In this paper, we discuss Laplacian smoothing and modified methods, mean curvature flow, PDE method and the smoothing method based on directions.
在文中，分别讨论了拉普拉斯平滑及其改进算法、平均曲率流、PDE方法及基于方向的平滑算法。
When we measure the heat capacity of heat pump by enthalpy measuring method, we use flow rate measuring method to measure flow rate and sectional mean temperature of air.
利用空气焓值测量方法对热泵的制热量进行测量时，通常采用测流量法测量空气的流量和截面平均温度。
When we measure the air heat capacity of heat pump by enthalpy potential method, the flow rate measuring method was used to measure flow rate and sectional mean temperature of air.
利用空气焓差法进行热泵空气侧换热量测量时，通常采用测流量法测量风的流量和截面平均温度。
We present a smoothing algorithm based on the main direction combined with mean curvature flow and normal filter method.
本文主要提出了基于主方向的平滑算法，并结合平均曲率流算法和法向滤波算法进行了改进。
In the second part, this paper develops a method of calculation of the mean water deficit, and surplus of the annual flow regulation.
本文第二部分建议确定年调节水库不足与多用水量多年平均值的计算方法。
The mean acquisition time of the FSASE method is derived by the generating function flow graph technique for the fading channel.
文中采用生成函数流图法推导出了衰落信道下FSASE算法平均捕获时间的闭式解。
The paper presents a smoothing algorithm based on the main direction combined with the mean curvature flow and the normal filter method.
该文给出了基于主方向的平滑算法，并结合平均曲率流算法和法向滤波算法进行了改进。
This paper has proposed a method to estimate traffic density using the output(traffic flow and time mean speed) of fixed traffic detectors.
本文提出了一种利用定点检测器数据（流量和时间平均速度）来获取交通流密度的方法。
At the mean time, the new method of the calculation of the flyer plate motion, which only USES the P-M flow solution as the initial parameters, is given as the explosive products flying towards air.
同时提出爆轰产物向空气飞散时，计算飞板运动可以只采用P -M流动解作初始参数的新方法。
By comparing the statistical results of the mean flow and the turbulence fluctuation of the jet, we verify the accuracy of the numerical method.
通过对喷流平均流及湍流脉动统计结果的对比，确定数值方法的精确性。
Then the mean distance and the mean time of material flow were calculated by means of filling method, the influence of the filling angle of particle on the axial transport velocity was analyzed.
然后引进差补方法计算物料平均轴向位移和平均停留时间 ，并分析了物料充满角对轴向位移速度的影响。
The results show that the given method is efficient, with which the variation of flow parameters, such as mean veloc…
计算结果表明 ，本文方法是有效的 ，正确地反映了挑流冲刷过程中流场结构及速度、压力等参数的变化。
The results show that the given method is efficient, with which the variation of flow parameters, such as mean veloc…
计算结果表明 ，本文方法是有效的 ，正确地反映了挑流冲刷过程中流场结构及速度、压力等参数的变化。
应用推荐