The results indicate that under standard load, the installation has good stress distribution, and good bearing capacity because of rational structural design.
结果表明在标准载荷下，该装置应力分布情况良好。同时该装置结构设计合理，承载力大。
This paper states the temperature stress and load value, puts forward the conformation measures of crack control in structural design and construction.
本文论述了温度应力、温度荷载的取值，并根据实际情况提出了结构设计和施工时裂缝控制的构造措施。
The paper presents the scheme of structural design of this radar and makes selection of stepping motor via the counting of wind load and inertia load of antenna.
给出了雷达的结构总体设计方案，计算了天线的惯性载荷以及风载荷，并由此得出方位转动电机所需的最小输出扭矩。
This paper present the analytical method for structural load calculation for SWATH ship, and the short cut method with empirical formula for preliminary design.
本文提供了小水线面双体船(SWATH)结构载荷的解析方法以及用于初步设计的简捷算法经验公式。
It analyzes the design elements of the pool from several aspects including the pool structure, load, computing model, load combination and internal force calculation and structural requirements.
从水池的结构形式、水池的荷载、水池的计算模型、荷载组合及内力计算、水池构造要求几方面分析了水池设计的要点。
Then, the matching design can be accomplished by means of impact load spectrograms so as to perform the optimal structural design and to make further improvement on dynamic strength program.
再利用冲击载荷谱图作为实现匹配设计的技术途径，以期实现最佳的结构设计，从而进一步完善了动力强度设计程序。
Some discussions on Code for dynamic Machine foundation Design (GB 50040-96) are had, including mass-spring-damper model, dynamic foundation parameters, load combination and structural requirements.
讨论了《动力机器基础设计规范》(GB 50040- 96)中的若干问题，包括质-弹-阻模型、地基动力参数、荷载组合和基础的构造要求等几个方面。
In the structure concept design, you should not only consider external factors-impact of load, it should be more emphasis on internal factors-stiffness in the role of the structural design.
在结构的概念设计中，不仅要考虑外部因素-荷载的影响，更应当注重内部因素-刚度在整个结构设计中的作用。
So during structure analyze and design, the randomness of structural system and load is considered is according to engineer practice.
所以，在结构的分析和设计中，考虑结构系统和载荷的随机性是符合工程实际的。
It introduces the road and storage yard arrangement of the second phase of Yangpu Port and the design load, foundation condition and structural design of the pavement.
介绍洋浦港二期工程道路、堆场的平面布置和铺面设计荷载、地基条件及结构设计。
Especially, the difficulties encountered in the design such as the corresponding structural wind load, steel-truss roof system selection, the joint structure and so on are explained in detail.
介绍了潍坊市中心-潍坊学院体育馆的结构计算和构造措施，并对结构风荷载的取值、屋架钢结构体系的选择、节点构造等设计中遇到的难点进行特别说明。
It is discussed that the main issues of the calculation and design of the sculpture structure, including structural arrangement, load calculation, members design and nodes design that merit attention.
分析了结构计算和设计中包括结构布置、荷载计算、杆件设计、节点设计方面需注意的问题。
In the design, in construction process of the structural calculation of the upper part in the continuous bridge, the permanent load were simulated and calculated.
在设计中，桥梁上部结构的计算着重分析了桥梁在施工过程中，恒载内力的计算。
K is for the safety coefficient from the overall structure can bear the load to, and it could be more accurately to reflect the structural strength design of a combination of factors.
因安全系数K是从整体结构所能承受的荷载来考虑的，故能较正确地反映结构强度设计时的综合因素。
Sometimes more than others can temperature stress caused by the stress load, temperature stress to the changes in the structural design and construction for reasonable extremely important.
有时温度应力可超过其它外荷载所引起的应力，因此掌握温度应力的变化规律对于进行合理的结构设计和施工极为重要。
The maximum load that the models can bear in the test meets the design load according to the structural similar theory.
试验结果与根据结构相似理论得出的结果相比较表明，模型受力性能较稳定，能承受最大荷载与理论计算的结果较吻合。
Some critical issues of structural analysis are present. The analysis results in reasonable design live load according to the code and architectural layout.
针对结构分析中若干关键问题的分析结果：结合规范与建筑功能布局，合理确定了结构活荷载取值；
Aerodynamic performance calculation provides evaluation and feedback for the aerodynamic design and also the aerodynamic load data for the structural design of blade.
气动性能计算为气动设计结果提供评价和反馈，并为叶片的结构设计提供气动载荷的原始数据。
Shakedown analysis is an important part of the structural design or the research on load-bearing capacity.
安定分析是结构设计或承载能力研究的一个重要方面。
The structural system, load paths, design conception, problems and countermeasures of low-rise cold-formed steel framing dwellings are introduced in this paper.
本文介绍了低层冷弯薄壁型钢房屋住宅的结构体系、传力路径、设计概念以及存在的问题和对策。
It mainly analyzes the design and internal structural force calculation for the sheet-pile retaining wall with load-relieving structures.
主要分析带有减载结构的板桩墙的设计及结构内力计算。
In the particular case, any building's structural design first includes the confirmation to consider the load which and other design conditions the building resists in the design.
特别情况下，任何建筑物的结构设计首先包括确认应考虑在设计内的建筑物所抵抗的荷载和其他设计条件。
Stainless steel structure, load-bearing spindle set and structural design, to ensure that the machines have a long life.
不锈钢结构，承重载主轴及结构设计，确保机器具有长久的寿命。
The design of engineering structures using frame structure, structural framework for the calculation according to the vertical load-bearing analysis.
本工程结构设计采用框架结构，结构计算按纵向框架承重分析。
The design of engineering structures using frame structure, structural framework for the calculation according to the vertical load-bearing analysis.
本工程结构设计采用框架结构，结构计算按纵向框架承重分析。
应用推荐