The amount of refrigeration of G-M cryorefrigerator has been derived by using strict thermodynamic method.
本文用严格的热力方法推导了G-M机的制冷量。
On the basis of experiment, the forming mechanism of complex microalloyingcarbonitride has been discussed by using of thermodynamic method.
本文在实验的基础上，用热力学方法来分析讨论微合金碳氮化物复合相的形成机制。
A relation between the saturated vapor pressure and the heat of vaporization for pure liquids has been derived by statistical thermodynamic method.
本文用统计热力学方法导得了液体饱和蒸气压与蒸发热间的关系式。
The process simulation is performed for ethylene glycol plant by using the PROCESS simulation programme, and the unit operation model and the thermodynamic method are determined.
应用PROCESS模拟程序，对乙二醇装置进行了流程模拟计算，确定了单元操作模型及热力学方法，计算结果与国外设计数据相吻合。
The probability distribution of the fluctuation on electrical medium system is deduced by using the quasi-thermodynamic method. Explaining the analogism can't be used every where.
推导出了电介质系统准热力学方法的涨落概率分布，证明了类比的方法并不是任何地方都可以用的。
This paper is to get a clear understanding of chemical potential, and introduce the way to calculate the chemical potential of ideal gas with thermodynamic method and physical method.
本文主要在于厘清化学势的定义，阐明如何用热力学方法和统计物理方法计算理想气体化学势，并在此基础上进一步阐述了化学势的一些重要作用。
Thermodynamic analysis on this cycle is conducted, and the method of selecting the parameters of this cycle is presented.
对此循环作了热力分析，提出了循环参数选择的方法。
Based on the method of statistical thermodynamics of solutions, a statistical thermodynamic model of liquid mixtures is given.
应用溶液统计热力学方法和溶液理论，建立了多元液体混合物的统计热力学模型。
Thermodynamic analysis results show that tellurium can be leached by sulfuric acid leaching method from lead-rich tellurium slag.
热力学分析结果表明：可以采用酸浸方法从高铅碲渣中提取碲。
Thermodynamic calculation method can be used to determine the optimum water-fuel ratio of water ramjet so as to provide reference to design and test of water ramjet.
用热力计算方法可确定水冲压发动机最佳水燃比，进而指导水冲压发动机的设计和试验。
The method for using the two equations to calculate the thermodynamic characteristics of an LiBr absorption refrigeration cycle is introduced.
进而介绍了利用这两个方程在电子计算机上进行溴化锂吸收式制冷循环热力计算的方法。
Using square lattice model and an enumeration calculation method, the thermodynamic properties of two-dimensional proteins is investigated.
采用二维正方形格点模型，用完全计算法研究了蛋白质分子的热力学性质。
A method for predication of the formation range of ternary amorphous alloys has been proposed from the thermodynamic point of view.
基于非晶形成的热力学观点，提出一种定量预测三元合金非晶形成成分范围的方法。
Because of no experiments reported for the reaction in slit pores, the chemical equilibrium compositions in bulk phase from RCMC method are compared with those from classic thermodynamic prediction.
由于没有狭缝孔内该反应的实验数据，因此比较了用经典热力学预测与RCMC方法得到的主体相平衡组成。
The Carnot analysis method was proposed for the simplification of the thermodynamic analysis of the absorption cycle, by the comparison of the absorption cycle and the compression cycle.
为了简化吸收循环热力学分析方法，通过吸收循环和压缩式循环的对比，提出吸收循环卡诺模型分析方法。
The method is a numerical solution of multi-component chemical equilibrium flows with the elements distributing equations and thermodynamic calculation of chemical equilibrium.
首先引入了元素的分布方程，然后根据化学平衡的热力计算方法求解每一位置的组分及温度。
The heat transfer model of the discharge has been established, and the removal rate could be significant promoted because of the explosion with the method of thermodynamic finite element analysis.
建立了电火花放电加工的热力学传导模型，通过有限元仿真方法得出具有放电爆炸力的单次脉冲能够明显提高难加工材料蚀除量的结论。
It consists of four main modules right now...... general method module, thermodynamic model module, conversion interface module and recommendation module.
它主要由四个模块组成——通用算法模块，热力学模型模块，转换接口模块和算法推荐模块。
By using thermodynamic optimization, a method of thermodynamic evaluation on the process parameters and the plants, especially, on the ammonia absorption refrigeration (AAR), is presented.
本文提出了利用(？)力学优化对过程参数和流程进行热力学评价的方法，并用于氨吸收制冷流程。
This paper makes a systematic study of EOS and anharmonic thermodynamic properties for solid substance system at high temperatures-high pressures by using phenomenological method.
本文采用唯象的方法对高温高压下固态物质系统的EOS及相关的非简谐热力学性质(非谐性质)作出了系统地研究。
A nonlinear time dependent thermodynamic system status is analyzed with a fault detection and diagnostic method being carried out by a dynamic neuron network status observer.
采用动态神经元网络状态观测器的故障检测和诊断方法对非线性时变热力系统状态进行估计。
The new method of thermodynamic calculation (the contrast model method) for air-air crossflow wet heat exchanger with wet air condensing first at the entry is proposed in this paper.
本文对一开始就冷凝的叉流式空气-空气湿热交换器提出一种新的热力计算法，即对比模型法。
On the base of the original cyclical function method, a general heater model is presented and cyclical function method is improved considering actual operating characteristics of thermodynamic system.
在传统循环函数的基础之上，根据实际热力系统运行的特点，建立了通用加热器数学模型，并对循环函数法进行了改进。
A method of calculating hydraulic and thermodynamic parameters such as flow, ratio of water in oil, pressure, temperature, specific heat for oil, gas, water pipe net is presented.
文中给出了油、气、水管网系统的水力、热力参数，包括流量、含水率、压力、温度、比热等的计算方法。
For improving the versatility and extensibility of the boiler thermodynamic calculation system, a modelling method with object-oriented application frameworks was presented.
为了提高锅炉热力计算模型的通用性和系统的可维护性，提出面向对象应用框架的系统建模方法。
This paper studies the thermodynamic quasi-stationary and non-static processes from the Angle of methodology, and presents an efficient method for the thermodynamic processes.
文章对热力学准静态过程与非静态过程进行教学研究，并提出处理热力学过程有效和准确的方法。
According to the features of equivalent enthalpy-drop method applied to thermodynamic system, the methods of local quantitative calculation for cycle function method in regenerative system is deduced.
根据等效焓降法在热力系统计算时的特点，推导了循环函数法在回热系统中的局部定量计算方法，导出了回热系统局部定量计算的几个重要结论。
The calculating method of the thermodynamic properties of compressed wet air are analyzed in this paper.
对压缩空气干燥设备设计中的湿压缩空气热力性质的计算方法进行了分析。
The distillation method was applied to the separation of product and the whole process was simulated with the NRTL thermodynamic equation.
采用普通精馏方法分离反应产物，并以NRTL热力学方程为物性计算方法。
This article gives a brief account of the thermodynamic principle of dilution refrigerator through a method of using analogues.
本文用类比的方法概述了稀释致冷机的热力学原理；
应用推荐