Inlet subcooling and system pressure are varied as parameters.
进口欠热度及系统压力作为变化参数。
Monitors exhaust system pressure by sending varying voltages to the onboard computer.
监测废气系统的压力，将各种电压值发送到机载计算机上。
Excess pressure unseats the poppet, allowing flow with minimal increase in system pressure.
多余压力从阀门排出，使得流体通过时系统增压最小。
As fluid is released the system pressure decreases until the spring force re-seats the poppet.
液体从系统中被排出时，系统压力降低，直到在弹簧压力作用下阀门回复原位。
After determining the maximum system pressure for a hydraulic system, hose selection can be made.
胶管的选择是根据液压系统设计的最高压力值来确定的。
A device incorporating an orifice that is used to control fluid flow rate or downstream system pressure.
包括一个喷嘴的装置。它用于控制流体的流量或下游系统的压力。
The second step, check the cooling water system and cooling system pressure is to meet the requirements.
第二步，检查冷水系统和冷却系统的压差是否达到要求。
The system pressure changed the adsorption abilities and pore size distributions of carbide and activated carbon.
反应压力能够改变炭化产物和活化产物的吸附性能和孔径分布。
High-pressure pump type shielding shell is a pressure vessel, so that pump can withstand the high system pressure.
高压型屏蔽泵的外壳是一个高压容器，使泵能承受很高的系统压力。
During the reaction process, the beginning of water spraying can cause the system pressure to increase temporarily.
水合物的制备过程中，喷雾的启动会引起系统内部压力有短暂的升高。
This can reduce the purchase cost, the more important is to be able to reduce the system pressure drop and air loss.
这样能降低购买成本，更重要的是能减小系统压降及空气损耗。
The effect of catalyst composition, microwave irradiation time and system pressure on the reaction was investigated.
考察了催化剂组成、微波辐照时间和体系压力对反应的影响。
When the system pressure exceeds the design pressure, anti-exploding slice would break itself, which can prevent exploding.
当系统压力超过设计压力时，防爆片自行破裂，防止系统发生爆炸。
Prior to installation of the tank in the system the tank must be pre-charged to the system pressure as determined in Step 2.
在把膨胀罐安装在系统里之前，膨胀罐必须预先充气加压使之达到步骤2所测定的系统压力。
Effects of system pressure, activation condition and other process parameters on the properties of activated carbon were studied.
讨论了体系压力、活化条件等过程参数对活性炭性能的影响。
Returning the lever to its normal position releases the tension on the rod permitting the valve to maintain normal system pressure.
将手柄恢复到正常位置，则“压杆”上的压力就得到缓解，使得调节阀能够保持正常的系统压力。
Real water injection rate in water injection well will change when system pressure fluctuates or formation water absorption capacity changes.
注水井实际注水量随系统压力波动或地层吸水能力的变化而改变，这是针型阀或井下固定水嘴无法避免的缺陷。
The experimental results indicate that the system pressure balance is kept stabilization by the total resident material in the second dipleg.
实验结果表明：双级料腿循环流化床压力平衡主要依靠第二级循环料腿中物料的停留量来维持。
The effects of system parameters such as system pressure, mass flow rate, heat flux and inlet sub-cooling are significant on both DWO and PWO.
系统压力、质量流速、热负荷和进口过冷度等参数对不稳定性有显著的影响。
By the use of this system pressure profile, heat flux profile and enthalpy of the jet of arc heater have been measured by various transient probes.
利用该系统各种快速探针测出了电弧加热器射流的压力剖面、热流剖面和气流焓值。
So less water means lower pressure. It does this by opening an internal valve based on the system pressure and the spring tension set on the valve.
通过固定孔的水量越多，压力就越大，反之水量少压力也小。
HART field-bus protocol is used in output of system pressure or differential pressure transmitter, digital signals is transmitted with MODBUS via RS485.
系统压力或差压变送器信号输出采用HART现场总线协议，数字信号传输通过RS485进行MODBUS通讯。
Butterfly spring valves are important safety attachments of boiler pressure vessels, they are used to prevent system pressure from exceeding allowable limit value.
蝶形弹簧安全阀是锅炉压力容器的重要安全附件，用于防止系统压力超过允许的极限值。
Buffer Another buffer can be slowed down and the air compressor system pressure fluctuations, for air drier and other equipment with more stable pressure and air flow.
另外缓冲器可以减缓压缩机与空气系统的压力波动，为空气干燥器和其他设备提供更为稳定的压力和空气流量。
This paper has researched on the effects of the system pressure, undercooling, inhibitors concentration, gas condensate and the methanol on hydrate formation kinetics.
研究了系统压力、过冷度、抑制剂浓度、凝析油、甲醇对水合物生成动力学的影响。
The impactor can regulate system pressure according to different objectives, so the purpose to reduce power capacity of original machine, such as excavator, is realized.
该冲击器时针对不同作业对象来调节系统压力，从而实现降低主机（如挖掘机等）装机容量的目的。
For the hydraulic system's pressure always be dynamic, there often appears an impact pressure; the maximum impact pressure is much higher than the maximum system pressure.
由于液压系统的压力值通常是动态的，有时会出现冲击压力，冲击压力峰值会大大高于系统的最高压力值。
Finally, falling film absorption changes with the solution parameters at inlet and system pressure and the change trend is very similar to what happened in the static tube.
最后，改变溶液入口参数及吸收压力，相应的吸收情况有所改变，其趋势与静止状态下的降膜吸收非常一致。
The main purpose of the buffer is to prevent the compressed air system pressure fluctuations, compressed air happened to prevent further cooling, prevent compressor working too much.
缓冲器的主要目的在于防止压缩空气系统的压力发生波动、防止压缩空气进一步降温，避免压缩机工作过度。
With the help of industrial control computer in the remote adjustment of system pressure and direction, the system can realize simulation of actual load condition needed in the test.
借助于工控机对系统压力和方向进行远距离程控调节，从而实现试验检测所需的实际载荷工况模拟。
应用推荐