This paper presents a method of flux compensation of saturated vapor. This method adopts parabola fitting the curve of temperature-density and deals with the data by MCS-51 single-chip computer.
提出一种采用二次抛物线来拟合温度—密度曲线进行饱和蒸汽的流量补偿的方法，并且用MCS-51单片机进行数据处理。
The Solar Probe Cup will scoop up bits of the sun’s corona and solar wind to continuously measure its speed, temperature and density.
太阳探测杯（The Solar Probe Cup）会收集一些日冕和太阳风去持续地测量速度、温度和密度等数据。
Any that sinks below the sunlit top layers will hang around in the depths for a long time, thanks to the colder temperature and greater density of the deep water.
由于深层水体的温度较低，密度较高，因此，沉降到透光层下的任何物质都会在那个深度停留很久。
"Our first paper shows connection between temperature, transpiration, and stomata density," Dilcher said in a Indiana University press release.
“我们的第一篇文章揭示了温度与蒸腾作用以及气孔密度之间的联系，”Dilcher在印第安纳大学通讯稿中谈到。
Stir or agitate the coating sample to assure uniform temperature and density.
搅动和摇动涂料样品以保证统一的温度和密度。
Density and viscosity were correlated to temperature.
将密度和粘度对温度进行关联。
The spatial distribution characteristics of plasma flow temperature, density, pressure velocity field and intrinsic relation of them were completely analyzed.
分析了等离子束射流温度、密度、压力和速度场的空间分布特点以及它们之间的内在联系。
Influences of the incident Angle for wave and plasma parameters such as temperature, density and location of resonance layer on wave traces and power deposition distribution were studied.
研究了等离子体温度、密度和共振层位置等参数及波的入射角对波迹和功率沉积分布的影响。
A set of formulas has been developed to calculate the atmospheric temperature, density, pressure, the speed of sound etc. of Standard Atmosphere 1976.
本文给出了计算1976标准大气表中温度、密度、压力、音速等诸参数的数学表达式。
The relationships between specific heat of PU rigid foam at low. temperature and such parameters as those of temperature, density and ageing time, etc., have been discussed.
讨论了聚氨酯硬泡沫塑料低温比热与密度、温度以及空气中存放时间等参数的关系。
That way, the output is unaffected by changes in fluid temperature, density and viscosity.
应用此种方法，输出将不受液体温度、密度和黏性所影响。
The spectral modulation sensor system can detect and measure various physical parameters such as pressure, temperature, gas density, and various chemical species.
这种光谱调制传感器系统能够测量多种物理参数，如压强、温度、气体密度及多种化学成份。
A superconductor's transition temperature and critical current density are two commonly measured parameters.
超导体的转变温度和临界电流密度是两个经常要测量的参数。
With a careful theoretical analysis various physical parameters such as the gas density, temperature, and pressure, and the ultraviolet and ionizing radiation fluxes can be derived .
通过仔细的理论分析，可以推导出如气体密度、温度和压力等各种物理参量，以及紫外辐射和电离辐射的流量。
The density of the component can also change during sintering, depending on the materials and the sintering temperature.
根据材料和烧结温度的不同，零件的密度在烧结过程中也会改变。
You can use this to experiment with some of the environmental factors that affect an aircraft in flight, including temperature, pressure, density, viscosity and gravity.
你可以运用这些设置来实验影响飞机飞行的环境因素，包括温度、压力、密度、粘滞度和重力。
An empirical formula describing the dependence of the power of hysteresis loss on frequency, magnetic flux density and temperature was derived.
得出磁滞损耗功率与频率、磁通密度及温度的经验公式。
The test conducted includes the temperature, salty, density, crystal structure, uniaxial compressive strength and flexural strength of sea ice.
试验内容包括海冰的温度、盐度、密度、晶体结构、单轴压缩强度和弯曲强度。
Experiments results show that hardware design and software development meet the requirements for measurement of electron temperature and density of laser induced plasma.
试验结果表明，硬件设计和软件系统的开发与集成满足了激光焊接光致等离子体电子温度和密度的测量要求。
Results: the excitation temperature and electron density decreased when the concentration of HCl and HAc increased.
结果：随着醋酸、盐酸浓度的增加，等离子体激发温度、电子密度随之降低。
Objective: To investigate the influence of excitation temperature and electron density in ICP for HCl and HAc solvents.
目的：探讨了醋酸、盐酸对电感耦合等离子体激发温度、电子密度的不同影响。
The influence of anode current density, polishing temperature, polishing time and stirring modes on polishing quality was discussed.
探讨了阳极电流密度、抛光温度、抛光时间和搅拌方式对抛光质量的影响。
Both the plasma density and the electron temperature increase as the coil current increases.
当线圈电流增大时，等离子体密度和电子温度都随着增大。
A method to determine the electron temperature and density from the time resolved spectra of hydrogen atoms left in a pulsed laser plasma is described.
本文讨论了一种利用残留在激光器中杂质氢原子的时间分辨光谱，来确定脉冲激光等离子体电子温度和电子密度的方法。
The calculated critical temperature, pressure and density are also in good agreement with data from molecular simulations.
临界点温度、压力和密度的计算值和分子模拟值也基本符合。
Compared to the middle Okinawa Trough, magmatic features hold lower temperature and density and higher pressure and viscosity in the northern Okinawa Trough.
海槽北段岩浆的物理性质与南段相比具有温度低、压力高、密度小、粘度高的特征。
This work indicates the necessity of using temperature dependent nucleon density in dealing with optical potentials at finite temperature.
通过和以前工作的比较，强调了采用温度有关核密度的必要性。
Electron temperature and electron density reach their saturation in several seconds and a few minutes, respectively.
电子温度和电子密度的变化分别在加热开始后几十秒和几分钟内达到饱和。
For explosion process of gas cloud in closed vessels, flow field parameters, such as pressure, velocity, density, temperature, concentration and so on, vary with time and space.
对于球形密闭容器内气云的爆炸过程，压力、速度、密度、温度、浓度等流场参数均随时间、空间而发生变化。
Effects of PTFE content in electrode, current density, temperature of electrolyte and electric quantity on pinacol yield was discussed.
探讨了复合电极中PTFE含量、阴极电流密度、电解液温度、电解电量对频那醇产率的影响。
应用推荐