Inlet subcooling and system pressure are varied as parameters.
进口欠热度及系统压力作为变化参数。
For uniform temperature surface, the CHF increases with the subcooling.
对等温面，CHF随过冷度的增加而增加。
Outlet subcooling degree of reverse flow section should be in conformity with the requirement of HEI Standard.
空冷器设计应注意其逆流段出口的过冷却符合HEI标准的要求；
The results showed that incipient boiling point decreased with increasing fluid subcooling and was independent of other factors.
结果表明：起沸点随液体过冷度增加而降低，与其它因素无关。
The minimum heat transfer area of the tube for subcooling and the optimal length range of the by-pass capillary tube were determined.
通过分析确定过冷管最小换热面积和旁通毛细管最佳长度范围。
The article focuses on two ways to determine friction factors of the capliliary tube without backheating which inlet refrigerant is subcooling liquid.
本文针对无回热且进口处制冷剂为过冷液体的节流管介绍确定其沿程阻力系数的两种方法。
Also, it is found and analysed that there exists inlet pressure fluctuation of coiled capillary tubes when the degree of subcooling is changed from one to another.
从一个过冷度工况向另一个过冷度工况转变的过程中存在螺旋管毛细管入口处压力的波动，并对此现象作了简要分析。
The rolling motion is chosen as the ocean condition in this experimental study, we study on Natural Circulation subcooling vapor bubble departure in vertical channel.
本文取摇摆为海洋影响条件，研究摇摆对竖直管自然循环过冷沸腾气泡脱离点的影响。
Technology of refrigerant subcooling applying to conventional air-conditioning systems, can increase cooling system efficiency, it let us find out energy-saving potential.
介绍了制冷剂过冷技术应用于普通空气调节系统，可提高制冷效率，挖掘节能潜力。
Results show that, under high subcooling conditions, steam bubbles appear and slide along on the narrow slit-channels heating surface, and play an active role in enhancing th.
采用高速摄像仪，对矩形窄缝流道内过冷沸腾时的汽泡行为进行了可视化实验研究。
The experimental results showed that the high heat flux portions of heat transfer curves shifted to the left with elevating fluid subcooling and was independent of other factors.
实验结果表明：核沸腾传热曲线随过冷度增加而向左移动，与其它因素无关。
The liquid superheat limit and vapor subcooling limit in homogeneous nucleation are determined in the present paper by using density fluctuation theory of statistical thermodynamics.
应用统计热力学巨正则系综的密度涨落理论，提出了确定均质沸腾中液体极限过热度和均质凝结中蒸汽极限过冷度的方法。
The influence of pressure on salt-removing effect indicated that the reaction time and the subcooling temperature submitted a relationship of power function under the same conditions.
压力对排盐效应的影响体现在反应时间上。 在相同反应条件下，反应时间与过冷温度呈幂函数关系。
By applying black box theory inlet pressure, inlet subcooling, outlet pressure and valve opening are selected as influence factors to flow coefficient of electronic expansion valve (EEV).
根据黑箱理论提出将阀前压力、阀前过冷度、阀后压力和膨胀阀流通面积作为膨胀阀流量系数的影响参数。
The effects of gap size, heat flux and inlet subcooling on the boiling incipience, flow pattern, heat transfer coefficient, flow instability and critical heat flux were analyzed and discussed.
讨论和分析了流道间隙、加热功率和入口过冷度对沸腾起始点、沸腾流态、换热系数、流动不稳定性和临界热负荷的影响。
The capillary tube model in subcooling single-phase region and two-phase region was established, and the difference of mass flow rate is within 10% between the predicted and the measured values.
建立单相区和两相区毛细管模型，模型计算的毛细管质量流量与实验测量的质量流量差别小于10%。
In this paper, the influences of these factors on the optimum vacuum are analyzed firstly, and the calculation method of condensate subcooling degree and the dissolved oxygen in condensate are given.
文中首先对上述各因素对凝汽器最佳真空的影响进行了分析，给出了凝汽器真空变化后凝结水过冷度及凝结水含氧量的计算方法。
In this paper, the influences of these factors on the optimum vacuum are analyzed firstly, and the calculation method of condensate subcooling degree and the dissolved oxygen in condensate are given.
文中首先对上述各因素对凝汽器最佳真空的影响进行了分析，给出了凝汽器真空变化后凝结水过冷度及凝结水含氧量的计算方法。
应用推荐