These electron holes transit through the selenium based on the potential of the bias voltage charge.
这些电洞过境硒的基础上的偏置电压充电的潜力。
Charge and current, and magnetic flux and voltage, are connected through their definitions.
电荷和电流，磁通量和电压，根据它们的解释关联在一起。
Similarly, in an ultracapacitor, when voltage is applied across the two metal plates (i.e. during charging), a charge still builds on the two electrodes—one positive, one negative.
同样，在超级电容中，当两块金属片被施以电压（即充电）后，电荷建立于两极，一极为正，一极为负。
And the charges in the plates are what causes the electric field between the plates. That is how you can get the relation between voltage and charge in these guys.
板材上的电荷，生成了薄片间的电场，这就是得到电势与电荷之间关系的方法。
Photons of light striking an array of capacitors create an electrical charge proportional to their intensity, which the charge-coupler transforms into voltage.
光子撞击电容器阵列，产生与其强度成正比的电荷，而电荷耦合器又将它转换成电压。
When a voltage is applied, positive charge builds up on one electrode and negative charge on the other, creating an attractive force that squeezes the polymer.
加载电压时，正负电荷分别在两个电极上聚集，生成一股挤压聚合物的引力。
Finally, employing the equivalent electricity quantity approach, the steady state output voltage expression of charge pump is derived.
紧接着采用等效电量关系法详细地推导了电荷泵的稳态输出电压表达式。
After a capacitor is disconnected from a discharge circuit, a residual charge remains on the capacitor, so a voltage is re-established across the capacitor terminals.
电容器从放电电路断开以后，电容器中保持剩余的电荷，从而在电容器的端子之间重新建立起电压。
So far, we have discussed considerations specific to voltage, current, resistance, and charge measurements.
至此，我们已经讨论了专门针对电压、电流、电阻和电荷测量所要考虑的问题。
The longer the voltage is applied, the lower the measured current becomes because the material continues to charge exponentially.
由于材料按指数形式不断充电，所以施加电压的时间越长，测量出的电流就变得越低。
The instrument is used in the charge (or coulombs) mode and its internal voltage source provides the step voltage.
使用仪器的电荷(库仑)模式，其内部电压源提供步进电压。
After the reading has been recorded, reset the voltage source to 0v to dissipate the charge from the device.
记录完读数以后，将电压源复位到0V，使器件的电荷泄放掉。
The polarity of impulse voltage and the polarity of insulator surface electric charge can affect the corona initial time of insulator, the change time - interval and the corona current.
外拖冲击电压的极性与绝缘子表面电荷极性是否相同会影响绝缘子的电晕起始时刻、由流注向先导的转变时间间隔和流注电晕电流。
And even more interesting is the voltage meter and ammeter become free Charge by-product.
而且更妙的是电压表和电流表成了免费的副产品。
Piezoelectric or stored charge effects: the creation of charge unbalances (and thus current flow or voltage shift) due to mechanical stress.
压电或储存电荷效应：由于机械应力产生的电荷不平衡(从而产生了电流或电压偏置)。
The experimental results show this way can be used to charge high voltage and high capacity capacitors quickly.
实验结果表明：这种方式能够实现高电压、大容量电容器组的快速充电。
This provides nine voltage combinations to ensure the fastest, most complete charge without damaging gel cell or AGM batteries.
这提供了九个电压组合，以确保最快，最完整的凝胶不损害电池的充电电池或股东大会。
In the design of column readout stage, master and slaver structure has been adapted, where master amplifier converts charge to voltage, and slave amplifier works with standby mode to drive output bus.
列读出级采用新型主从两级放大列读出结构，其中主放大器完成电荷到电压的转换，从放大器驱动输出总线来满足一定的读出速度。
The new structure features high breakdown voltage, low on-resistance , and charge balance in the drift region.
结果表明这种结构具有高的击穿电压、低的导通电阻和漂移区中电荷平衡的特点。
The discharge breakdown time, peak current as a function of charge voltage and buffer gas are obtained.
得到了放电击穿时间、放电峰值电流随充电电压、不同气体介质变化的曲线；
If the discharge current was increased, the discharge capacity was obviously less than the stabilized value and maximum charge voltage was also changed suddenly.
若放电电流增加，在随后的第一周充放电过程中最高充电电压迅速增加、放电容量显著小于稳定值。
A research on the effects of amplitude, polarity and the stressed duration of the applied voltage on the surface charge accumulation is carried out.
研究了外施直流电压极性、幅值、作用时间和外界气象条件对表面电荷积聚的影响。
When in the external feedback mode, the electrometer will display the voltage across the feedback element. The unknown charge can be calculated from the following formula.
在外部反馈模式下，静电计显示反馈元件上的电压。未知电荷可以由下式计算。
Two charge ways are commonly taken in charge circuit, charge with constant voltage and charge with constant current.
一般的充电回路采用的充电方式有两种：恒压充电和恒流充电。
Unlike a voltage measurement, a charge measurement can be a destructive measurement. In other words, the process of making the measurement may remove the charge stored in the device under test.
与电压测量不同，电荷测量可能是破坏性测量，换言之，进行测量的过程可能会消除被测器件中储存的电荷。
Just before the voltage source is turned on, disable the meter's zero check and suppress the charge reading by using the REL function to zero the display.
在电压源即将打开之前，关闭仪器的零点检查功能并使用REL功能抑制电荷读数，使显示为零。
Just before the voltage source is turned on, disable the meter's zero check and suppress the charge reading by using the REL function to zero the display.
在电压源即将打开之前，关闭仪器的零点检查功能并使用REL功能抑制电荷读数，使显示为零。
应用推荐