Then, the mathematical expression of heat flow density on the tool-chip interface of the rake face is deduced on the basis of milling temperature experiment.
结合铣削温度试验，推导出了前刀面刀—屑接触面输入的热流密度的函数表达式。
Theoretical analyses show that the cutting fluid can difficultly soak into the tool-chip interface within extremely short separating time though there is some action in the UVC process.
理论分析表明，在超声振动切削中，切液削有一定作用，但不可能在极短的分离时间内浸入刀—屑界面。
Distribution of stress, strain and milling temperature showed that stress is localized in the primary shear zone, while the maximum strain and temperature rise occurs along the tool-chip interface.
应力，应变和铣削温度分布表明，压力是定位在主剪切带，而最大应变和温度升高时沿的刀具芯片接口。
This was due to the increase in the contact area at the tool-chip and tool-work interface due to the presence of flank and crater wear.
这是由于增加了接触面的工具，芯片和工具的工作界面因侧翼和火山口的磨损。
Smaller chip sizes are more desired because such chips simplify the machining operation and facilitate more effective heat removal from the tool work piece interface than larger chips.
较小的切屑尺寸比较大的切屑更被期望，因为这样的切屑使机械加工操作简化而且有利于从刀具工件接触面的更有效的热量排出。
Merchant thought that minute asperities existed at the chip-tool interface and the fluid was drawn into the interface by the capillary action of the interlocking network of these surface asperities.
Merchant认为：在切屑与刀具接触界面上存在微小的粗粒，切削液通过这些表面的微小粗粒组成连锁的网络的毛细管被吸入到切屑与刀具的接触界面上。
Merchant thought that minute asperities existed at the chip-tool interface and the fluid was drawn into the interface by the capillary action of the interlocking network of these surface asperities.
Merchant认为：在切屑与刀具接触界面上存在微小的粗粒，切削液通过这些表面的微小粗粒组成连锁的网络的毛细管被吸入到切屑与刀具的接触界面上。
应用推荐