Specify a Virtual LAN port for the partition.
为分区指定一个虚拟LAN端口。
Make sure it USES Virtual LAN ID 1 (see Figure 20).
确保它使用“Virtual LAN ID”值1(请参见图20)。
Ensure that the host partition is configured to use the Virtual LAN.
确保宿主分区被配置为使用虚拟lan。
Remember that the Linux partition lives on a virtual LAN that you configured earlier.
记住，Linux分区位于您前面配置的虚拟LAN中。
Packets will be automatically forwarded to the logical partition through the virtual LAN.
数据包将通过虚拟LAN被自动转发到逻辑分区。
You should also set up a third virtual Ethernet adapter on each VIO Server using the virtual LAN ID of the trunk adapter.
您还应该在每个VIO服务器上设置第三个虚拟以太网适配器，使用干线适配器的Virtual LANID。
Both of these trunk adapters must have the same Virtual LAN ID value, but it should have different trunk priority values.
这两个干线适配器必须具有相同的Virtual LANid值，但是它们的Trunkpriority值不同。
Just make sure the Virtual LAN ID field has the same value as the trunk adapters in the VIO Server configurations (see Figure 5).
只需要确保Virtual LANID字段与VIO服务器配置中的干线适配器具有相同的值(请参见图5)。
Like the first virtual adapter, these two adapters must have the same virtual LAN ID, but the value assigned to this field must be unique to these two adapters (see Figure 3).
与第一个虚拟适配器一样，这两个适配器必须具有相同的Virtual LANID，但是两个适配器的这一字段所指定的值应该是唯一的(请参见图3)。
If virtual LAN (VLAN) trunking is available, where multiple network subnets can be accessed simultaneously through the same physical adapter, this method does not use that benefit.
如果可以使用虚拟LAN (VLAN)中继，就可以通过同一个物理适配器同时访问多个子网，但是这种方法无法享有这一好处。
Likewise, if all communication at the physical layer was lost, HA would continue to think the network was OK, as it is still able to route traffic across the virtual LAN on the Hypervisor.
同样，如果物理层的所有通信中断了，HA仍然会认为网络是正常的，因为它仍然能够通过Hypervisor上的虚拟lan路由通信流。
To do that, configure a new IP address for the host and have it forward all traffic to and from this address to the private address of your Linux partition that is hooked on the Virtual LAN 0.
要做到这样，需要为主机配置一个新的IP地址，并让它将出入该地址的所有流量都转发到您的连接在Virtual LAN 0上的Linux分区的私有地址。
To do that, configure a new IP address for the host and have it forward all traffic to and from this address to the private address of your Linux partition that is hooked on the Virtual LAN 0.
要做到这样，需要为主机配置一个新的IP地址，并让它将出入该地址的所有流量都转发到您的连接在Virtual LAN 0上的Linux分区的私有地址。
应用推荐