介绍了一种由冲击电压发生器和峰值电压表组成的用于电机磁极线圈匝间绝缘试验的设备，详细说明了设备的工作原理及关键技术，给出了试验结果。
The paper introduces a type of the turn-to-turn insulation test equipment including an impulse-voltage generator and a peak voltmeter for the electrical machine pole coil.
是理想的干式电力变压器、电抗器及其它电机槽间、匝间、层间绝缘材料。
It is an ideal slot, interturn and interlayer insulating material of dry type power transformers, reactors and other motors.
提出了新型匝间绝缘结构。
应用领域：适用于电机、变压器槽绝缘、匝间绝缘和衬垫绝缘。
Application: It is widely used in slot, phase and liner insulating of motor, transformer and so on.
在对干式空心电抗器参数计算的基础上，提出了用脉冲电压谐振法进行电抗器匝间绝缘缺陷的检测。
Based on the parameter calculation of the air core reactor, this paper presents a pulse voltage resonance method to detect turn to turn insulation defects in air core reactors.
论述了高压电机绕阻匝间绝缘故障发生原因，保护措施以及故障检测手段等，提出了提高匝问绝缘可靠性的办法。
Accident -easons of winding turn-to-turn insulation in a Hv motor are analyzed, protection measures and accident inspection methods are discussed.
在制造电抗器前，需要对电抗器的过电压耐受进行评估，保证匝间电压小于绝缘值。
Before manufacturing the CLI, the over-voltage withstand ability of CLI should be evaluated to ensure the voltage between two coils less than the withstand value.
单只线圈制造完成后，在下线前应经过匝间耐电压试验，以保证匝间绝缘质量。
After coil manufacturing, the coils shall be treated with inter-turn voltage withstanding test to ensure the inter-turn insulation quality before inserting coil.
可在气体或油的绝缘系统内作层间绝缘。主要用于六氟化硫互感器和变压器的层间绝缘及匝间绝缘。
It can be used for interlayer isolation of gas or oil insulation system, especially interlayer insulation and turn-to-turn insulation of sulfur hexafluoride mutual inductors and transformers.
在场的计算中，讨论了定子股线绝缘和转子匝间绝缘对电磁场及温度场的影响。
Calculating results with and without the consideration of insulation is compared and the effect of insulation to the air gap magnetic field and rotor temperature field is analyzed.
附着于管道的电线至少每4英尺（122.4厘米）需要用提供的夹子、电缆扎匝或绝缘胶带固定。
The wire shall be attached to the tubing with supplied clips, cable ties, or electrical tape, at least every 4 ft (122.4 cm).
附着于管道的电线至少每4英尺（122.4厘米）需要用提供的夹子、电缆扎匝或绝缘胶带固定。
The wire shall be attached to the tubing with supplied clips, cable ties, or electrical tape, at least every 4 ft (122.4 cm).
应用推荐