A method for solving the gas particle viscous flow equations is presented.
提出了一种解气体-颗粒粘性流动方程组的方法。
These meshes are beneficial to the solution for the problem of viscous flow in turbomachinery.
这些网格的优点在于有利于求解涡轮机中的粘性流。
However, knowledge of the 3d viscous flow in this kind of impeller flow passage is quite limited.
然而,人们对其流道内三维粘性流动的认识却非常有限。
Elastic deformation occurs at stress below the yield stress, the viscous flow appears after yield with thixotropy.
验证了在剪切应力低于屈服应力时,变形基本上是弹性的,而屈服后粘流过程显示了触变特性。
This paper represents a CFD method for the design of NLF airfoils directly under transonic viscous flow conditions.
本文介绍一种设计跨声速自然层流翼型的计算流体力学(CFD)方法。
First, a 2-d unsteady viscous flow in a vibrating cascade is investigated under flow-structure uncoupled conditions.
本文首先研究气固非耦合条件下的振动叶栅内二维非定常粘性流动。
The viscous flow between the wing-tip and the wall is simulated by solving the RANS equations of incompressible fluid.
本研究以隐式差分方法求解不可压RANS方程,对二维地效应翼的性能及周围流场进行数值模拟。
The characteristics of the flow over a backward facing step are studied by use of a 3 D viscous flow mathematical model.
利用三维粘性流动数学模型,研究了台阶突扩流动的三维特性。
It is shown that the rapid viscous flow deformation, forming, welding can be carried out in the supercooled liquid region.
结果表明,在过冷液相区内能够进行快速粘滞流动变形、粘滞成型和粘滞连接;
The internal flow field of a single-stage axial compressor is analyzed using a fast full 3-D viscous flow calculating method.
采用一种快速求解三维粘性流场的计算方法求解轴流压气机的内部流场及全工况特性。
Its apparent viscous flow activation energy is higher so the influence of temperature on characteristics of melt is stronger.
由于其表观粘流活化能较大,故熔体特性受温度影响较大。
The stream function-vorticity method has been used to simulate two-dimensional transient state of incompressible viscous flow.
采用流函数-涡量法对粘性不可压缩流体的二维瞬态流动进行模拟计算。
The firing of enamel frit is a process of "Liquid-phase Sintering". Its mass transfer is based on the viscous flow of the melt.
搪瓷釉的烧成过程是一种“液相烧结”过程,其传质有赖于熔体的粘性流动。
The detail of the flow field around the body is obtained by simulating the viscous flow field using the commercial software CFX.
采用商业软件CFX对船体所处的粘性流场进行数值模拟,从而得到三体船周围的详细的流场细节和流动特征。
This article presents a two-step optimization based on a surrogate model for the aerodynamic shape optimization in a viscous flow.
提出了基于代理模型的两步优化方法,用于翼型在黏性流场中气动外形的优化设计。
The numerical solution of incompressible viscous flow over an aerofoil is obtained by H-type grids and a special difference scheme.
本文用H型网格和特殊的差分格式数值求解了粘性不可压缩叶型绕流。
The viscous flow around M6 wing and F4 wing-body configuration are simulated and compared with the results of wind tunnel experiment.
为了验证方法和程序的正确性,论文中对M6机翼和F4翼身组合体的流场进行了数值模拟,并与试验结果进行了对比。
Their excellent properties of heat transfer and scale resistance were suitable to the heat exchange requirements of high viscous flow.
其良好的传热及抗结垢性能适合于高粘度流体的换热要求。
Tip clearance flow in a radial inflow turbine rotor blade under stage environment was investigated by 3-dimensional viscous flow simulation.
对微型燃机向心透平叶轮顶部间隙流动在级环境下进行了全三维粘性数值模拟。
Numerical research of the three dimensional viscous flow field in diffuser with small flow rate stage of centrifugal compressor is carried out.
对一离心压缩机小流量级扩压器内部的三维粘性流场进行了数值研究。
The present paper computed the viscous flow of S_1 flow surfaces in some transonic turbine vane cascade by using the computational software FLUENT.
使用FLUENT软件对某型跨音速涡轮叶栅的导叶进行了S_1流面的粘性流动计算。
The behavior of uranium metal in rolling mills was considered as a viscous flow. Then the differential equation for rolling pressure was established.
把轧制中的金属运动看作粘性流动,建立了轧制压力微分方程;
The cause of usual molding fault in the course of injection forming, such as the short shot, the viscous flow and the sedimentation tache, was analyzed.
对注射成型过程中常见的成型缺陷(如短射、滞流和沉降斑)的形成原因进行了分析。
A new restoring analytic numerical method based on application of the method of restoring nucleus is developed for solution of viscous flow field in turbine.
应用再生核方法求解叶轮机粘性流场是一种新颖的解析数值方法,它可以解决计算中的存贮、计算速度和精度问题。
The rheological study indicates that Nylon 1212 melt shows a non ?Newton and pseudoplastic fluid and the viscous flow activation energy has also been obtained.
通过流变行为的研究,证明了尼龙1212熔体为假塑性非牛顿型流体,并求得了其粘流活化能。
The viscous flow active energy is different because of different morphology of fillers, and the system filled with small size filler has a low viscous flow active energy.
由于三种填料具有不同的微观形态,其对体系粘流活化能的影响是不同的,其中细颗粒填料填充的体系有较低的粘流活化能。
To decrease the effect of compression wave, the numerical simulation of a three-dimensional viscous flow induced by a high-speed train entering tunnels with a shaft was made.
为了降低噪声的影响,对高速列车穿越带有竖井的隧道时产生的压缩波进行了三维粘性流场数值模拟。
The inviscid and viscous flow physics around a high lift configuration and the complexity of its flow phenomena and the difficulty of its description are analyzed and discussed.
分析和讨论了高升力系统外形无黏和黏性流动的物理特征,表明了流动现象的复杂性和求解的艰难性。
Thus instead of Boltzmann equation this model equation may be approximately used to discuss the motion of gases in the transient region between molecular flow and viscous flow Iimits.
因此可以近似地用此模型方程序代替玻氏方程序讨论介于分子流和粘性流之间的过渡区的气体运动情况。
In this paper, the influence of tip leakage flow on the 3-d viscous flow field is investigated for different blade tip gap shapes under the condition of rotating hub or stationary hub.
本文针对几种不同形态的叶栅顶部间隙,在环壁转动与静止的不同情况下,研究间隙内的泄漏流动对三维粘性流场的影响。
应用推荐