Objective: to investigate the safety and superiority of blood drawing through an indwelling vein needle on in oral glucose tolerance test.
目的：观察静脉留置针采血应用在口服葡萄糖耐量试验中的安全性和优越性。
Cover mounting core locations exceeded the drawing tolerance and must be corrected. See attachments for details.
上盖底盘的核心位置超过了图纸允许的公差，必须要纠正，请看附件的细节。
Drawing the mechanical engineering drawing usually need to mark the dimension tolerance of the parts.
绘制机械工程图经常要标注零件的尺寸公差。
According to relevant product requirements, mold choice and mold tolerance configuration during the cold-drawing are mainly solved.
试验中根据产品要求，重点解决了冷加工模具选用、公差配置等技术问题。
Introduced design of the adjustable blanking-drawing compound for the drawing with flange, the drawing die could adjust the flange size, and satisfied the part tolerance requirement.
介绍了带凸缘拉伸件可调式落料拉伸复合模设计，实现对凸缘直径尺寸可以进行调整以实现一定公差要求的模具结构。
At least 3 years of product design experience such as Good Drawing Office practices, Tolerance Analysis, design For Assembly, Failure Mode and Effect Analysis (FMEA).
至少3年的产品设计经验，如良好的绘图方法，公差分析，装配设计，失效模式与效应分析(FMEA)。
Size check condition: Use the measure ruler based on the product drawing for check, and need note that the tolerance make by operator.
尺寸检测条件：依据图纸，使用计量卡尺，注意检测人为误差。
Size check condition: Use the measure ruler based on the product drawing for check, and need note that the tolerance make by operator.
尺寸检测条件：依据图纸，使用计量卡尺，注意检测人为误差。
应用推荐