The section size of mass concrete is larger, the less likely to cause a load, but due to the temperature of deformation of mass concrete is extremely adverse.
大体积混凝土的截面尺寸较大，有荷载引起的可能性较小，但由于温度产生的变形对大体积混凝土却极为不利。
Deformation temperature and pass strain are the key factors controlling the cracking of the samples during deformation.
变形温度和应变量的精确控制是保证合金形变中不发生开裂的关键。
When the content of water and temperature in the layers changes, the layers expand and contract and the measure mark of deformation is also moved.
当地层中水和温度的量值变化时，地层便膨胀或收缩，依附于地层的形变测量标志也就随之而被移动。
The second kind of model is complete coupling one and this model includes the coupling temperature field equation, fluid coupling seepage model equation, rock coupling deformation equation.
第二类模型为完全耦合模型，包括耦合温度场方程、流体耦合渗流方程和岩石耦合变形方程。
Expansion joint: to meet the deformation of foundation, expansion and construction requirements play, prevent play a change in temperature in transverse crack produces.
伸缩缝：为适应地基变形，管身伸缩及施工要求，防止管身在温度变化时产生横向裂缝。
The results show that thermal compensation in non-irradiant areas could reduce the temperature gradient of mirror for high-power laser, and then could decrease the thermal deformation significantly.
结果表明有效的热补偿对镜面变形峰谷值有很大的影响，在非光照区进行热补偿可以大大降低镜体的温度梯度，从而明显减小镜面变形的峰谷值。
The measured strain of concrete includes the elastic strain, creep strain and also the non-stress strain like the concrete free deformation and temperature strain.
混凝土实测应变包含弹性应变、徐变应变及混凝土自由变形、温度应变等非应力应变。
In this paper, based on systematic test on different bitumen mixtures of gradation, the deformation behaviour of asphalt mixtures is analyzed under high temperature.
本文通过对不同级配形式的沥青混合料的系统试验研究，全面分析了沥青混合料高温变形特性。
This paper discusses the two indexes, dynamic stability and relative deformation, that evaluate the high temperature stability of the asphalt mixture by rutting test.
本文通过车辙试验讨论了衡量沥青砼热稳性的两个指标：动稳定度和相对变形。
The temperature field and thermal deformation of the piston and ring carrier was used as the boundary in the calculation of stress field.
计算时把温度场和热变形作为结构应力计算的边界，获取活塞镶圈在热负荷状态下的综合应力场。
The temperature properties of membrane deformation, water viscosity and surface tension in reverse osmosis system are analyzed.
分析了反渗透系统中膜体形变、水体粘度与表面张力等参数的温度特性。
Thermal deformation temperature and liner expansion coefficient of the composite were decreased.
该复合材料的热变形温度有所降低，但线膨胀系数减小。
With the decreases of deformation temperature and increases of deformation degree and deformation rate, the recrystallized grain size decreases and the recrystallization volume percent increases.
随着变形温度的降低、变形程度和变形速率的增大，再结晶晶粒尺寸减小，再结晶体积分数增大。
Results show that the additional temperature stress and deformation of the continuously welded turnout will increase with the increase of rail temperature.
结果表明：无缝道岔的附加温度力与变形随轨温变化幅度的增大而增加；
The temperature field of the bar in and out the deformation zone during continuous rolling is simulate by finite element method.
采用有限元法分析了棒材连续热轧中变形区及出变形区时轧件横断面温度场。
While studying the rolling influence of the course to rolling compounding of craft parameter, have probed into the rolling temperature and influence of deformation amount especially.
在研究轧制工艺参数对轧制复合过程的影响时，重点探讨了轧制温度以及变形量的影响。
Effects of SS400 steel's deformation temperature and strain rates on its deformation behavior was studied using single pass compressing test.
采用单道次压缩试验，研究了变形温度和变形速率对SS400钢热变形行为的影响。
The conventional calculation of thermal deformation of precision mechanism involves an exclusive consideration of the influence of temperature distribution on part deformation.
精密机械热变形计算中，通常只考虑温度在零件中的分布状况对零件变形所产生的影响。
The difficulties of calculation are to establish the temperature field of structure under the action of ambient temperature and to calculate the thermal stress and thermal deformation.
其计算难点是建筑结构在环境温度作用下的温度场的建立与对应的温度应力和温度变形的计算。
Based on the particularity of roll casting process, a practicable scheme is given for conveniently surveying the temperature field and thermal deformation of casting roller.
针对铸轧工艺的特殊性，拟定了一套方便可行的铸轧辊温度场及热变形测试方案。
In this paper, the influence of various deformation temperature, deformation degree and deformation velocity on structure and properties of superalloys in forging process was discussed.
本文讨论了在锻造过程中不同变形温度、变形程度、变形速度对高温合金组织和性能的影响。
Based on analyzing the eruption and tiny aggregate effect of fly ash, the influence of fly ash on the shrinkage fissure of concrete is studied, caused by the plastic deformation, dry or temperature.
以粉煤灰的火山灰效应、微集料效应分析为基础，分析研究了粉煤灰对混凝土塑性收缩、干缩、自缩和温度收缩裂缝的影响。
Temperature deformation and autogenous deformation are the two major forms of deformation of hardening concrete in early age.
温度变形和自生变形是硬化混凝土在初龄期两种最主要的变形。
The influences of deformation temperature, deformation rate and deformation degree on the flow stress and grain size are different. The deformation degree mainly influences the shape of flow curves.
结果表明：变形温度、变形速率和变形程度对流动应力和再结晶晶粒尺寸均有不同程度的影响。
The effect of deformation temperature and deformation speed on the limit drawing ratio (LDR) and microstructure of the roll-casting AZ31 magnesium alloy sheet.
研究了变形温度、变形速度对铸轧az31镁合金板的极限拉深比(ldr)和组织的影响。
The effect of deformation temperature and deformation speed on the limit drawing ratio (LDR) and microstructure of the roll-casting AZ31 magnesium alloy sheet.
研究了变形温度、变形速度对铸轧az31镁合金板的极限拉深比(ldr)和组织的影响。
应用推荐