按“检测”键,可自动完成一个单轴的检测过程。
Press the "test" key and the test process of a single axle can automatically be finished.
单轴的应力状态跟棱柱杆承受单纯轴向拉伸十分近似。
The condition of uniaxial stress is closely approximated in prismatic bars subjected to pure axial tensile.
介绍了SZT-1 型单轴转台的设计及低温环境下正常工作的实现。
The design of SZT-1 gyrometer test table and the realization for its working at the low temperature are introduced.
抛物面一种有与单坐标轴平行的抛物截面和与该轴垂直的椭圆截面的平面。
A surface having parabolic sections parallel to a single coordinate axis and elliptic sections perpendicular to that axis.
这将检测到大约 63 个双坐标轴空间移位,这与膝上型计算机在处于运行状态时被放在典型的单肩背膝上型计算机包中的情况一致。
This will pick up about 63 dual-axis dimensional shifts, consistent with the laptop being running while in an over-the-shoulder typical laptop bag.
依据这一模型,分析了单轴压缩时岩石破坏阶段声发射特性与压机刚度的关系。
The relation between AE characteristics during rock failure and machine stiffness is analysed under uniaxial compression with the above model.
介绍了一种用于MEMS薄膜材料力学特性测试的单轴拉伸试验方法。
A uniaxial tensile test method for measuring mechanical properties of MEMS thin film materials is presented.
本文建立了两段式的腐蚀混凝土单轴受压本构模型,与试验数据比较符合。
The constitutive model of corroded concrete under uniaxial compression is established which has two expression and is proved by the experiment outcomes.
对于单马达转向架,转向架上的两根轴由同一个马达驱动,常常会遇到扭转的共振,这将导致周期性的滑动。
Monomotor bogies, where both axles of the bogie are driven by a single motor, often encounter torsional resonances, which lead to periodic longitudinal slip.
本文从微观统计的损伤理论出发,建立了腐蚀混凝土单轴受压本构模型,与试验结果较符合。
Beginning with the damage theory of micro-statistics, the constitutive model of corroded concrete under uniaxial compression is established which is proved by the experimental outcomes.
通过岩块试验回归了探针的临界载荷和所对应的岩石单轴抗压强度之间的关系。
Through the rock mass test, the linear relationship between critical load of the probe and its corresponding rock compressive strength is regressed.
1873年,美国的斯潘塞制成一台单轴自动车床,不久他又制成三轴自动车床。
In 1873, the United States into a single spencer shaft automatic lathe, soon he and three axis made automatic lathe.
最广泛应用的单轴感应式信号传感器是微动同步器。
The most widely used single - axis inductive pickoff is the microsyn.
通过单桩竖向抗压静载试验和动载试验,分析了静动载对桩身轴力分布、桩身侧摩阻力和基桩沉降的影响及其变化规律。
Distributive regularities of inner force of pile under static and dynamic load, the change of pile's side resistance, and settlement of piles are analyzed by static and dynamic load test.
最广泛应用的单轴感应式信号传感器是微动同步器。
The most widely used single-axis inductive pickoff is the microsyn .
结果表明,该数值模型及计算方法能够较好地反映混凝土在单轴荷载作用下的力学特性。
It is shown that that numerical mode and calculation means are used to simulate the mechanical behaviors of concrete in uniaxial load.
利用CT识别技术对非贯通节理试样的单轴加载全过程进行即时扫描。
Ct identification technology is used to conduct timely scanning of the uniaxial loading complete process of non-consecutive joint samples.
笔者以杨陵黄土为对象,进行了原状黄土和击实黄土单轴抗拉的三轴抗拉试验。
In this paper, intact loess samples and disturbed loess samples of Yangling are studied by using uniaxial and triaxial tensile tests.
在实验的基础上,对单轴pmma试件的蠕变型本构关系进行了研究。
Basing on experiments, the creep constitutive relations of PMMA were researched.
对SS304不锈钢在室温单轴循环加载下的时相关棘轮行为和时相关应变循环特性进行了实验研究。
The uniaxial time-dependent strain cyclic characteristics and ratcheting behavior of SS304 stainless steel were studied by cyclic loading experiments at room temperature.
分析复合理论和纤维间距理论的缺陷,并且通过连续纤维增强水泥基复合材料的单轴拉伸试验加以验证。
The defects of composite material theory and fiber distance theory are analysed, and they are verified through uniaxial stretch test of continuous fiber reinforced composite material for cement base.
研究了6063锻造铝合金单轴拉压载荷下的疲劳特性。
The fatigue characteristic of forged 6063 al alloy under uniaxial loading was studied.
提出了单轴压缩的岩样在受到剪切破坏条件下的全部变形特征,即轴向、侧向、环向、体积应变及峰后泊松比的解析式。
Analytical solutions of axial, lateral, circumferential and volumetric strains, and post-peak Poisson's ratio of rock specimen subjected to shear failure in uniaxial compression are proposed.
本文讨论了将模型跟踪综合技术用于单轴液压速度转台综合设计的四种方法。
In this paper four model following approaches are used to design Hydraulic Velocity Flight Simulation Table with One Axis.
这一过程的最新阶段是设计出一种将发电机置于燃气轮机和汽轮机之间的单轴布置方案。
The latest stage in this development process is a single-shaft arrangement with the generator located between the gas and steam turbine.
在高水固结充填体单轴SHPB冲击实验的基础上,得出了充填体的的典型冲击波形;
On the basis of the uniaxial SHPB experiments, the typical impact waves are obtained about the high water material solidifying backfill body.
交换各向异性与单轴各向异性之间的竞争使体系存在单稳态与双稳态两种不同的状态,直接决定了交换偏置的角度依赖关系。
It is found that the system will be in monostable state or bistable state, which is controlled by the competition between the uniaxial anisotropy and the exchange anisotropy of the system.
通过对一种硫化橡胶在变温条件下进行的单轴拉伸实验,考察了硫化橡胶在变温、大变形条件下的力学特性。
In this paper, experiment of uniaxial extension for a vulcanized rubber at different temperatures was carried out and some mechanical characteristics of vulcanized rubber were investigated.
通过对一种硫化橡胶在变温条件下进行的单轴拉伸实验,考察了硫化橡胶在变温、大变形条件下的力学特性。
In this paper, experiment of uniaxial extension for a vulcanized rubber at different temperatures was carried out and some mechanical characteristics of vulcanized rubber were investigated.
应用推荐