Theoretical calculations show that the polarization dispersion reaches zero at a specific amplitude of the soliton.
理论结果表明,在特殊的孤立波振幅下,偏振色散为零。
Where a trough and crest coincide we get the total amplitude zero.
在波峰与波谷重合之处,总振幅实际上为零。
The absolute zero angle can be defined at the biggest fringe amplitude point, so this method can also achieve absolute angle measurement.
干涉条纹幅度最大点处确定为绝对零角度位置,因此该方法可以实现角度的绝对测量。
The results show that the phase error of the vector measurement is zero, and amplitude errors can be eliminated, and high measurement accuracy can be obtained by using low bit D/A converter.
结果表明,相位测量的理论误差为零,幅度测量的理论误差可用修正系数消除,且使用较低位数的D A转换器,可得到高准确度的结果。
The frequency, amplitude, zero-point of signal generated by generator can be adjust continuously.
信号发生器所产生的波形的频率、幅值、零点均为连续可调。
The amplitude of this pulsatile change in arterial volume would be maximal when the transmural pressure was near zero.
这动脉体积的脉动性变化振幅会在跨壁压力接近零的时候达到最大。
This paper mainly describes the amplitude and phase errors caused by zero-order holder and the error caused by finite word length of D/A, and computer simulation test of D/A error is also introuced.
针对零阶保持器引起的幅度误差和相位误差,以及D/A转换器有限字长引起的误差进行了较为详细的分析,并进行了D/A误差仿真试验。
This paper also proposed a new fault locating method based on either the active component increment or the amplitude increment of zero-sequence current.
提出了零序电流有功增量和零序电流幅值增量作为判据的故障点定位方法。
A method for extracting both effective reflection events and zero-offset trace signals is developed using the lateral coherence and the property that signal amplitude changes with offset.
本文利用信号的横向相关性和信号振幅随炮检距变化的特征,提出一种既能提取有效反射信号同相轴,又能提取零炮检距道信号的方法。
Among the methods for estimating the minimum phase wavelet from its amplitude spectrum, methods of Hilbert-transform, of homomorphy, of zero-phase wavelet and of relaxation-iteration are analysed.
根据子波振幅谱估算最小相位子波已有多种方法,本文对用希尔伯特变换法、同态法、零相位子波法、松弛迭代法等估算的最小相位子波,进行了详细的分析。
The involved parameters are short-time amplitude and energy, lst-and2nd-order zero-crossing rate, autocorrelation function and pitch period.
所使用的参数是:信号的短时幅度与能量、一阶和二阶过零率、自相关函数及基音周期等。
The involved parameters are short-time amplitude and energy, lst-and2nd-order zero-crossing rate, autocorrelation function and pitch period.
所使用的参数是:信号的短时幅度与能量、一阶和二阶过零率、自相关函数及基音周期等。
应用推荐