切削速度和材料硬度是决定切屑变形的两个主要影响因素。
And that cutting speed and material hardness are two main influential factors that determine chip deformation.
从切屑变形力与摩擦力两方面分析了切向磨削力与法向磨削力的比值，大体上应在0.2～0.59范围内。
We have also analysed the ratio between tangential forces and normol forces with respect to both chip formation forces and friction forces. The ratio generally falls within the range of 0.2~0.59.
钛合金的切屑变形从低速起就是一种典型的集中剪切滑移，这种集中剪切滑移在高速切削大部分难加工材料时是一种普遍现象。
The chip deformation of titanium alloys is typical shear localization from low cutting speed, which is general phenomenon in machining of difficult to cut material at high cutting speed.
然后变形金属（称为切屑）流过刀具（前倾）面。
Then the deformed metal (called chip) flows over the tool (rake) face.
在径向未变形切屑厚度公式的推导中，考虑了刀具进给运动的三维特点。
The three dimensional characteristic of cutter feed motion is considered in the formulation of undeformed radial chip thickness.
研究发现：砂轮速度和磨削深度对表面粗糙度的影响都可归结为未变形切屑厚度的改变。
It is found that the surface roughness influenced by wheel speed and grinding depth can be attributed to the changing of undeformed chip thickness.
通过对切屑截面几何、变形状态及切削比的实验分析，研究了非自由切削的变形特征。
The deformation characteristics of non free cutting (NFC) are experimentally studied with the chip cross section geometry, the deformation configuration and the cutting ratio.
锯齿形切屑产生的原因是第一变形区内因热软化超过应变和应变率强化而发生了绝热剪切局部化。
The reason for the sawtooth chips is that the adiabatic shear localization occurs in the primary deformation zones when thermal softening exceeds strain and strain rate hardening.
带切屑瘤的连续切屑：这种切屑显示了粘合或“焊接”在刀具面上材料局部高度变形区的存在。
Continuous with a built-up edge. This chip shows the existence of a localized, highly deformed zone of material attached or "welded" on the tool face.
带切屑瘤的连续切屑：这种切屑显示了粘合或“焊接”在刀具面上材料局部高度变形区的存在。
Continuous with a built-up edge. This chip shows the existence of a localized, highly deformed zone of material attached or "welded" on the tool face.
应用推荐