研究了尖头、钝头弹在侵彻机理上的差异。
The differences in the penetration mechanism between cuspidal and blunt projectiles are studied.
第二章对弹丸侵彻有界靶进行了理论分析。
The boundary effect of finite targets on the penetration are analyzed.
进行了聚能装药对钢筋混凝土的侵彻机理研究。
The mechanism of shaped charge penetrating reinforced concrete is researched.
进行了动能侵彻体对预损伤混凝土的侵彻机理研究。
The mechanism of KE projectile penetrating the pre-damage concrete is researched.
为了提高混凝土破障弹的威力,必须提高其侵彻深度。
To enhance the damage capability of the concrete-piercing shell, the penetration depth must be raised.
介绍了截卵形弹头钻地弹对混凝土靶的侵彻试验研究结果。
The paper discusses experimental results of launching truncated-ogive-nose earth penetrating weapon into concrete targets.
进行了钨合金空心弹体垂直侵彻钢靶板和混凝土靶板的实验。
Normal penetration of tungsten alloy hollow projectiles into steel and concrete targets were performed.
利用火炮发射动能弹,对钢筋混凝土靶进行正侵彻和斜侵彻试验。
We conduced penetration experiments into reinforced concrete targets with ogive-nose kinetic energy projectiles.
长管体的侵彻能力小于同长度同质量同密度的长杆体的侵彻能力。
The performance of the long tube is proved to be worse than that of the long rod with the same mass, length and density.
侵彻时的应力状态与压入法测硬度相似,靶内应力状态为三向压应力。
The penetration process is similar to Vickers hardness test, it is triaxial compressive stress condition in the target.
侵彻按准定常过程进行计算,同时考虑了靶板强度及射流断裂的影响。
Penetration is calculated in accordance with quasi-steady process, and the effects of target strength and break-up of jets are also considered.
装药长径比对杆式射流速度有一定影响,但对水下侵彻能力影响不大。
Some influence of the ratio of length to diameter of SCESHL on the velocities of jetting penetrator were observed but appeared mildly on the penetration depth into water.
估算了侵彻时靶体强度,侵彻时花岗岩强度高出其单轴抗压强度好几倍;
The dynamic strength of granite target is estimated, which is many times larger than the unconfined compressive strength.
最后用数值计算和数值模拟的方法对射流的形成及侵彻过程做了初步的尝试。
At last, the methods of numerical computation and numerical simulation were used to make an attempt on the shaped charges formation and penetration.
综合考虑经济性和工艺性,优选的抗侵彻材料是钢丝网增强活性粉末混凝土。
By taking economical availability and processing property into account, the optimized material for anti-penetration is reactive-pow der-concrete reinforced with steel wire net.
在实验研究的基础上,利用有限元方法模拟分析了弹头侵彻靶板的物理过程。
Based on the experiments, the process penetrating the target plate was simulated by using the method of finite element.
根据相似准则建立弹坑比例半径同弹体侵彻深度和弹体装药参数的函数关系。
The function relations of the crater scaling-radius with projectile penetrating-depths and projectile charge parameters are established according to the similarity theory.
特定组成成分的陶瓷复合装甲只对一定速度范围内的侵彻体有较好的防御效果。
The specific kind of composite targets can only have good defence effect for the long rod penetrators with certain velocity.
采用能量守恒原理估算了侵彻过程中平均减速度,与数值模拟结果一致性良好;
The rigid-body average deceleration is estimated using the law of conversation of energy, and it is in good agreement with numerical results.
所获得的相对侵彻增量与靶板倾角、着靶速度的定量关系式,具有工程应用价值。
The formula acquired from experiment, indicated the relationship with penetration increment, oblique angle of target and impact velocity, can be applied in engineering.
提供了一套线性聚能装药侵彻深度计算公式及线性聚能切割器设计参数计算方法。
A series of formulae on penetration depth of linear shaped charge and the calculation method on design coefficient of linear shaped cutter are provided.
提出利用C-G公式估算侵彻深度的实用计算方法,并且得到了很好的试验验证。
Using C-G expression engineering method to calculate the penetrating depth of fragment, which is proved to be effective.
利用长杆侵彻弹对几种含密排刚玉球层的钢纤维混凝土靶体进行了抗侵彻试验研究。
The anti-penetration characteristics of several kinds of steel fiber reinforced concrete (SFRC) with tightly arrayed corundum spheres to long rod projectile have been experimentally studied.
利用粒子群的优化算法,建立侵彻子母弹最佳抛撒高度的求解模型,并进行了仿真计算。
By using Particle Swarm Optimization (PSO), a model was built up for calculating the optimum dispersion height of intrusive submunition dispenser, and mathematical simulation was carried out.
本文在理论上探讨了射流在侵彻或钻孔过程中,孔径和射流在孔底的堆积厚度之间的关系。
In this paper the relation between the hole diameter and the pile thickness of the jet on the hole bottom for a jet penetrating or drilling process is theoretically examined.
抗侵彻模拟试验表明,与常规的钢筋砼比较,夹钢球钢纤维砼抗侵彻能力有了很大的提高。
This paper presents a general idea of anti penetration simulation of SFRCSI. It is proved that the anti penetration performance of this new material is much better than that of normal RC.
文中根据能量守恒原理及侵彻孔径公式,推导了获得圆柱形穿孔的射流直径与速度的关系。
The law conversation of energy and the hole diameter formula of jet perforating are employed to deduce the relationship of diameter and velocity of jet for cylindrical hole of perforation concrete.
文中根据能量守恒原理及侵彻孔径公式,推导了获得圆柱形穿孔的射流直径与速度的关系。
The law conversation of energy and the hole diameter formula of jet perforating are employed to deduce the relationship of diameter and velocity of jet for cylindrical hole of perforation concrete.
应用推荐