Finite element mechanical model of moving crossbeam is set up for analyzing three dimension finite element intensity of this structure.
并建立了活动横梁的有限元力学模型,对该结构进行了三维有限元强度分析。
This paper developed a three dimension finite element model to analyze stress distribution on residual limb of crus under lumped loads with different displacement constraint conditions.
通过建立三维线性有限元模型来分析在集中载荷作用下小腿肢体残端的应力分布,且分析了不同边界条件对肢体残端应力分布的影响。
Based on the dynamic characteristics obtained with three dimension finite element method, the reduced mechanical model and parameters of lift ship structure can be modified and obtained.
利用三维有限元方法计算的结构动力特性和简化结构动力特性相等的原则修正升船结构简化力学模型,并确定了等效的升船机简化结构模型和系统参数。
Three dimension finite element method is used to calculate the stress state of the cantilever during each construction stage.
因此对桥悬臂施工过程进行了三维有限元计算,分析了各个施工阶段的应力状态。
Three-dimension finite element model is built according to the actual structural characteristic of suspension pipe bridge.
按照悬索式管桥的实际结构特点,建立了三维有限元模型。
Based on three-dimension finite element model, transient temperature field in nozzle was calculated.
基于三维有限元模型,计算了喷管的瞬时温度场。
At low flow attenuation performance of semi-active muffler was computed respectively by using theoretical formula and three-dimension finite element method.
低速气流时,分别进行了半主动消声器的消声性能理论计算和三维有限元法数值计算。
At low flow attenuation performance of semi-active muffler was computed respectively by using theoretical formula and three-dimension finite element method.
低速气流时,分别进行了半主动消声器的消声性能理论计算和三维有限元法数值计算。
应用推荐