如果密炼机的轴滑动面磨损，可用金属喷镀方法修补，然后再磨光至原直径尺寸。
If the axis sliding surface wears, available metal spraying method patching, then regrinds the light to the original diameter size.
如果固定环端面硬度低于HRC40，则应先在端面上重新堆焊一层硬质合金，经磨光后再装配。
If the set collar end hardness is lower than HRC40, should first on the end surface again a built-up welding hard alloy, after the polish repackaging.
回收硅片即将硅片削去几微米，再对其表面进行磨光。
Reclaim is defined as the removal of several microns of the silicon wafer and subsequent re-polishing of the wafer surface.
若喷丸强化后再表面磨光，则可以进一步改善喷丸强化提高SCC抗力的效果。
The SCCR could be further improved by promptly polishing the surface after shot peening.
若喷丸强化后再表面磨光，则可以进一步改善喷丸强化提高SCC抗力的效果。
The SCCR could be further improved by promptly polishing the surface after shot peening.
应用推荐