ST16C554 works in FIFO mode, receives and transmits data by (interrupt) mode with a 16 byte hardware transmit buffer, that will also greatly cut down the load on the CPU.
ST16C 554工作在FIFO模式，采用中断方式收发数据，并有16字节的硬件接收发送缓冲区，降低了CPU的开销。
The SPU (a) queues a DMA PUT to transmit the contents of buffer #1 and then (b) queues a DMA GETB to execute after the PUT to refill the buffer with the next portion of data from main memory.
SPU (a) 对DMAPUT 进行排队来传输一号缓冲区的内容，然后 (b) 对 DMAGETB 进行排队，从而在 PUT之后用主内存中的下一部分数据重新填充这个缓冲区。
tcp_receivespace —In addition to controlling the amount of buffer space to be consumed by receive buffers, AIX 7 also uses this value to determine the size to make its transmit window.
tcp_receivespace —除了控制接收缓冲区所消耗的缓冲区空间总量之外，AIX7还使用这个值来确定其传输窗口的大小。
Rather than waste good processor cycles waiting around for data to transmit, your code can instead have a second buffer waiting to process.
不要浪费宝贵的处理器周期来等待数据传输。
The SPU queues a DMA PUT to transmit the buffer back to main memory.
SPU对DMA PUT进行排队，从而将缓冲区传输回主内存。
As we know Serialization is the process of saving an object in a storage medium (such as a file, or a memory buffer) or to transmit it over a network connection in binary form.
我们知道序列化的过程将对象保存在一个存储介质(如一个文件或内存缓冲区)或传输二进制形式通过网络连接。
Gets or sets the size of the buffer used to transmit a chunk of the serialized message on the wire from the client or service.
获取或设置一个值，该值指示通过面向连接的传输对消息进行缓冲还是流处理。
The transmit agent acts as a buffer when the mobile node goes handoffs and reduces the overheads as same as the number of the hosts along the changing road which need to change.
在移动主机切换链路的时候，中转代理起到缓存的作用，可以减少所需要更改的路径的节点数量，同时减少切换开销。
An on-chip LO buffer to drive the transmit up converter further reduces system complexity.
片内LO缓冲器用来驱动发送上变频器，进一步降低了系统的复杂性。
An on-chip LO buffer to drive the transmit up converter further reduces system complexity.
片内LO缓冲器用来驱动发送上变频器，进一步降低了系统的复杂性。
应用推荐