密度共同作用的结果。
When spraying, it is shown that gas velocity and spraying density jointly affect pressure drop.
结果表明,U型弧底节流孔具有更大的压降和更高的热力学效率。
It is shown that the U-bottom orifice has higher total pressure drop and (thermodynamic) efficiency.
根据输入的不同,在过载的条件下,输入端压降可能达到若干伏。
In an overload condition, the voltage burden can reach many volts, depending on the input value.
散热器散热能力的评估需要压降-流量曲线和换热量-流量曲线。
The heat dissipation assessment of radiator needs both drawdown flow curve and heat exchange flow curve.
油井和气井的压力不稳定测试,包括压降曲线测试和压力恢复测试。
Unsteady testing for oil and gas well includes testing of drawdown curve and build-up curve.
在需要关注压降的地方,应采用不缩径全流道球阀或类似结构的阀门。
Where pressure drop is a concern, full-port ball valves or like construction are to be used.
采用因次分析的方法推导出错流旋转填料床气相压降的无因次关联式。
The correlative formulas for pressure drop of cross-flow rotating packed bed was deduced with the method of dimensional analysis.
换热器的翅片间距和翅片厚度是影响换热器换热和压降特性的重要因素。
The fin pitch and fin thickness of the exchanger are the key parameters for heat transfer and pressure drop.
能测试各种LED发光矩阵每个发光元的发光强度,正向压降和反向电流。
It can be used to measure the luminous intensity, forward voltage, reverse current of each luminous dot in all kinds of LED luminous dot matrix.
具体地说,如果装置为低阻抗,那么通过开关的电流就会引起很明显的压降。
In particular, if the devices have low resistance, the current flowing through the switches may cause a significant voltage drop.
传统规整填料压降模型的来源主要是散堆填料的压降关联式和湿壁塔模型。
The traditional models reviewed for structured packing were mainly derived from correlations for random packing or the model for wetted-wall column.
为了安全起见我们要在取样点设双阀以便于安全的压降,取样口还要加护罩。
For safety we should use dual valves to aid safe pressure reduction, and cap the sample outlets.
在将一个电压源切换至多个装置时,则可能必须补偿由于开关电阻引起的压降。
When switching a voltage source to multiple devices, it may become necessary to compensate for voltage drops due to switch resistance.
本文通过对化工装置系统压降性能的技术经济分析,得出合理的压降设计策略。
The rational strategy for designing the pressure drop is proposed by technical and economic analysis on the pressure drop performances of chemical plant system.
由以上结果得出的压降计算方法能比较准确地确定气液两相气泡流的压力损失。
The pressure drop calculation method obtained from above results can be used to accurately determine the pressure loss of two-phase gas bubble flow.
由以上结果得出的压降计算方法能比较准确地确定气液两相气泡流的压力损失。
The pressure drop calculation method obtained from above results can be used to accurately determine the pressure loss of two-phase gas bubble flow.
应用推荐