A vertical bending fatigue experiment for a certain model of automotive front axle is reported in this paper.
阐述了某汽车前轴的垂直弯曲疲劳试验。
The result of this test shows that this structure is similar to a vertical bending cantilever beam component.
试验结果表明，该结构近似于一个悬臂梁弯曲受力构件。
Recent results from Handan, China show that the total oxygen content in a thin slab using EMBR is comparable with that of a conventional vertical bending slab without EMBR.
中国邯钢最新的结果显示，使用电磁制动后薄板坯总的含氧量可以同常规直弯式板坯媲美。
When the optimal inductance and resistance of the piezoelectric shunting circuit are obtained, the peak of the first order vertical bending vibration peak can be reduced obviously.
压电分流电路的电感值与电阻值取最优值时，可明显降低车体一阶弯曲振动峰值。
The results indicate that the vertical bending moment of girders, especially the girders of middle span, are influenced more obviously by coherence effect than by local site effect.
研究结果表明：相干效应对主梁纵向弯矩影响比较大，尤其是中跨部位；而局部场地效应相对影响较小。
The results of the tests reveal that the effect of the vertical bending transverse to the bridge under the action of vertical loading is greater than that longitudinal to the bridge.
试验结果表明：结构在竖向荷载作用下横桥向竖向弯曲效应大于纵桥向竖向弯曲效应；
The methods for calculation of additional vertical bending moment and confining bending moment of flanges are deducted, and the type and quantity of radial reinforcements are proposed.
为此，导出了竖向附加弯矩和法兰盘约束弯矩的计算方法，提出了径向联系筋的形式及数量。
According to the principle of minimum potential energy, the governing differential equations and boundary conditions are established for T-beams with wide flanges under vertical bending.
根据最小势能原理，建立宽翼缘t梁竖向弯曲的控制微分方程及边界条件。
It is shown that, when the effect of warping on rotation Angle is neglected, tension (or compression) is only coupled with horizontal bending and vertical bending instead of constrained torsion.
所得到的刚度矩阵表明，只有当忽略翘曲变形对截面转角的影响时，轴向拉压才只与水平弯曲及竖向弯曲相耦合，而与约束扭转不再耦合。
Experimental results show that the total Vertical Bending Moment can be divided into one low frequent component due to wave loads and one high frequent component due to whipping loads.
试验数据分析表明，合成弯矩可以分成由波浪载荷引起的低频成分以及由砰击载荷引起的高频成分。
Experimental results show that the total Vertical Bending Moment can be divided into one low frequent component due to wave loads and one high frequent component due to whipping loads.
试验数据分析表明，合成弯矩可以分成由波浪载荷引起的低频成分以及由砰击载荷引起的高频成分。
应用推荐