GCC还可以帮助将函数划分到热区和冷区。
GCC can also help to partition functions into hot and cold sections.
炉体分为预热区、加热区、保温区、缓冷区。
It is divided into preheating zone, heating zone, heat preservation zone and natural cooling.
测量断面的平均计数、噪声、冷区对比度及剖面曲线。
The mean counts, noise, contrast and profile curves of the slices were measured.
本文介绍一个连铸二冷区铸坯表面温度测量系统的测量方法和实际应用情况。
The application and measuring method of a slab surface temperature measuring system for secondary cooling zone of continuous casting are introduced.
提出了一种基于带有变异算子的改进粒子群算法对二冷区水量进行优化的新方法。
A novel method based on modified particle swarm optimization (IPSO) with mutation algorithm was proposed to optimize water quantity in secondary cooling process in the continuous slab casting.
探讨纺丝组件、冷却条件及集束上油、缓冷区、拉伸工艺等条件对产品质量的影响。
The influence of process condition such as spinning pack, cooling condition, collection oiling, annealed zone, drawing condition etc on products quality were expounded.
液芯压下应该在结晶器出口处及二冷区扇形段开始部分进行，这样能减小铸坯的应变。
It was considered that the reduction should be performed in the mould exit and the upper strand segment to decrease the strand stress.
由于氨的聚集与氧的存在，在凝汽器空冷区出现过冷度的情况下，铜管的氨腐蚀是不可避免的。
Ammonia corrosion of condenser copper tubes in the air removal section cannot be avoided as a result of ammonia collection and existence under super cooling condition.
大气逆辐射在东北冷区最明显，在黄土高原区最弱；地表长波辐射在西北干旱区最强而在东北冷区最弱。
The downward long-wave radiation is strongest in the cold region and weakest in the Loess Plateau while the upward long-wave radiation is obvious in the arid region and weak in the cold region.
由冶金准则及设备约束条件设计优化算法的价值函数，用改进粒子群优化算法以价值函数值最小化为目标，对二冷区各段的水量进行优化。
Value function consists of metallurgical criteria and equipment constraints, the IPSO algorithm applies for optimal of the secondary cooling system aiming at minimize value function.
如果行星处于可居住区的更冷(外)端，它或许会进入冰冻和解冻周期。
If the planet is on the cooler edge of the habitable zone, it could go through cycles of freezing and thawing.
更多热量到达了格陵兰和北极的冰区，所以冷洋流沿着欧洲海岸线向下流动，欧洲就会经历较冷的天气。
More heat is over the ice fields of Greenland and the Arctic, so colder water flows down along the European coastline, thus colder weather in Europe.
于是，空气总是从冷的地方流向热的地方，而风则从高气压地区吹向低气压区。
Thus, air ordinarily moves from cooler places to warmer places, and winds blow from high pressure areas to low pressure areas.
从1975年起，在复垦后的泥浆区，冷季、暖季草和湿地植物已经建立。
Cool and warm season grasses and wetland plants have been established on reclaimed slurry areas since 1975.
接头延伸率的改善同热影响区冷变形程度的减弱及焊缝强度、应力水平同母材趋于一致有很大关系。
Improvement of elongation of joint is related to weaker cool deformation degree of heat affect zone (HAZ) and uniformity of strength and stress level between weld and base metal.
这些现象的本质是环件冷辗扩过程中的径向和轴向塑性区的分布不同。
The nature reason of these phenomena was that the radial and axial plastic zone distributions were different in cold ring rolling.
通过工件工作区的应力分布云图考察金属材料的塑性流动情况，分析冷辗成形的机理。
According to stress distribution pattern in working region of the workpiece, the plastic flow condition is inspected, the mechanism of cold rolling forming is analyzed.
本文就此次冷修对贫化炉区炉顶结构改进做一总结。
This paper sums up the experi-ces to improve the cleaning zone roof structure in cold maintenance.
按尺度大小将降雹云团分为雷暴云、对流云、中尺度对流系统、冷云核、系统云系云区及云团边缘6类。
Hail clouds were classified 6 kinds according to scale: thunderstorm cloud, convective cloud, mesoscale convective system, cold-cloud-nuclei, cloud field of system clouds, and edge of cloud cluster.
本试验首次采用再结晶显示金属内塑性变形区的方法观察分析了焊接接头中冷裂纹产生的塑性变形区域。
In this investigation recrystallization in metals was first used to study the plastically - deformed zone induced by cold cracking in welds.
随着古季风活动的进一步衰退和海面的不断升高，来自陆架区的东北风变为冷湿气流。
With the farther decline of the paleo monsoon and the rise of the sea surface, the east north wind from the shelf was the cold wet air stream.
目的：观察冷刺激对青年人甲襞微循环及微区血流量的影响。
Conclusion: Cold stimulation can lead the disfunction of the nailfold microcirculation and decrease the microblood flow of nailfold.
由于在液氮温区附近氦气高低压焓差不平衡，导致G-M机蓄冷器中温度分布出现低温平台。
The disequilibrium of the enthalpy difference of helium at liquid - helium temperature region results in that the temperature distribution in the regenerator of a GM refrigerator forms a platform.
适宜黄土高原冷凉区水地种植。
冷涌爆发后，斧形干区南压过程中演变为倒T形干区，之后倒T形干区转变为西南东北向的带状干区进入南海海面。
After outbreak, the axe-shape arid region is turning into the inverted T shape as moving to south, followed by turning to southwest-northeast zonal arid region and moving to South China Sea.
在此基础上给出了相变区的物态方程，其中冷压为平台，内能计入了相变熵的影响。
Then the equation of state for phase transition region is achieved, where the cold pressure is constant and the energy includes the effect of the phase transition entropy.
结果显示本区气候总体冷期易旱、暖期易涝，显示季风气候区的特征。
It is revealed that droughts often occur in the cold periods while floods in the warm, indicating the monsoon climate change.
对真空冷阱中处于滑流区的气体换热，应考虑温度跳跃和速度滑移对换热的影响。
The effects of the temperature jump and the velocity slip on the heat transfer for the slip-flow regime in the cold trap of the freeze dryer are considered.
碲增加冷硬铸铁白口层厚度和硬度，缩小麻口区，但降低灰口部分的机械性能。
Te also raises the thickness and hardness of the chilled layer of white cast iron, reduces the area with mottle and lowers mechanical properties of the part of gray cast iron.
碲增加冷硬铸铁白口层厚度和硬度，缩小麻口区，但降低灰口部分的机械性能。
Te also raises the thickness and hardness of the chilled layer of white cast iron, reduces the area with mottle and lowers mechanical properties of the part of gray cast iron.
应用推荐