The waveforms of the collector current and collector-emitter voltage are also determined under the optimum operation condition.
在最佳工作条件下，给出了集电极电流和集电极——发射极电压波形。
Features: Low collector-emitter saturation voltage, fast switching speed.
特点：饱和压降低，开关速度快。
When choosing a value for R6, ensure that Q2's base-emitter voltage is less than approximately 0.5V at the maximum permissible value of the load current.
选择R6的阻值时要确保在负载电流的最高允许值的条件下，Q2的基极-发射极电压大约低于0.5V。
Figure 2-1 (a) shows the physical representation of the BJT in its common-emitter orientation, and also shows typical voltage polarities and magnitudes for the case of a silicon device.
图2 - 1 (a)给出了共发射极取向的晶体管的物理特性，同时也给出了硅器件的电压极性和大小。
Consequently, no load current flows through R6 because Q2, whose base-emitter voltage is now 0v, has turned off.
由于Q2的基极-发射极的电压为0 V而截止，因此没有负载电流流过r6。
In the event of an overload when ILOAD exceeds its maximum permissible value, the increase in voltage across R6 results in sufficient base-emitter voltage to turn on Q2.
当iload超过最大允许值时发生过载情况，R6上的电压增大导致基极-发射极电压足够大到导通Q2。
The temperature is higher, the change of input current I_F according to the same change in value of the base-emitter voltage V_ (BE) is smaller.
温度越高，发射结正向压降v _ (BE)变化相同数值所对应的输入电流i_f的变化越小。
In this design, the collector-to-emitter voltage is sensed to determine the directions of the output currents for the 4-step commutation strategy.
该文检测器件集射极电压确定输出电流方向，并据此实现四步换流。
In this design, the collector-to-emitter voltage is sensed to determine the directions of the output currents for the 4-step commutation strategy.
该文检测器件集射极电压确定输出电流方向，并据此实现四步换流。
应用推荐