On this basis, I finished the various sub-circuit design and analysis the important parameters related to the calculation.
接着在此基础上完成了各个子电路的电路的设计及相关重要参数的分析、计算。
The topology of PET based on dual PWM converters is proposed. The control strategies of each sub-circuit of PET are pointed out.
提出了一种基于双PWM变换的电力电子变压器拓扑结构，对各级电路提出了相应的控制策略。
After analyzing the producing mechanism of leakage power for each sub-circuit in SRAM, a leakage power model for each sub-circuit was established to estimate the leakage power for full SRAM.
在分析了SRAM逻辑结构中各子电路的泄漏功耗的产生机制的基础上，建立了SRAM的泄漏功耗模型，然后对SRAM的泄漏功耗进行估算。
The equivalent sub-circuit model in discrete domain is formed for numerical simulation and the equivalent model of the coupled multiphase transmission lines is then proposed in discrete domain.
提出了用于数值计算的子电路离散时域等效电路模型，并以此建立了多相耦合传输线的离散时域等效电路模型。
The so-called hate circuit includes structures in the cortex and the sub-cortex and represented a pattern distinct from emotions such as fear, threat and danger, Zeki said in a telephone interview.
泽克在电话采访中称，大脑“憎恨回路”包括大脑皮层和下皮层中的结构，它所反映的大脑活动形式与恐惧、威胁和危险等情绪截然不同。
The key to power distribution system is to ignore transient process in this sub-system and to draw the network equivalent circuit diagram, therefore its node voltage equation is algebraic equation.
配电子系统的建模关键是忽略其内部的暂态过程并作出了网络的等值电路图，因而依此建立的节点电压方程为代数方程。
As to the problem of sub synchronous resonance (SSR) in thyristor controlled series compensation (TCSC) circuit, a method to real time detect and suppress sub harmonic has been put forward.
针对晶闸管控制的串联补偿电路(TCSC)的次同步谐振(SSR)问题，提出了一种可实时检测次同步谐振，并对其加以抑制的方法。
A sub circuit model for VDMOS is built according to its physical structure. Parameters and formulas describing the device are also derived from this model.
从VDMOS的物理结构出发建立子电路模型，进而导出描述其交直流特性的参数及模型公式。
The drive module and STOP signal conversion module are sub-frequency, select and comparison circuit based on the transducer's launch and reception principles.
驱动电路与STOP信号转换电路是根据换能器的发射接收原理设计的分频、选择、比较电路。
Interconnect geometric variation extraction is a key factor for the integrated circuit design for manufacturability research and development, under ultra deep sub-micro process nodes.
硅片上互连线几何变异提取对于超深亚微米工艺节点下集成电路可制造性设计研究开发极其关键。
In particular the introduction of sub-wavelength structures, the microstrip circuit has presented unprecedented features, such as slow-wave characteristics, left-handed properties and so on.
特别是亚波长结构的引入，使微带电路呈现出了前所未有的特性，如慢波特性、左手特性等。
We also choose the type of stable voltage direct current and frequency conversion motor, and design the hardware circuit of the sub-systems.
根据控制要求对直流稳压电源、变频器等其它硬件进行了选型，并对系统各部分硬件电路进行设计。
The digital video signals bit plane separation strategy is applied in the circuit design, and the sub-field writing-in and sub-area readout to the cache memory method is used.
该电路的设计，应用了数字视频数据信号位面分离的策略，采用了分场写入、分区读出缓存存储器的方法。
It also puts forward the applicable range of measuring impedance and sub circuit impedance action features.
规定了测量阻抗动作特性和支接阻抗动作特性的适用范围。
A synthesis system of equation-based deep sub-micron cell-level CMOS analog circuit is presented in the paper.
介绍了一个基于公式的深亚微米CMOS模拟单元电路综合系统。
Have you finished repairing the sub - circuit board?
你把电路板修好了吗？
Through the drive circuit design of the new hydraulic transformer, it is concluded that the transmission ratio has multi-level changes due to the combination of each sub motor working mode.
通过设计单泵多马达液压变速器的传动回路，得出多马达中各个子马达之间工作方式的组合可以使变速器传动比有多级变化。
A static verification methodology for circuit design-flow of ASIC's based on very deep sub-micron CMOS technology is described in the paper.
介绍了基于深亚微米cmos工艺asic电路设计流程中的静态验证方法。
The whole circuit consists of Sample and Hold Circuit, the Multiplicative A/D Converter, the Sub-ADC, the Digital Calibration Circuit, the Clock Generator and the Time Synchronizer.
流水线ADC的模块有采样保持电路、乘法数模转换器、子ADC、数字校正电路、时钟产生电路和时间对齐电路。
Through microwave network decomposition principle, we divided multilayered microwave circuit into simple circuit of sub-structure to analyze.
本文通过微波网络分解，将复杂的多层微波电路分解为结构相对简单的子结构电路进行分析。
The principle of sub-threshold MOS peak detector is stated and the circuit is implemented.
先介绍了亚阈值MOS管峰值检测器的工作原理，并进行了电路实现。
The utility model relates to a single battery or a sub-battery protection circuit and the battery balanced discharge control device.
本实用新型涉及一种单体电池或子电池组保护电路及电池组均衡放电控制装置。
The present invention further relates to a deep sub-micron MOS integrated circuit die comprising a thick-oxide transistor-based preamplifier.
本发明还涉及一种深亚微米mos集成电路管芯，包括基于厚氧化物晶体管的前置放大器。
To convert a gate circuit to a Boolean expression, label each gate output with a Boolean sub-expression corresponding to the gates' input signals, until a final expression is reached at the last gate.
要转换选通电路成一个布尔表示式，标记每个门的产品以对应于门的输入的一个布尔次级表示信号，直到最后一个表示信号到达最后门。
To convert a gate circuit to a Boolean expression, label each gate output with a Boolean sub-expression corresponding to the gates' input signals, until a final expression is reached at the last gate.
要转换选通电路成一个布尔表示式，标记每个门的产品以对应于门的输入的一个布尔次级表示信号，直到最后一个表示信号到达最后门。
应用推荐