F1 tyres have an optimum operating temperature, and when they drop below that they rapidly lose grip, which dramatically slows lap times.
F1赛车的车胎对环境温度有要求，当温度低于底限时候轮胎就会失去抓地力，这会大大减慢圈速。
They work by absorbing extra thermal energy in the drink when it's too hot, and then releasing that stored energy back into the drink to keep it at an optimum temperature as it begins to cool down.
金属咖啡豆的工作原理是在饮品温度过高时吸收多余热量，并在饮品开始冷却时释放储存的热量。
Provides an optimum temperature for soldering PCB throughout reflowing operation.
通过回流焊操作为焊接pcb提供最佳温度。
Through the study on the added amount of NaOH, reaction time and temperature, the optimum production process conditions were determined.
通过对氢氧化钠的加入量、应时间、应温度等生产条件的研究，得出了最佳生产工艺条件。
The optimum buffer gas pressure for LIF emission increases with the temperature of the heat pipe oven.
使发射达到最大值的最佳缓冲气压随热管炉温度的增加而增加。
Points of knowledge: selection of single reactor and the most optimum operating temperature, selection of reactor type for the complex reaction.
知识要点：单一反应反应器的选型与最优操作温度的确定，复合反应反应器的选型。
By studying the several important control indicators of glass powder, such as crystallization, glass temperature, the optimum proportion of glass powder is made certain.
通过研究玻璃粉的几个重要控制指标如析晶、玻璃化温度，确定了玻璃粉的最佳配比。
The optimum sintering temperature, sintering time and proper heating-up rate were estimated in the meantime.
同时对最佳的烧成温度、烧成时间以及合理的升温速度作了预测。
Methods for obtaining Crystallized activation energy of glasses and the optimum temperature of the heat treatment are described. The problem concerning the application of DTA in glasses is discussed.
介绍了利用差热分析求取玻璃的析晶活化能、最佳的热处理温度的方法。讨论了差热分析在玻璃中的应用问题。
AIM To study the optimum temperature and time for hyperthermia of two different metastatic osteosarcoma cell lines in vitro.
目的探讨两株不同转移性成骨肉瘤细胞系的体外灭活最佳温度与时间。
The optimum middle annealing temperature depends on the chemical composition of the alloys.
而最佳中间退火温度受合金成分的影响。
The activation surface and the process of heating cleaning have also been analyzed systematically and the optimum temperature and time for surface cleaning have been determined in the paper.
本文还对激活表面及热清洁工艺进行了系统地分析，确定出了最佳的表面清洁温度及时间。
The control object is the optimum forming temperature and it is realized by controlling forming pressure.
优化目标为最佳成形温度，而温度的控制主要通过压力控制来实现。
The result shows that a optimum strip(SPCC steel) heating curve and a furnace temperature curve be gained.
结果获得了SPCC钢优化的带钢升温曲线和炉温曲线；
The effects of the ratio, time, temperature on the yield are investigated and the optimum conditions given.
研究了原料配比、反应时间、反应温度等对收率的影响，给出了最佳合成工艺条件。
The results showed that the austenite recrystallization occurs in a temperature range biger than thenormal quenching temperature and there is an optimum temperature range for the grain refining.
结果表明，奥氏体的再结晶发生在钢的正常淬火温度以上的一个温度范围，并在该范围内存在晶粒细化效果最佳的温度区域；
The influences of the temperature on passivation operation and production quality for ammonia synthesis catalyst after reduced are explored, and the optimum passivation temperature is found.
探索了氨合成催化剂还原后的温度对钝化操作与产品质量的影响，确定了最佳的钝化温度。
On the basis of factors analysis of structure, material emissivity, temperature distribution and surrounding temperature, the sensor's optimum parameters are obtained.
在分析传感器几何特性、材料发射率、温度分布和环境温度对有效发射率影响的基础上，给出了传感器结构的优化参数。
The research also indicates that the temperature resulting from the secondary defects may represent approximately the optimum temperature for the thermal color concentration.
研究证实，二次缺陷形成的初始温度，可近似代表辐照绿柱石的最佳热固色温度点。
I apply the minimum principle to the analysis of optimum temperature distribution on the basis of mathematic model for acetic acid cracking at high temperature.
依据醋酸高温裂化数学模型，应用最小值原理分析了裂化温度的最优分布。
Based on the investigation of die Angle, pressing route and pressing temperature, the optimum parameters were chosen in the experiments of equal channel angular pressing (ECAP).
在对等通道角挤压中模具通道夹角、挤压路线和挤压温度研究的基础上，确定了实验中的理想工艺。
In this paper, calcined coal gangue at different temperatures is studied systematically, so as to look for the optimum calcined temperature, and its activation mechanism is briefly discussed.
对不同温度煅烧的煤矸石进行了系统研究，以寻求煤矸石最大活性的煅烧温度，并对其活化机理进行了初步探讨。
The flow charts of optimum scheme for low temperature grain storage in three ecological areas were provided respectively in this paper.
同时给出了三个储粮生态区域低温储粮优化方案的工艺流程图。
With the increasing of cure temperature, the scorch time and optimum cure time decreased, but the crosslink density had a tread of decreasing.
硫化温度的提高会缩短焦烧时间和正硫化时间，但有使交联密度下降的趋势。
I really can't seem to find an optimum temperature or pour condition that will allow perfect casting.
我真的似乎无法找到一个最适温度，或倾诉的条件，这将使完美的铸造。
With the temperature dropping below the optimum, as its period prolonged, the normal metabolism in the rubber tree was changed.
随着温度的下降和持续时间的延长，椽胶树的正常代谢发生变化。
With the temperature dropping below the optimum, as its period prolonged, the normal metabolism in the rubber tree was changed.
随着温度的下降和持续时间的延长，椽胶树的正常代谢发生变化。
应用推荐