This paper introduces a numerical analysis of semi-conductor devices by using the finite-element method combining with the coupled approach and the design of a corresponding modelling program.
本文采用有限元分析与耦合法相结合的方法对半导体器件进行数值分析，设计了相应的模拟程序；
Using the finite element method software ANSYS, the stator temperature field of the hydroelectric generator is analyzed and calculated, the corresponding temperature field picture is given.
在此基础上应用有限元法的通用软件ANSYS，对大型水轮发电机定子温度场进行分析与计算，绘制了相应温度场图。
The effects of matching materials on the brake temperature of braker were investigated by using the finite element method to simulate the temperature transient process of disc brake.
采用有限元法模拟盘式制动器制动过程瞬态温度场，研究了材料匹配性对制动器温度场的影响。
In this paper, the theoretical model of cross-flow of grain cleaning fan on farm is proposed by using the finite element method.
本文应用有限元方法，建立了横流式农用清选风机内部的气体流动数值模拟模型。
It was universal to study ship's longitudinal strength by using the finite element-method.
目前国内外普遍运用有限元方法研究船体的总纵强度。
According to the measured results, a reasonable boundary condition can be set up and then the field distribution can be calculated by using the finite element method.
按测量结果，确定了一个合理的边界条件，用有限元法模拟计算了沿轴场分布。
Computation and analysis of the cylinder block stress and deformation are conducted on a 6125q diesel engine in supercharged or cylinder diameter enlarged situation by using the finite element method.
本文应用有限元法，对6125Q型柴油机机体在增压和扩缸时的变形和应力进行了计算分析。
Using the finite element method to analyze the mixing chamber, the temperature distribution as well as the change situation.
利用有限元法对混炼过程中密炼室、胶料的温度分布以及变化情况进行了分析。
Symmetrical folding of a single layer and folding process of an overfold are analyzed by using the finite element method.
本文采用有限元方法，分析单层对称褶皱作用和一个天然倒转褶皱的变形过程。
The predicted transmission loss of perforated tube silencers using the finite element method and experimental results are compared and showed good agreement.
使用有限元法计算穿孔管消声器的传递损失，并与实验测量结果进行了比较，二者吻合良好。
The Maxwell stress between magnet and keeper was integral analyzed using the finite element method, and the attractive force between magnetic attachments was obtained.
通过有限元法积分作用于闭路磁体与衔铁之间的麦克斯韦应力，算得磁性附着体的固位力。
Based on cutting and vibrating theories, the dynamic behavior of micro drill is studied by using the finite element method.
基于切削和振动理论，利用有限元技术对微细钻头振动钻入动力学特性进行了深入地研究。
By using the Finite Element Method (FEM), the nonlinear thermal vibration characteristics of composite laminated plates under linear temperature field were investigated.
采用有限元方法研究复合材料层合板结构在线性温度场作用下非线性热振动特性。
The torsional stiffness of a large turbogenerator rotor body and the factors influencing the stiffness are studied systematically in by using the finite element method.
本文利用有限元数值计算方法，系统研究了发电机转子本体部分的扭转刚度及其主要的影响因素。
Using the finite element method, a mathematical model of temperature field for weld-repaired zone of white cast iron is constructed, and temperature field and heat cycle are analyzed.
应用有限元方法建立了白口铸铁焊接接头焊补温度场的数学模型，对白口铸铁焊补温度场和热循环进行了分析。
The authors, using the finite element method, analyse the rules of continuous deep beam internal forces under the influence of the support plate width.
作者以有限元法分析了连续深梁的内力受支座垫板宽度影响的变化规律；
The two dimensional fluid Reynolds equations were established using the finite element method. The pressure distribution, opening force and upstream pumping rate of spiral groove were obtained.
用有限元数值计算的方法得出了一定条件下螺旋槽上游泵送机械密封端面间液体的压力分布、开启力及上游泵送量等。
Using the finite element method, the dynamic buckling of a bar with finite initial imperfection under axial impact is analyzed in this paper.
本文用有限元方法分析了一定初缺陷杆受轴向冲击的弹塑性动态屈曲。
A typical problem of a jointed rock slope has been analyzed and factors of safety against collapse have been computed using the Finite Element Method.
文中用有限元法分析了一个节理岩石边坡的典型问题，并计算出其抗破坏的安全因子。
A modal analysis using the finite element method is carried out for a crankshaft workpiece system. Six lowest order modal 'parameters have been obtained.
本文用有限元方法对曲轴工件系统进行了模态分析，求出了前六阶模态参数。
The resistivity, formation factor, and resistivity index of rocks were calculated using the finite element method (FEM) and we studied the effect of rock wettability on electrical properties.
利用有限元方法计算了岩石电阻率，进而得到岩石地层因素和电阻率指数，并考查了岩石润湿性对岩石电阻率指数的影响。
The experimental results were used to calculate material properties, using the finite element method combined with optimization techniques.
该方法根据实测的客观物理量集成运用有限元方法和优化技术来测算材料的弹性参数。
Using the Finite Element Method (FEM) and dislocation theory, we simulated the asymmetric earthquake displacement field of a vertical strike-slip fault caused by laterally inhomogeneous medium.
结合位错理论和有限单元法，对介质横向不均匀性引起的直立走滑断裂地震水平位移场不对称性进行了数值模拟研究。
In this paper, using the finite element method, we discuss the two-grid methods for two simplified models.
本文针对二维三温辐射热传导方程的两种简化模型的有限元方程，讨论了两层网格方法。
In this paper, we give an analysis for friction-free interference fit bolt using the finite element method.
本文采用有限元素方法在螺纹面无摩擦力的条件下对过盈配合的螺栓、螺母进行了分析计算。
A computer model for the mechanical response of steel bridge deck surfacing under wheel loading is established by using the finite element method.
采用有限元方法建立在车载作用下钢桥面铺装层的力学响应计算模型。
By using the finite element method, the dynamic stress caused by vertical contact impact between bolt locking surface and barrel extension locking surface of a new rifle was studied.
采用有限元方法研究了某新型自动步枪枪机闭锁面与节套闭锁面间垂直接触碰撞的动应力。
By using the finite element method, the dynamic stress caused by vertical contact impact between bolt locking surface and barrel extension locking surface of a new rifle was studied.
采用有限元方法研究了某新型自动步枪枪机闭锁面与节套闭锁面间垂直接触碰撞的动应力。
应用推荐