这些指标是风险概率评估和网络管理的最小割集。
These indicators are the minimum cut sets in probabilistic risk assessment and network management.
本文给出“割集矩阵可实现性算法”的计算机程序。
This paper presents a computer program for the realizability of a cutset matrix.
通过实例验证了该方法能快速准确地获得故障树的最小割集。
The results of exemplified calculation demonstrate that minimum cuts of fault tree can be accurately and quickly obtained.
此外,对这两种积的局部割集和广义割集的性质也进行了考虑。
In addition, properties on local cuts and generalized cuts in these two kinds of product of graphs are also considered.
给出一种基于潮流追踪和发电机再调度的割集断面潮流控制方法。
An interface power control strategy based on power flow tracing and generator re-dispatch is presented.
本文讨论基于最小路径和最小割集的复杂系统可靠性的描述与计算问题。
In this paper, we discuss the problem about description and calculation of reliability based on minimal path and minimal cutset for the class of complex system.
文中采用割集法求解,可以解各类具有复杂负载的MHD发电机的等效网络。
The cutset method can be used for solving circuit problems in the MHD generator under various loading conditions.
提出一种基于最小割集的故障模式分析方法,对复杂配电系统进行可靠性评估。
The paper presents a method based on the failure mode and effect analysis of minimal cuts to assess the reliability of large scale complicated power distribution system.
给出了一个新的模糊割集的概念,称之为模糊下割集,并讨论了它们的几个属性。
We presented a new concept of fuzzy cut sets that is called fuzzy lower cut sets, and discussed several properties of them.
介绍了故障树分析的基本概念,对其中用到的最小割集和最小径集做了详细的说明。
Some basic conceptions of fault tree analysis are described, especially least cut set and least path set used in it.
采用层次与关系相结合的装配模型,研究利用割集法自动求解装配与拆卸的并行序列问题。
With assembly model organized in hierarchical and relational mode, the problem of automatically generating assembly and disassembly sequence is explored using cut set theory.
阐述了最小割集理论及其在事故分析中的作用。为有效地控制事故和降低事故率提供依据。
This paper elaborates the action of minimum cutset in accident analysis, and provides the basis for effectively controlling accident and lowering accident rate.
在简化网络模型基础上可灵活、高效地用最小割集法搜索故障、进行网络重构和潮流计算。
With the simplified network model, the fault can be flexibly and efficiently searched by minimal cutset method, and the network reconstruction of and power flow calculation can be conducted.
与只基于通用割集或专用割集的验证方法相比,该方法可以使组合电路的验证速度明显提高。
Compared with the method only using universal cut or special cut, the method can obviously improve the speed of verification for combinational circuits.
应用事故树分析中的最小割集、最小径集及结构重要度,对汛期尾矿坝溃坝事故进行了研究。
Accordingly, the accident of tailings dam break during flood season is studied by applying fault tree analysis that includes minimum cut sets, minimum path sets and structure importance.
但若故障支路形成回路或割集时,则仍需要解一组非线性方程,不过它的变量个数已大大减少。
But if there have some loops or cut sets between these fault branches, solving a set of nonlinear equations is also necessary, though the number of variables is much decreased.
在结构保持模型的基础上,根据网络中暂态能量的变化规律,定义了支路及割集的脆弱性指标。
Based on the structure preserving model, according to the variation of transient energy in power network, line vulnerability index and outset vulnerability index are defined.
该算法利用二进制数分割无向图的顶点集,通过对子图各顶点的关联集的运算产生相应的割集。
The algorithm use a binary digit to divide the vertex set of a non-direction graph, and employ the incident sets of the vertices in the subgraph to produce opposite cut sets.
采用最小割集分析法确定了导致制冷系统失效的主要因素,提出了改善集中空调系统可靠性的途径。
Finds out the main factors causing the refrigerating system failure by the minimal cut set analysis (MCSA). Proposes the measure to improve the reliability of CACS.
应用事故树分析中的最小割集、最小径集和结构重要度,对矿井采煤工作面瓦斯爆炸事故进行了研究。
Gas explosion accidents on the coalface of mines are studied, using minimal cut set, minimal radius set and structural importance.
利用二元决策图(BDD)中的B—割集和节点概率,提出了基于BDD的关联故障树定量分析新算法。
By the B-cut sets and the probabilities of the nodes of Binary Decision Diagrams (BDD), a new quantitative analysis algorithm of coherent fault tree based on BDD is presented in this paper.
提出了一种完全脱离马尔可夫模型的求解动态故障树顶事件发生概率的方法和一种最小顺序割集的生成方法。
Then this thesis presents a new approach to solve top event occurrence rate and a new generation algorithm of minimal cut sequence of dynamic fault tree that deviate from Markov model completely.
该方法用状态空间法求解输入母线单元失效频率和平均修复时间,用最小割集法计算整个系统的供电可靠性指标。
Failure rate and average repair time of input-bus unit were calculated by state Spaces method. Power reliability indices of whole systems were computed by min-cut method.
可是对含有纯电容回路和纯电感割集的奇异电路,在“换路”瞬间其初始值有可能发生跃变现象,不能用换路定则来求解。
But in the singularity circuits that contain pure capacitance loop and pure inductance cutset, the initial value is possible of jumping phenomenon when switching.
网络最大流与最小割集的矩阵算法,不仅能解决许多这类问题,而且能使最小费用流、分配问题和运输问题容易通过计算机来实现。
Matrix arithmetic of network maximal flux and minimal separate set not only solves these problems, but also solves some other problems by the computer such as minimal fee, distribution and transport.
结合电力通信系统的特点,建立了电力通信系统的有效性模型,采用最小割集分析法进行了定性分析,以确定影响电力通信系统失效的主要因素。
The main factors causing the failure of power communication system can be determined by qualitative analysis in which the minimal cut set analysis (MCSA) is used.
新的模糊重要度计算方法解决了中值法中最小割集所含基本事件模糊重要度相同的问题, 考虑了基本事件发生概率的不同对系统顶事件的影响。
The new fuzzy importance calculating method solved the problem of median method that the basic events in minimum cut sets have the same fuzzy importance degree.
采用一种改进的故障树分析方法对所得到的故障进行分析,根据每类故障分别建造了多棵故障树,并以最小割集理论按下行法对各树进行了定量分析。
Faults are analyzed by means of an improved fault tree analysis, and several fault trees are built for every kind of faults, then make down-way quantity analysis with the minimal cut set theory.
第二部分讨论稳态响应的线性关系,在论证过程中提出了含有纯电容割集的网络及含有纯电感回路的网络为非衰减网络等几条定理,并进行了比较严谨的证明。
In the course of demonstration, several theorems are posed and proved in detail, such as networks including pure capacitance cut-sets and pure inductance loops are non-decaying, etc.
第二部分讨论稳态响应的线性关系,在论证过程中提出了含有纯电容割集的网络及含有纯电感回路的网络为非衰减网络等几条定理,并进行了比较严谨的证明。
In the course of demonstration, several theorems are posed and proved in detail, such as networks including pure capacitance cut-sets and pure inductance loops are non-decaying, etc.
应用推荐