Normally the shear velocity is about half of the compressional velocity.
一般地说横波速度大约是纵波速度的一半。
What they saw at the McKees Rocks, Pa., metal service center was a lot of repetitive, tedious, and sometimes strenuous operator movement around the shear.
他们在宾夕法尼亚州的McKeesRocks金属服务中心看到许多操作工人围着剪板机在进行重复、枯燥和费力的工作。
With a few quick snips of the shear, he pruned the bush.
他用大剪刀几下子就把灌木给修剪好了。
The study on development of the shear strength of soft clay is very significant for the use of vacuum preloading method.
软土抗剪强度增长规律性研究对真空预压法的推广应用具有重要意义。
This paper discusses the shear strength of reinforced concrete members subjected to combined axial forces, moment and shear.
本文讨论了钢筋混凝土构件在轴向力、弯矩和剪力共同作用下的抗剪强度。
Some proposals in the shear walls design.
剪力墙设计中的一些建议。
In borehole sonic logging, these may be the shear, flexural and Stoneley waves.
在井眼声波测井中,这些波是横波、弯曲波、斯通·利波。
The oscillation of the shear layer decreases with the increase of the plate length.
随着腔内平板长度的增加,剪切层振荡的程度有所减小。
Furthermore, the shear strength formula of concrete hollow brick masonry is proposed.
提出了混凝土空心砖砌体的抗剪强度计算公式。
Objective To compare the shear bond strength of light cured and chemically cured resin adhesive.
目的对光固化和化学固化树脂粘接剂的剪切强度进行对比研究。
This paper deals with the calculation of the shear strength of reinforced lightweight concrete beams.
本文就钢筋轻骨料混凝土梁的抗剪强度计算问题进行了论述。
For a partial explanation, let us take a look at the material, particularly the shear sensitivity of all resins.
为了部分说明这个问题,让我们看一眼材料,特别是树脂的剪切敏感性。
In this photo, the plug of a KIK cylinder has been drilled at the shear line, allowing the plug to freely rotate.
在图片中,一个KIK锁芯在切线处被钻孔,以便让锁芯自由的转动。
It is also shown that the influence of the rotary inertia of the mass block on the shear failure is not negligible.
质量块的转动惯量对于剪切失效具有不可忽略的影响。
Therefore, the compressive strength difference of lime-soils can only be evaluated based on the shear wave velocity.
因此,只有依据剪切波速才能评价各种条件下石灰改良土强度特性的差异。
Bonding temperature, bonding time and interlayer thickness have an obvious effect on the shear strength of the joints.
连接温度、连接时间和中间层厚度对接头抗剪强度具有较明显的影响。
The results showed that the shear strength of fractal joints decreases nonlinearly as the filling percentage increased.
结果表明,随着充填度的增大,分形节理抗剪强度总体上呈非线性减小。
The shear stress sharply rises at the ends of the piezoelectric as the shear modulus increasing or the thickness decreasing.
随着粘贴层的切变模量的增加或其厚度的减小,切应力在靠近压电致动器端部区域迅速增大。
The shear strength of the rockfill is of high nonlinearity, but the stress path almost does not influence the shear strength.
堆石料抗剪强度具有显著的非线性特征,而应力路径对其抗剪强度影响极小。
Static loading tests of 35 specimens were carried out to study the shear strength of concrete filled steel tube (CFST) columns.
为建立钢管混凝土柱的受剪承载力计算式,完成了35根试件的静力加载试验。
The deformation and stress condition of the micro-composite are studied according to the shear-lag theory and strain-hardening law.
按照剪切滞后理论和应变硬化规律,研究微复合材料的变形和应力状态。
The shear stress rises sharply at the ends of the piezoelectric actuator with the shear modulus increasing or the thickness decreasing.
随着粘贴层的剪切模量的增加或其厚度的减小,剪切力在靠近压电致动器端部区域迅速增大。
From the rotation strain and other evidences, the shear direction of the two ductile transcurrent shear zones are determined to be dextral.
根据旋转应变及其他标志,确定本矿区两条韧性平移剪切带的剪切动向为右行剪切。
Grid-experiments are performed to investigate metal flow and deformation in the shear-extrusion process of tubular components with branches.
通过网格试验研究分析了枝叉管形件剪-挤工艺过程的金属流动情况及其变形规律;
When the shear temperature was close to or higher than abnormal point, the viscoelastic parameters varied little with the shear temperature.
当剪切温度接近或超过反常点时,测量温度下的粘弹性参数基本不随剪切温度变化;
The method for calculating the shear carried by the concrete and the stirrup stress in beams with inclined cracks are suggested in the paper.
提出了有斜裂缝梁内的混凝土承受的剪力和箍筋应力的计算方法。
To increase the shear strength on lift joints of the high roller compacted concrete dam (RCCD), a kind of construction method is brought forward.
理论分析认为这一施工技术对提高碾压混凝土层缝的抗剪强度效果显著。
Due to the heterogeneity, rock failure mainly results from tensile damage but shear damage still exists, which has influence on the shear strength.
由于试样细观缺陷非均匀性的存在,导致岩石断裂主要由拉伸破坏引起,但拉剪混合破坏仍然存在,并对抗剪强度有较大的影响。
Due to the heterogeneity, rock failure mainly results from tensile damage but shear damage still exists, which has influence on the shear strength.
由于试样细观缺陷非均匀性的存在,导致岩石断裂主要由拉伸破坏引起,但拉剪混合破坏仍然存在,并对抗剪强度有较大的影响。
应用推荐