The frequency of THG thrust force was analyzed.
分析了推力的频谱，发现推力存在着较大的波动。
However, the calculating precision of imbalance thrust force method is needed to discuss.
然而不平衡推力法的计算精度却有待进一步的探讨。
From the model, the effects of the dip Angle and feed rate on thrust force are estimated.
在此基础上，分析比较了进给量、斜面倾角等参数对斜面钻孔初期受力的影响。
Moreover, a gear pair with curvilinear - tooth traces operates without axial thrust force.
除此之外，具有曲线型齿线之齿轮在运转时亦不会产生轴向的推力。
Direct thrust force control method for the linear motor in theory and experiment has been further studied.
对适合直线电机直接推力控制的方法进行理论分析和实验研究。
A comparative study of the thrust force at initial stages of drilling on inclined surfaces was conducted through experiments.
本研究通过实验，比较了斜面上钻孔与平面上钻孔在加工初期切削力的差异，对斜面上钻孔加工初期的受力进行了理论分析。
In general, the piezoelectric linear motor is defined by no load velocity, the maximum thrust force, efficiency and other parameters.
一般用空载速度、最大推进力、效率及其他一些参数来表征压电线性马达。
The work principle and the motion order of the pneumatic loop of total drill was explained based on the example of thrust force air cylinder.
本文给出了该机的原理和整体结构，介绍了钻孔模块部分。并以推力气缸为例，详细说明了整机气动回路的工作原理及其动作顺序。
When the water with the same water-flow flows, water running thrust force suffered by the mobile type magnet sensor with two propeller blades can be increased.
当同样的水流量流过时，具有两片螺旋桨片的活动磁铁传感器受到的水流推力会增加。
Compared to single piston cylinder, it features fast action and flexibility, specially used when large thrust force or tensile force is required within short time.
介绍了双活塞液压缸的研制及应用，与单活塞液压缸相比，它具有动作快速、灵活等优点，特别适合在需要快速提供强大推力或拉力的场合。
Particularly with Taper Roller Bearings sufficient support of bearing rings by the adjacent parts is required due to the generated internal thrust force components.
尤其是圆锥滚子轴承的轴承环的邻近部位足够的支持是必需的，由于所产生的内部推力组件。
To avoid the generation of the noise, the design method of balanced Lorentz force gradient coils is studied and the gradient coils with cacelled net thrust force are designed.
为了解决这一问题，本文研究了减少噪声的力平衡梯度线圈的设计方法，并完成了洛伦兹力近似为零的线圈设计。
Single row angular contact ball bearings in a tandem arrangement are used when the actual thrust force exceeds the thrust load capacity of a single angular contact ball bearing.
单列角接触球轴承在串联布置时所使用的实际推力超过一个单一的角接触球轴承推力负荷能力。
Imbalance thrust force method (ITFM) is originally developed approach for slope stability analysis in China, which has been widely used in the field of landslide stability analysis.
不平衡推力法是我国独创的边坡稳定分析方法，在滑坡稳定分析和治理中得到广泛地应用。
The inertia friction welding process is a non-linear process because of the interaction between temperature field and material properties as well as friction force and thrust force.
焊接过程中的温度、材料热物性、摩擦力和顶锻压力的相互作用使焊接过程高度非线性。
The steel axle of this kind of pig can bend under greater thrust force, it is helpful to pass through elbow or the section of converting pipe, so it can avoid efficiently block accident.
该清管器的钢轴能在较大推力作用下发生弯曲变形，有利于通过弯头或变形管段，可有效避免堵卡事故的发生。
Imbalance Thrust Force method (ITFM) is an original method for slope stability analysis in China, which has been widely used in the field of slope stability analysis and slope stabilization.
不平衡推力法是我国独创的边坡稳定性分析方法，在滑坡的分析治理中得到了广泛应用，然而对其精度的分析却寥寥无几。
The couple of force created by rotor pole center suspending difference may not increase the pressure on the thrust pad.
转子磁场中心安装偏差所产生的轴向磁拉力很小，转子磁极中心挂装高程差所产生的不平衡力偶不致增大推力瓦受力。
According to the field distributions in no-load and load operations, the methods of calculating the thrust and vertical force in a single-sided PMLSM are presented.
根据计算得到的空载及负载的磁场分布，提出了计算单边永磁直线同步电动机产生的推力和垂直力的方法。
During normal construction process, the friction force between shield and soil exhibited greater influence on surface deformation compared with bulkhead additive thrust.
在正常施工时，盾壳与土体之间的摩擦力对地面变形的影响远大于正面附加推力。
It is a balance system that the anti-slide pile is exerted by three kinds of force, they are the tensile force of anchor, the thrust of sliding mass, the resistance of soil and rock.
一般认为锚杆（索）抗滑桩在锚杆（索）拉力、滑坡推力、桩前滑体抗力的作用下绕锚固点（锚拉力作用点）保持力矩平衡，锚固点为一铰支点。
The thrust of crowd cylinder on tunneler is the main design parameter to determine the number and dimension of crowd cylinder on tunneler and the basis to determine propelling force of tunneler work.
掘进机推进液压缸的推压力是确定掘进机推进液压缸缸数和液压缸大小的主要设计参数，也是确定掘进机工作中推进力大小的依据。
RADIAL FORCE : The load on a bearing perpendicular to the axle, this and the Thrust load are forces that affect the design and application of bearings.
径向力：与轴承的轴线所垂直的载荷；它和轴向力是影响轴承设计和应用的两个力。
Two kinds of the normal force of the linear servo motor are analyzed by using finite element analysis. The relations between thrust, normal force and air gap length are analyzed.
采用有限元分析的方法对直线伺服电机的两种法向力进行分析，分析了推力、法向力与气隙长度的关系。
Compared to the testing system of conventional rotatory motor, the one of 3-phase linear induction motor (LIM) is quite different with the measuring of thrust and normal force.
相比普通旋转电机，三相直线异步电机静态测试时推力和法向力的测定比较特殊。
It is the result of both the pulling force from positive factors in society environment and the thrust from negative factors in the organization.
文章认为，雇员离职是社会环境积极因素形成的拉力和组织中的消极因素形成的推力，共同作用于雇员的结果。
So, even though the swimmer is moving from right to left, his hand is moving from top to bottom and the lift force adds to the thrust (see figure).
那么，即便游泳者是从右往左移动，他的手也是从上往下移动，所以浮力就叠加到前推力上(见图)。
The utility model will generate no surcharge force along the motor axis line in the process of inflating which will not affect measurement results, thus enhances the thrust measurement accuracy.
本实用新型的供气管在充气过程中沿发动机轴线上不会有附加的作用力产生，因此不会影响测量结果，从而提高了推力测量精度。
The transverse thrust is the sideways force of the propeller as it rotates.
横向推力是螺旋桨的横向效力，因为它旋转。
The transverse thrust is the sideways force of the propeller as it rotates.
横向推力是螺旋桨的横向效力，因为它旋转。
应用推荐