If I hadn't put you back in that oven for the second time, you wouldn't be kept for very long because the hardness would not have held.
如果我没有再次把你放进烤箱，你也不会被保存很长时间，因为硬度会消失。
The hardening case depth and hardness curve can be changed by adjusting heating time, heating power and cooling speed during induction hardening.
在感应淬火中，通过改变加热时间、加热功率和冷却速度可以改变淬硬层深度和硬度梯度。
At the same time, some of the same or higher hardness material, such as diamond, corundum, metal oxide, quartz crystals are likely to damage the material.
同时一些硬度相同或更高的物质，例如钻石、刚玉、氧化金属、石英水晶都有可能损坏这些材料。
In castings, hardness can be achieved at ambient conditions if the part remains at rest for a period of time.
铸件，硬度，才能实现在环境条件下进行，如果部分仍然是休息一段时间。
It is more bright, has low hardness, low temperature of synthesis and requires less time in synthesis when compared with products synthesized by high temperature solid-phase reactions.
与高温固相反应法比，该方法具有合成温度低，反应时间短，所得产物硬度小，发光亮度好等优点。
The hardness of the alloy following the change of time was analyzed by micro- hardness instrument and the alloy's hardness curve following the change of time was drawn.
用显微硬度仪测定合金的硬度，分析其硬度随氧化时间变化的情况，绘制该钢的显微硬度随时间变化的曲线。
The experimental results show that the depositing power and time have a certain effect on the depth and hardness of the deposited layer.
研究结果表明，电火花沉积功率和沉积时间对电火花沉积层的厚度和硬度有一定的影响；
With prolonged or shortened pulse electrical current sintering time, the density, hardness and bend toughness of the sintered materials decreased.
进一步延长或缩短脉冲电流烧结时间，烧结体的密度、硬度和弯曲强度反而下降。
Influencing of curing time on film hardness is discussed through modifying the ratio of paint and curing agent. The defects from spraying process and the countermeasures are narrated.
通过调整漆与固化剂比例，讨论了固化时间对漆膜硬度的影响，同时论述了喷涂过程中产生的缺陷和采取的措施。
With the increasing of ageing temperature, time is shortened reaching hardness peak.
随着温度的升高，达到硬度峰值所需的时间越短。
Effects of basic coating performance of stain resistance were studied in the light of drying time, hardness and surface tension of the coatings.
从涂料干燥时间、硬度和表面张力出发，研究了这些基本性能对涂料耐沾污性的影响。
The effects of the aging temperature and holding time on the microstructure and hardness of the ultra-low-carbon steel bearing copper were investigated.
研究了时效温度和保温时间对时效硬化型超低碳含铜钢的显微组织和硬度的影响。
The hardness of the silica column increased with the increase of aging time.
延长陈化时间，硅胶整体柱的硬度随之增大。
The effects of solid-solution temperature and holding time on the grain growth and hardness of GH4169 superalloy were investigated.
研究了热处理温度和保温时间对GH4169合金晶粒长大规律和硬度的影响。
The effects of different silane end-capped ratios and HTPB content on mechanical properties, hardness and surface dry time of the sealant were discussed.
探讨了烷氧基硅烷封端率及端羟基聚丁二烯的含量对单组分密封胶的力学性能、硬度及表干时间的影响。
The main factors that influence tablet hardness and disintegration time are wetting agent ethanol, agglutinating agent polyvinylpyrrolidone(PVP) and tablet pressure.
确定了制片压力、润湿剂无水乙醇和粘合剂聚乙烯吡咯烷酮为影响崩解时间和片剂硬度的主要影响因素。
While water is applied, vacuum degree and pressure release time both affect greatly on pellet hardness; vacuum degree exhibits remarkable influence on the spraying uniformity.
在喷涂水溶液时，真空度、泻压时间对颗粒硬度均有较大的影响真空度对喷涂均匀度有显著影响。
The concept of "softening rate at sustained load" was suggested in accordance with the fact that the the hardness at high temperature decreases with the increase in holding time.
根据高温硬度随保载时间延长而变小这一事实，提出了“保载软化率”的概念。
Tribological tests reveal that the friction coefficients of the nitrided samples are greatly reduced, and the surface hardness is remarkably improved at the same time.
摩擦学测试表明渗氮样品不仅摩擦系数大大降低了，而且表面硬度也获得了显著提高。
The hardness increased, but the density, transverse rupture strength and compressive strength decreased when prolonging the holding time.
随着球磨时间的延长，烧结合金的硬度升高，密度、横向断裂强度和压缩强度均下降。
The effects of milling time and sintering temperature on density, hardness, transverse rupture strength and compressive strength were mainly studied.
重点研究了球磨时间和烧结温度对烧结合金的密度、硬度、横向断裂强度和压缩强度的影响。
High elasticity is the premise of low hardness for top roller, it can improve instantaneous dynamic circularity, extend the time of the elasticity fatigue resistance, improve yarn forming quality.
胶辊低硬度必须以高弹性为前提，才能提高胶辊瞬时动态圆整度，延长抗弹性疲劳时限，达到稳定、提高纺纱质量的目的。
For the lower hardness of the surface, use slurry abrasive with wax-coated particles can reduce the polishing time and improve the accuracy of the surface polishing.
对于较低硬度的工件表面，采用蜡敷磨粒的磨料液可缩短抛光时间和提高抛光的表面精度。
The effect of rare-earth elements, RE content, temperature and time on the penetrated depth, surface hardness and its distribution was investigated.
研究了稀土及稀土加入量、共渗温度、共渗时间对共渗层厚度、表面硬度及其分布的影响。
Higher nitrogen potential may promote formation of white layer, increase hardness and wear resistance but at the same time increase brittleness of nitriding case.
提高氮势可促使白层形成，提高渗层硬度和耐磨性，但使其脆性增高。
The candy made this way showed the characteristics of long chewing time, good elasticity and hardness. In addition, it gave the feeling of chewing gum, yef could also be digested completely.
采用该法研制的新型糖果，咀嚼时间长，口感类似胶姆糖，有较好的粘弹性和硬度，可被人体完全消化代谢。
All my friends want to increase access to safe hardness and methods to extend the time, so the internal market, the emergence of a large number of drugs and drugs for external use.
所有朋友都希望获得安全的增加硬度和延长时间的方法，所以市场涌现大批的内服药物和外用药物。
The effect of preheating treatment process of cold rolls on induction heat quenched structures and the effect of heating temperature and time on structure and hardness have been studied.
研究了轧辊的预备热处理工艺对感应加热淬火组织的影响，感应加热温度和时间对组织和硬度的影响。
This article investigated the effect of setting time, the temperature of soaking water, soaking time on fresh noodle hardness, firmness, and extensibility.
研究了面条静置时间、 冷却浸泡水温度、冷却浸泡时间等因素对面条质构特性测定结果的影响。
This article investigated the effect of setting time, the temperature of soaking water, soaking time on fresh noodle hardness, firmness, and extensibility.
研究了面条静置时间、 冷却浸泡水温度、冷却浸泡时间等因素对面条质构特性测定结果的影响。
应用推荐