In the case of ideal operational amplifier, circuit analysis was simplified by the ideal summing point restraints of zero voltage and zero current at the inverting input.
对于理想的运算放大器而言，通过倒相输入处零电压和零电流的理想求和点限制，可以简化电路分析过程。
Through electrostatics and examples of low-frequency alternating current and direct-current circuit, the problem of zero potential point is queried and clarified.
通过静电学、低频交流、直流等电路实例，质疑了电势零点问题，并对此进行了澄清。
The intelligent instruments dynamic display circuit and program with moving decimal point and blanking invalid zero were discussed in this paper.
介绍动态显示电路和能够移动小数点、熄灭无效零的显示程序。
So it is the key to choice the sensor. The characteristics of sensor is tested. This paper adjusts the physical zero point between rack and sensor. The circuit of signal adjusting is design.
本文针对该传感器进行了特性测试，并通过实验研究确定了喷油泵内齿条与传感器位置的物理零点，最后对传感器的信号调理电路进行了设计。
The principle and software of the auto zero point adjustment circuit in VS tiltmeter are described.
介绍垂直摆倾斜仪自动调零的电路、原理和软件。当摆偏离零位越出记录范围时，仪器将不能正常进行记录。
Near the critical point of the RLC-circuit, the residual voltage waveform changes form non-oscillating attenuation mode to distinct across zero oscillating mode when the peak current increases.
在RLC回路临界点附近，随着冲击电流峰值的增大，残压波波尾从非振荡衰减过渡到大幅度的过零振荡；
Near the critical point of the RLC-circuit, the residual voltage waveform changes form non-oscillating attenuation mode to distinct across zero oscillating mode when the peak current increases.
在RLC回路临界点附近，随着冲击电流峰值的增大，残压波波尾从非振荡衰减过渡到大幅度的过零振荡；
应用推荐