The generator voltage is equal to the system voltage.
发电机电压等于系统电压。
The higher tower height and larger system voltage may be important factors.
杆塔较高和导线上工作电压幅值大，可能是较重要的因素。
Um- –The maximum value of "the highest system voltage "for which the equipment may be used.
设备可承受的“最高系统”电压的最大值。
The Stable and effective MMI is important base of the software of Power System Voltage Stability.
开发稳定、高效的人机系统是电压稳定性软件的重要组成部分，也是基础的部分。
Ignition must be on, Engine must NOT be running, you may connect a charger to keep the system voltage up.
点火开关必需打开，发动机不要打着，你可以连接充电器保持系统电量。
Finally, this paper gives some discussion to the methods of power system voltage stability dynamical analysis.
最后，本文对电压稳定动态方法进行了简要的评述。
Larger system voltage unbalance degree causes larger capacitor voltage pulsation and negative sequence current.
不对称度的增加将进一步增大电容电压的脉动和负序电流的大小。
Continuous power flow method is frequently employed when analyze electric power system voltage stability problems.
连续潮流方法是分析电力系统电压稳定问题的常用方法。
Series power quality controller (SPQC) can mitigate the voltage disturbances by superposing a voltage on the system voltage.
串联型电能质量控制器(SPQC)通过向系统电压中串联一个电压源来调节用户侧电压质量。
When distribution system voltage drops, dynamic voltage restorer (DVR) can maintain the sensitive load side voltage stability.
配电系统电压跌落时，动态电压调节器可以维持敏感性设备的电压稳定。
Both regulating characteristics of on-load tap changer (OLTC) and load characteristics greatly impact power system voltage stability.
有载分接开关(OLTC)的调节特性和负荷特性对电力系统电压稳定性具有极大的影响。
How fast will an increment of the excitation voltage reach 95% of the difference between ceiling voltage and the system voltage rating.
励磁电压增加到最高电压和系统额定电压之差的95%时要多少。
Voltage-controlled voltage level to maintain the system, improve system voltage stability has been an important part of a wide range of concerns.
电压控制作为维持系统电压水平、提高系统电压稳定性的重要环节得到广泛的关注。
The simulation results indicate that the strategy can maintain the system voltage and prevent the over-control and control oscillation among the multi-methods.
仿真结果表明，该方法能有效地维持系统电压水平，同时防止多控制手段间的超调和调节振荡等现象。
The method makes use of the nonlinear participation factors and consequently the effect of power system nonlinearity on system voltage stability can be considered.
提出以节点电压非线性参与因子作为依据，衡量负荷节点对电压稳定性的影响程度。
Abstract: : the substation is in power system voltage conversion, accept and electric power distribution, control and adjustment to the current voltage power facilities.
摘要：变电站是电力系统中转换电压、接受和分配电能、控制电流走向和调整电压的电力设施。
Selection of fuses must be carried out according to their use conditions, mainly they are system voltage, rated current, short circuit capacity, protection suitability etc.
熔断器选择必须依据其使用条件来进行，主要有系统电压、额定电流、短路容量、保护配合等。
Simulative results for typical systems demonstrate that the proposed strategy makes full use of voltage control capability in power system to improve system voltage stability.
基于典型系统的仿真结果表明，该方法能充分利用系统中的电压支撑能力，提高系统电压稳定性。
When the load is near to generators, the possibility of voltage collapse caused by system voltage oscillate and the power limit corresponding to saddle-node bifurcation will decrease.
负荷越靠近发电机，系统电压将越不易发生振荡失稳，但鞍结分岔对应的最大功率传输极限将减小。
It analyses the rail transit DC traction power supply system voltage type frame protect device and rail voltage limited device matching problems that solve their adjusting value and time.
分析了轨道交通直流牵引供电系统的直流设备电压型框架保护装置与轨道电位限制装置定值和时间配合存在的问题及解决办法。
During the design of under frequency load shedding (UFLS) schemes, some simple models for frequency dynamics analysis are obviously inadequate since they do not take system voltage into account.
进行系统低频减载方案设计时，简单的频率响应模型由于未考虑系统电压对频率过程的影响而导致不少情况下无法适用。
Through the single-dynamic load model dynamic reactive power compensation device can change the original system bifurcation point, increase the load limits and improve the system voltage stability.
通过对单机。动态负荷模型添加无功功率动态补偿装置，可以改变原系统的分岔点，增加了负荷极限，从而提高了系统电压稳定性。
This algorithm is used in IEEE-30 buses system and the result indicates that the optimization algorithm not only can decrease the power loss but also can improve the system voltage stability margin.
通过对IEEE 30节点系统计算并与其他算法比较，结果表明采用该优化规划的算法能有效地降低网损、提高系统电压稳定裕度。
In this paper, the regulating characteristic of the static VAR compensator (SVC) and its effects on reducing the system voltage fluctuation and improving the system stability have been investigated.
本文研究了静止无功补偿器的调节特性及其对减少系统电压浮动、改善系统稳定的效果。
This paper discusses a nonlinear design for TCR-FC Static Var Compensator (SVC) to improve power system voltage stability. A third order nonlinear dynamical model for the SVC system is the developed.
本文对由晶闸管控制电抗器（TCR）型装置与一个固定电容器组（FC）型装置组成的静止无功补偿系统（SVC）建立了一个三阶非线性动态模型。
Synchronous closing is an intelligent control technique. It can make the moving and stationery contact-header of circuit breaker to close on the specified phase angle of the power system voltage wave.
同步关合是指断路器动、静触头在系统电压波形的指定相角处关合，以减小合闸操作的过电流和过电压的一种智能操作技术。
Physical parameters range from the temperature of CPUs, utilization of memory and file system, interface utilization, and voltage reading, among other physical values.
物理参数包括CPU温度、内存与文件系统利用情况、接口利用、电压读数，以及其他物理值。
Devices called synchrophasors can sample voltage and current 30 times a second or faster-giving utilities and system operators a far more accurate view of the health of the grid.
而被称为“同步向量”的设备能以一秒30次或更快的速度采样电压和电流——向电力公司和系统操作员提供有关电网健康状况的信息更为精确。
Devices called synchrophasors can sample voltage and current 30 times a second or faster-giving utilities and system operators a far more accurate view of the health of the grid.
而被称为“同步向量”的设备能以一秒30次或更快的速度采样电压和电流——向电力公司和系统操作员提供有关电网健康状况的信息更为精确。
应用推荐