The filter stage (340) may provide filtering for the input signal.
所述滤波级(340)可提供针对所述输入信号的滤波。
Is the input signal transmitter output voltage and current signals.
输入信号是变送器输出的电压，电流信号。
It is the input signal, the output is the line, angular displacement.
它输入的是电信号，输出的是线、角位移量。
The design of the audio input signal to the input signal amplification.
本设计当输入音频信号时，对输入的信号进行放大。
Which can be used for direct observation of the input signal voltage waveform.
它可以用于直接观察输入信号的电压波形。
The input signal is reconstructed with several random sampling series by multi-trigger.
等效采样系统通过对该信号多次触发，用多个等效采样序列重建输入信号。
Hysteresis compactor is the one whose threshold value can change with the input signal.
迟滞比较器是一种阈值能随着输入信号而变化的比较器。
Therefore, the SR is comparatively more sensitive to the frequency of the input signal.
因此，相对而言，随机共振对输入信号的频率更敏感一些。
The detail component and the approximation of the input signal are available alternately.
该系统实现了原信号的细节分量和近似分量的交替输出；
Therefore the identification results can not be influenced by the input signal time-delay.
这就使网络辩识结果不再受输入信号时延的影响。
The traditional solution is to compress the input signal through the limited voltage device.
传统的解决办法是通过压限器对输入信号进行压缩。
But for any system, if the input signal will be processed, the system stability is a prerequisite.
但任何系统要使其能对输入信号进行处理，都必须以系统稳定为先决条件。
If input sigmal is supwrimpsed with high-frequency noise use a low-pass filter in the input signal line.
若输入信号伴随高频干扰，应在线里用高频过滤器。
Unless it's corrected by "zeroing," the resulting offset produces an error by adding to the input signal.
如果不进行“调零”修正，所产生的偏置量就会叠加到输入信号上产生误差。
Before acting as the input signal of panel monitor, the analog signal must be processed by AD conversion.
这种模拟视频信号必须要经过AD转换后，才能成为平板显示器的输入信号。
The input signal is sampled on the falling edge of CS and the conversion is also initiated at this point.
输入信号在CS的下降沿进行采样，而转换同时在此处启动。
In experiment, the input signal was not saturated, so the amplification has the potential to be improved.
实验表明，信号光对放大增益的抽取非常重要，在此实验中信号光尚未饱和，放大功率仍有提高的余地。
When the frequency of the input signal is high enough, parallel processing or equivalent sampling is used.
当输入信号的频率足够高时，一般采用并行处理技术或等效采样技术。
It is important to note that the amount of compression is directly related to the level of the input signal.
涉及到大量的压缩直接关系到输入信号的电平是很重要的。
If the input signal level exceeds the programmable threshold, the coarse upper threshold indicator goes high.
如果输入信号电平超过可编程阈值，粗调阈值上限指示器就会变为高电平。
This paper introduces a hysteresis comparator whose output can be delayed when the input signal is in rising time.
本文提出了一种在输入信号上升延迟滞的比较器电路。
If the input signal is anywhere in the frequency range of the detector, the meter will make a valid power measurement.
只要输入信号落在检测器的频率范围内，则功率计就能给出准确的的功率。
The influence of the bias point and the input signal power on the subharmonic load pull is also analyzed in this paper.
并进一步分析了偏置条件和输入信号功率对副谐波牵引特性的影响。
The design can measure rapidly and avail the input signal format, and is satisfied to the scale system performance requirement.
该设计可以快速准确地测量输入信号格式，满足定标器稳定工作的需要。
By this method, we can design a data acquisition system in which an alternating pulse serves as the input signal with a microcomputer.
采用这一新的方法，可用计算机设计输入信号为交替脉冲的这一类数据采集系统。
Using a 1-bit internal ADC, the internal converter modulator in Figure 1 samples the input signal, producing a coarse, quantized output.
使用1位内部ADC，图1中内部转换调节器采集输入信号，产生粗量化的输出作为输入信号。
Dynamic measurements can be summed up as ascertaining the input signal with known output signal and known dynamic response of the measuring system.
动态测量可以归结为已知测量系统的输出和测量系统的动态响应特性，求测量系统的输入。
The output signal of the outer loop ACTS as the input signal of the inner loop. The inner loop engenders a synchronism drive signal to control current.
控制器由内环和外环两部分组成，外环的输出信号作为内环所需的输入信号，内环产生一个同步驱动信号，实现对电流的快速控制。
Only the frequency of the input signal locates in the low frequency region, can the signal be selected by a proper noise level to produce SR phenomenon.
输入信号的频率只有位于噪声能量集中的低频区域，才有可能使输入信号被适量的噪声选择而产生随机共振现象。
Only the frequency of the input signal locates in the low frequency region, can the signal be selected by a proper noise level to produce SR phenomenon.
输入信号的频率只有位于噪声能量集中的低频区域，才有可能使输入信号被适量的噪声选择而产生随机共振现象。
应用推荐