Surfaces to be welded or thermally cut shall be cleaned of all foreign material such as grease, oil, dirt, scale, slag and paint that would be detrimental to either the weld or base material.
需焊接或热切割的表面应排除所有可能会损坏焊材或母材的杂物，如脂、油、灰尘、水垢、熔渣和油漆等。
The welding of high pressure boiler longitudinal weld shall be electric slag welding which may be replaced by improved auto-submerged arc welding when have no electric slag welding.
高压锅炉锅筒纵缝焊接时，采用的焊接设备为电渣焊。在不具备电渣焊的情况下用改进的埋弧自动焊成功的替代了电渣焊。
Relation between slag contribution and weld penetration is studied by adding aluminum powder into AF305 to change this distribution.
向AF305活性剂中添加铝粉改变焊渣分布，研究焊渣分布与熔深的关系，证实了焊渣成片分布能增加焊接熔深。
The weld defects of incomplete fusion and burn through always occur when the electro-slag welding is used between the outside thin metal plate and the inner clapboard in a box-section member.
箱形截面构件薄壁板与内隔板电渣焊接时，易产生壁板烧穿和焊缝未熔合现象。
Reducing content of hydrogen effect of fluoride, carbonate, active chide and rare earth oxide in weld by self-shielded flux-cored wire with CaF2-TiO2 MgO slag system is investigated.
探讨氟化物、大理石、高价氧化物和稀土氧化物在氟钙钛渣系自保护药芯焊丝中的降氢机理。
The positioning welding stainless steel pipe shall be smooth transition arc and weld end, can not be too high, must ensure good fusion, produce unweld, slag and other defects in case.
不锈钢管件的定位焊起弧和结尾处应圆滑过渡，焊道不能太高，必须保证熔合良好，以防产生未焊透、夹渣等缺陷。
The positioning welding stainless steel pipe shall be smooth transition arc and weld end, can not be too high, must ensure good fusion, produce unweld, slag and other defects in case.
不锈钢管件的定位焊起弧和结尾处应圆滑过渡，焊道不能太高，必须保证熔合良好，以防产生未焊透、夹渣等缺陷。
应用推荐